Metal-Assisted and Microwave-Accelerated Decrystallization of Pseudo-Tophus in Synthetic Human Joint Models.

In this paper, we tested a hypothesis that the metal-assisted and microwave-accelerated decrystallization (MAMAD) technique, based on the combined use of low-power medical microwave heating (MWH) and gold nanoparticles (Au NPs), can be used to decrystallize laboratory-prepared monosodium urate monohydrate crystal aggregate (pseudo-tophus) placed in three-dimensional (3D) synthetic human joint models. To simulate a potential treatment of chronic tophaceous gout using the MAMAD technique, we used three different 3D synthetic human joint models and assessed the percent mass reduction (PMR, i.e.

Microwave Heating of Crystals with Gold Nanoparticles and Synovial Fluid under Synthetic Skin Patches.

Gout is a disease with elusive treatment options. Reduction of the size of l-alanine crystals as a model crystal for gouty tophi with the use of a monomode solid-state microwave was examined as a possible therapeutic aid. The effect of microwave heating on l-alanine crystals in the presence of gold nanoparticles (Au NPs) in solution and synovial fluid (SF) in a plastic pouch through a synthetic skin patch was investigated.

Metal oxide surfaces for enhanced colorimetric response in bioassays.

Physical stability of metal nanoparticle films on planar surfaces can be increased by employing surface modification techniques and/or type of metal nanoparticles. Subsequently, the enzymatic response of colorimetric bioassays can be increased for improved dynamic range for the detection of biomolecules. Using a model bioassay b-BSA, three planar platforms (1) poly (methyl methacrylate) (PMMA) with silver thin films (STFs), (2) silver nanowires (Ag NWs) on paper and (3) indium tin oxide (ITO) on polyethylene terephthalate (PET) were evaluated to investigate the extent of increase in the colorimetric signal.

Effect of Microwave Heating on the Crystallization of Glutathione Tripeptide on Silver Nanoparticle Films.

Effect of microwave heating on the crystallization of glutathione (GSH) tripeptide using the metal-assisted and microwave-accelerated evaporative crystallization (MA-MAEC) technique is reported. GSH crystals were grown from supersaturated solutions of GSH (300-500 mg/mL) on the iCrystal plates with silver nanoparticle films (SNFs) and without SNFs in three different microwave systems operating at 2.45 GHz: conventional (multimode, fixed power at 900W), industrial (monomode, variable power up to 1200 W), and the iCrystal system (monomode, variable power up to 100 W).

Metal-Assisted and Microwave-Accelerated Decrystallization: An Alternative Approach to Potential Treatment of Crystal Deposition Diseases.

Gout is a painful and prevalent crystal deposition disease caused by the overproduction of Uric Acid (UA) in the body and the atypical deposition in human synovial joints as Monosodium Urate Monohydrate (MSUM). Conventional treatments, such as NSAIDs, cyclooxygenase-2 inhibitors, and systemic glucocorticoids often present harmful side-effects and are short-lived. Long-term therapies including xanthine oxidase inhibitors and the use of uricosuric agents have been developed and aim to lower the UA serum levels in the body.

Ultra-Rapid Crystallization of L-alanine Using Monomode Microwaves, Indium Tin Oxide and Metal-Assisted and Microwave-Accelerated Evaporative Crystallization.

The use of indium tin oxide (ITO) and focused monomode microwave heating for the ultra-rapid crystallization of L-alanine (a model amino acid) is reported. Commercially available ITO dots (< 5 mm) attached to blank poly(methyl)methacrylate (PMMA, 5 cm in diameter with 21-well silicon isolators: referred to as the iCrystal plates) were found to withstand prolonged microwave heating during crystallization experiments. Crystallization of L-alanine was performed at room temperature (a control experiment), with the use of two microwave sources: a 2.

Microwave Heating of Synthetic Skin Samples for Potential Treatment of Gout Using the Metal-Assisted and Microwave-Accelerated Decrystallization Technique.

Physical stability of synthetic skin samples during their exposure to microwave heating was investigated to demonstrate the use of the metal-assisted and microwave-accelerated decrystallization (MAMAD) technique for potential biomedical applications. In this regard, optical microscopy and temperature measurements were employed for the qualitative and quantitative assessment of damage to synthetic skin samples during 20 s intermittent microwave heating using a monomode microwave source (at 8 GHz, 2-20 W) up to 120 s. The extent of damage to synthetic skin samples, assessed by the change in the surface area of skin samples, was negligible for microwave power of ≤7 W and more extensive damage (>50%) to skin samples occurred when exposed to >7 W at initial temperature range of 20-39 °C.

Decrystallization of Crystals Using Gold "Nano-Bullets" and the Metal-Assisted and Microwave-Accelerated Decrystallization Technique.

Gout is caused by the overproduction of uric acid and the inefficient metabolism of dietary purines in humans. Current treatments of gout, which include anti-inflammatory drugs, cyclooxygenase-2 inhibitors, and systemic glucocorticoids, have harmful side-effects. Our research laboratory has recently introduced an innovative approach for the decrystallization of biological and chemical crystals using the Metal-Assisted and Microwave-Accelerated Evaporative Decrystallization (MAMAD) technique.