Exploring vitreous cryo-section-induced compression at the macromolecular level using electron cryo-tomography; 80S yeast ribosomes appear unaffected.

Vitreous cryo-section-induced compression influences the interpretation and the reliability of electron microscopy images and tomographic reconstructions. Previous studies of this deformation have been focused at the cellular level where considerable compression occurs, yet the degree of possible intracellular macromolecular deformation has remained unclear. Here, electron cryo-tomographic reconstructions of vitreous cryo-sections show that 80S ribosomes, both intracellular and in an isolated state, appear able to resist section-induced compression.

TEM study of locally coated nanopore fabricated by ion-beam-induced deposition in a thin membrane.

We studied the formation of locally coated sub-10-nm nanopores fabricated by ion-beam milling and ion-beam-induced deposition (IBID) in a thin silicon nitride membrane. Two typical precursor gases representing conductive ((CH(3))(3)Pt(CpCH(3)), CPC for short) and insulating (tetra ethyl oxysilane, TEOS for short) material deposition are used. Three-dimensional electron tomography, EDX and EELS analysis are used to measure the changes in chemical composition and shape of the pores after their formation and at various stages of pore shrinkage.

Control of shape and material composition of solid-state nanopores.

Solid-state nanopores fabricated by a high-intensity electron beam in ceramic membranes can be fine-tuned on three-dimensional geometry and composition by choice of materials and beam sculpting conditions. For similar beam conditions, 8 nm diameter nanopores fabricated in membranes containing SiO(2) show large depletion areas (70 nm in radius) with small sidewall angles (55 degrees ), whereas those made in SiN membranes show small depletion areas (40 nm) with larger sidewall angles (75 degrees ). Three-dimensional electron tomograms of nanopores fabricated in a SiO(2)/SiN/SiO(2) membrane show a biconical shape with symmetric top and bottom and indicate a mixing of SiN and SiO(2) layers up to 30 nm from the edge of nanopore, with Si-rich particles throughout the membrane.

Three-dimensional architecture of hair-bundle linkages revealed by electron-microscopic tomography.

The senses of hearing and balance rest upon mechanoelectrical transduction by the hair bundles of hair cells in the inner ear. Located at the apical cellular surface, each hair bundle comprises several tens of stereocilia and a single kinocilium that are interconnected by extracellular proteinaceous links. Using electron-microscopic tomography of bullfrog saccular sensory epithelia, we examined the three-dimensional structures of basal links, kinociliary links, and tip links.

Influence of charged surfaces on the morphology of DNA condensed with multivalent ions.

DNA in solution can be condensed into dense aggregates by multivalent counterions. Here we investigate the effect of a nearby surface on the morphology of DNA condensates. We show that, contrary to what has often been assumed, interactions between DNA condensates and the surface can strongly influence the observed morphology.

Automatic TEM image alignment by trifocal geometry.

Here we propose a novel method for automatic, markerless, feature-based alignment of TEM images suitable for electron tomography. The proposed method, termed trifocal alignment, is more accurate than the previous markerless methods. The key components developed are: (1) a reliable multi-resolution algorithm for matching feature points between images; (2) a robust, maximum-likelihood-based estimator for determining the geometry of three views--the trifocal constraint--required for validating the correctness of the matches; and (3) a robust, large-scale optimization framework to compute the alignment parameters from hundreds of thousands of feature point measurements from a few hundred images.

Creation of hollow zeolite architectures by controlled desilication of Al-zoned ZSM-5 crystals.

Hollow zeolite architectures on different length scales have been obtained upon controlled desilication of Al-zoned ZSM-5 zeolites in alkaline medium. The hollow ZSM-5 crystals possess a functional Al-rich exterior and a tunable internal porosity and accessibility.

Endosomal compartmentalization in three dimensions: implications for membrane fusion.

Endosomes are major sorting stations in the endocytic route that send proteins and lipids to multiple destinations in the cell, including the cell surface, Golgi complex, and lysosomes. They have an intricate architecture of internal membrane structures enclosed by an outer membrane. Recycling proteins remain on the outer membrane, whereas proteins that are destined for degradation in the lysosome are sorted to the interior.

Correction of autofocusing errors due to specimen tilt for automated electron tomography.

Transmission electron microscopy images acquired under tilted-beam conditions experience an image shift as a function of defocus settings - a fact that is exploited as a method for defocus determination in most of the automated tomography data collection systems. Although the method was shown to be highly accurate for a large variety of specimens, we point out that in its original design it can strictly only be applied to images of untilted samples. The application to tilted samples and thus in automated electron tomography is impaired mainly due to a defocus change across the images, resulting in reduced accuracy.

Three-dimensional reconstructions of extracellular matrix polymers using automated electron tomography.

