Exploring the relationship of colour categorization with pork colour standards under different subjective and objective conditions.

The impact of using incorrect lighting while subjectively scoring pork colour with subjective standards (Japanese, Canadian, and Kodak grey) was explored. Lightness was more important than a good colour match between standards and meat. Subjective and image-based automated scoring with Canadian standards were correlated at 0.

Effect of different electrical stimulation systems on beef quality and palatability: Constant current compared to constant voltage.

This study examined the effects of constant current electrical stimulation (CCES) compared to constant voltage electrical stimulation (CVES), when applied within the same beef carcass (n = 79), on longissimus thoracis et lumborum (LTL) quality and palatability. There was a stimulation method × time interaction for pH, with CCES reducing the 3 h post-mortem pH, but increasing the 72 h post-mortem pH compared to CVES (P < 0.001).

Effect of a novel steak fabrication method by trimming subcutaneous and intermuscular fats on palatability and calorie content of beef ribeye steaks.

This study investigated the effects of a novel steak fabrication method, involving removal of both subcutaneous and intermuscular fats between the longissimus thoracis (LT) and spinalis dorsi (SD) muscles before cooking, on beef ribeye steak palatability and calorie content. Canada AA (n = 10) and AAA (n = 10) ribeyes were fabricated into steaks either with (fat-on) or without (fat-off) subcutaneous and intermuscular fats. Fat-on steaks had shorter cooking times and lower cooking losses than fat-off steaks (P < 0.

A new manual method for pork belly firmness measurement.

A new objective and standardized method for early determination of firmness of the intact pork belly in a research environment is described, and compared to the existing bar-bend method. The belly characteristics that contribute to the outcome of each method, and the relationship between the two methods are identified. •Original method requires a ribbed pork belly, and several minutes relaxation time.

Impact of a constant current electrical stimulation (CCES) system and hormonal growth-promoting (HGP) implants on meat quality and palatability of finished steers.

This study evaluated the effects of a constant current electrical stimulation (CCES) system and hormonal growth-promoting (HGP) implants on the quality and palatability of the longissimus thoracis et lumborum (LTL) from yearling-finished steers. The experiment used a total of 46 Angus cross steers, which were either non-implanted (n = 20) or implanted with trenbolone acetate and estradiol benzoate (n = 26). The CCES was applied to one side of each carcass during the slaughter process, whereas the other side remained unstimulated.

Performance of a Handheld Near-Infrared Spectroscopy Device to Predict Pork Primal Belly Fat Iodine Value and Loin Lean Intramuscular Fat Content.

The increase in market demand and economic value of Canadian pork primal cuts has led to a need to assess advanced technologies capable of measuring quality traits. Fat and lean composition were measured using a Tellspec near-infrared (NIR) spectroscopy device to predict the pork belly fat iodine value (IV) and loin lean intramuscular fat (IMF) content in 158 pork belly primals and 419 loin chops. The calibration model revealed a 90.

Prediction of primal and retail cut weights, tissue composition and yields of youthful cattle carcasses using computer vision systems; whole carcass camera and/or ribeye camera.

The application of two computer vision systems (CVS) was evaluated to predict primal and retail cut composition in youthful beef carcasses. Left carcass sides from a total of 634 animals were broken down into primal cuts, scanned using dual-energy x-ray absorptiometry for the prediction of tissue composition and fabricated into retail cuts. Cold carcass camera (CCC) images led to higher R values than hot carcass camera (HCC) images.

An image analysis approach to identification and measurement of marbling in the intact pork loin.

An image analysis method for identifying marbling on exposed boneless pork loin surfaces was developed, solving the problem of influences from uneven lean colour. Comparing results from RAW and JPEG images of the mid-loin pork chop showed that, except at very high marbling levels, estimation of %IMF (intramuscular fat) was similar with both image types (R = 0.72 and 0.

An approach for objective and automated identification of pork belly firmness.

A series of studies was performed to develop and test a method adaptable for early automated sorting of pork bellies based on firmness. Flattened and non-flattened, bone-in, skin-on primal bellies were fed skin-down, caudal end foremost on to a horizontal (0°) or raised (30°) conveyor with an adjustable nosebar (ø = 14 mm). The drop angle, after 24 cm of belly had passed the nosebar, was strongly correlated with subjective floppiness (r = 0.

Effects of a novel three-step sous-vide cooking and subsequent chilled storage on the microbiota of beef steaks.

This study aimed to evaluate a novel three-step sous-vide (SV) method on bacterial growth and diversity, and its relationship to product storage life. Vacuum-packed naturally contaminated steaks were sequentially cooked at 39 °C (1 h), 49 °C (1 h), and 59 °C (4 h), then stored at -1.5 and 2 °C for 28 d, with a single-step SV at 59 °C for 4 h for comparison.

Efficacy of multi-stage sous-vide cooking on tenderness of low value beef muscles.

The efficacy of thermal activation of residual proteolytic enzymes on shear force and deformation of 72 beef supraspinatus (SS) and rectus femoris (RF) muscles was tested using multi-stage sous-vide cooking (M-SV; 1 h at 39 °C, 1 h at 49 °C, 4 h at 59 °C), single-stage sous-vide cooking (S-SV; 4 h at 59 °C), and waterbath cooking (22 min at 70 °C, to 59 °C). Two storage conditions (1 week at 2 °C; 2 weeks at -1.5 °C) followed, then meat was reheated to and tested at 55 °C.

Compositional and dimensional factors influencing pork belly firmness.

We explored various dimensional and compositional factors that can influence the perception of pork belly firmness. Bellies from 198 pigs of three different genotypes, two sexes, two slaughter weights and three different diets were recovered and belly firmness was assessed using the belly-flop angle and a 5-point scale subjective measurement. Dimensional and compositional factors were recorded on intact and sheet-ribbed bellies.

Type of packaging affects the colour stability of vitamin E enriched beef.

Colour stability is a very important parameter for meat retail display, as appearance of the product is the deciding factor for consumers at time of purchase. This study investigated the possibility of extending appearance shelf-life through the combined use of packaging method (overwrapping - OVER, modified atmosphere - MAP, vacuum skin packaging - VSP and a combination of modified atmosphere and vacuum skin packaging - MAPVSP) and antioxidants (vitamin E enriched beef). Retail attributes (appearance, lean colour, % surface discolouration), as well as colour space analysis of images for red, green and blue parameters were measured over 18days.

Distributions of brine and bacteria in beef primal cuts injected with brine without, or before or after mechanical tenderizing.

Eye of round primal cuts of beef were injected with brines containing a dye and Listeria innocua. The amounts of brine in portions of meat were determined from the concentrations of dye in the tissues, and the numbers of L. innocua in the tissues were determined from the numbers of colonies recovered on hydrophobic grid membrane filters incubated on a selective agar.

A novel approach to grading pork carcasses: computer vision and ultrasound.

A Computer Vision System prototype for grading pork carcasses was developed at the Lacombe Research System. The system consists of two components: ultrasound imaging to scan a cross-section of the loin muscle and video imaging to capture two-dimensional (2D) and three-dimensional (3D) images of the carcass. For each of the 241 carcasses (114 barrows and 127 gilts), salable meat yield was determined from a full cutout.