The extracellular matrix is an intricate network of macromolecules which provides support for cells and a framework for tissues. The detailed structure and organisation of most matrix polymers is poorly understood. These polymers have a complex ultrastructure, and it has proved a major challenge both to define their structural organisation and to relate this to their biological function.

Three-dimensional localization of ultrasmall immuno-gold labels by HAADF-STEM tomography.

The localization of scarce antigens in thin sections of biological material can be accomplished by pre-embedment labeling with ultrasmall immuno-gold labels. Moreover, with this method, labeling is not restricted to the section surface but occurs throughout the section volume. Thus, when combined with electron tomography, antigens can be localized in three dimensions in relation to the 3D (three-dimensional) ultrastructure of the cell.

Automated high-throughput electron tomography by pre-calibration of image shifts.

Electron tomography is a versatile method for obtaining three-dimensional (3D) images with transmission electron microscopy. The technique is suitable to investigate cell organelles and tissue sections (100-500 nm thick) with 4-20 nm resolution. 3D reconstructions are obtained by processing a series of images acquired with the samples tilted over different angles.

Corneal collagen fibril structure in three dimensions: Structural insights into fibril assembly, mechanical properties, and tissue organization.

The ability of the cornea to transmit light while being mechanically resilient is directly attributable to the formation of an extracellular matrix containing orthogonal sheets of collagen fibrils. The detailed structure of the fibrils and how this structure underpins the mechanical properties and organization of the cornea is understood poorly. In this study, we used automated electron tomography to study the three-dimensional organization of molecules in corneal collagen fibrils.

The supramolecular organization of fibrillin-rich microfibrils.

We propose a new model for the alignment of fibrillin molecules within fibrillin microfibrils. Automated electron tomography was used to generate three-dimensional microfibril reconstructions to 18.6-A resolution, which revealed many new organizational details of untensioned microfibrils, including heart-shaped beads from which two arms emerge, and interbead diameter variation.

Automated electron tomography of the septal pore cap in Rhizoctonia solani.

Dolipore septa and septal pore caps (SPCs) in filamentous basidiomycetes may play an important role in maintaining the integrity of hyphal cells. We have investigated the ultrastructure of the dolipore septum and the SPC in Rhizoctonia solani hyphal cells after high-pressure freezing, freeze substitution, and Spurr embedding. We visualized the SPC with associated cell ultrastructures in three dimensions by automated electron tomography of thick-sectioned cells, followed by 3D tomographic reconstructions.

SNDV, a novel virus of the extremely thermophilic and acidophilic archaeon Sulfolobus.

We describe a novel virus, SNDV (Sulfolobus neozealandicus droplet-shaped virus), of the crenarchaeotal archaeon Sulfolobus, which was found in a carrier state in a Sulfolobus strain isolated from a field sample from New Zealand. SNDV particles are droplet-shaped and densely covered by thin tail fibers at their pointed ends. The virion consists of a core and a coat.

A novel lipothrixvirus, SIFV, of the extremely thermophilic crenarchaeon Sulfolobus.

We describe a novel lipothrixvirus, SIFV, of the crenarchaeotal archaeon Sulfolobus islandicus. SIFV (S. islandicus filamentous virus) has a linear virion with a linear double-stranded DNA genome.

The C-terminal domain of the Pseudomonas secretin XcpQ forms oligomeric rings with pore activity.

The Pseudomonas secretin XcpQ forms an oligomeric complex, which is involved in the translocation of proteins across the outer membrane via the type II secretion pathway. Pseudomonas aeruginosa produces only small amounts of this complex, 50 to 100 copies per bacterium, and overexpression is lethal to these cells. However, overexpression of Pseudomonas alcaligenes XcpQ could be achieved in the P.

A novel virus family, the Rudiviridae: Structure, virus-host interactions and genome variability of the sulfolobus viruses SIRV1 and SIRV2.

The unenveloped, stiff-rod-shaped, linear double-stranded DNA viruses SIRV1 and SIRV2 from Icelandic Sulfolobus isolates form a novel virus family, the Rudiviridae. The sizes of the genomes are 32. 3 kbp for SIRV1 and 35.

Structural characteristics of halobacterial gas vesicles.

Gas vesicle formation in halophilic archaea is encoded by a DNA region (the vac region) containing 14 different genes: gvpACNO and gvpDEFGHIJKLM. In Halobacterium salinarum PHH1 (which expresses the p-vac region from plasmid pHH1), gas vesicles are spindle shaped, whereas predominantly cylindrical gas vesicles are synthesized by the chromosomal c-vac region of H. salinarum PHH4 and the single chromosomal mc-vac region of Haloferax mediterranei.