The surface chemistry of the atomic layer deposition of metal thin films.

In this perspective we discuss the progress made in the mechanistic studies of the surface chemistry associated with the atomic layer deposition (ALD) of metal films and the usefulness of that knowledge for the optimization of existing film growth processes and for the design of new ones. Our focus is on the deposition of late transition metals. We start by introducing some of the main surface-sensitive techniques and approaches used in this research.

Remote Activation of H-H Bonds by Platinum in Dilute Alloy Catalysts.

With heterogeneous catalysts, chemical promotion takes place at their surfaces. Even in the case of single-atom alloys, where small quantities of a reactive metal are dispersed within the main host, it is assumed that both elements are exposed and available to bond with the reactants. Here, we show, on the basis of X-ray absorption spectroscopy data, that in alloy catalysts made from Pt highly diluted in Cu the Pt atoms are located at the inner interface between the metal nanoparticles and the silica support instead.

Redox Properties of TiO Thin Films Grown on Mesoporous Silica by Atomic Layer Deposition.

The redox properties of titania films grown by ALD on SBA-15, a silica-based mesoporous material, were characterized as a function of thickness (that is, the number of ALD cycles used). Si CP/MAS NMR helped to identify the nature of the surface species that form in the initial stages of deposition, and infrared absorption spectroscopy was used to follow the transition from silica to titania surfaces. The reducibility of the titania sites by CO and H was studied using EPR and with ambient-pressure XPS.

In situ identification of surface sites in Cu-Pt bimetallic catalysts: Gas-induced metal segregation.

The effect of gases on the surface composition of Cu-Pt bimetallic catalysts has been tested by in situ infrared (IR) and x-ray absorption spectroscopies. Diffusion of Pt atoms within the Cu-Pt nanoparticles was observed both in vacuum and under gaseous atmospheres. Vacuum IR spectra of CO adsorbed on CuPt/SBA-15 catalysts (x = 0-∞) at 125 K showed no bonding on Pt regardless of Pt content, but reversible Pt segregation to the surface was seen with the high-Pt-content (x ≥ 0.

Vanadate Retention by Iron and Manganese Oxides.

Anthropogenic emissions of vanadium (V) into terrestrial and aquatic surface systems now match those of geogenic processes, and yet, the geochemistry of vanadium is poorly described in comparison to other comparable contaminants like arsenic. In oxic systems, V is present as an oxyanion with a +5 formal charge on the V center, typically described as H VO , but also here as V(V). Iron (Fe) and manganese (Mn) (oxy)hydroxides represent key mineral phases in the cycling of V(V) at the solid-solution interface, and yet, fundamental descriptions of these surface-processes are not available.

Designing Sites in Heterogeneous Catalysis: Are We Reaching Selectivities Competitive With Those of Homogeneous Catalysts?

A critical review of different prominent nanotechnologies adapted to catalysis is provided, with focus on how they contribute to the improvement of selectivity in heterogeneous catalysis. Ways to modify catalytic sites range from the use of the reversible or irreversible adsorption of molecular modifiers to the immobilization or tethering of homogeneous catalysts and the development of well-defined catalytic sites on solid surfaces. The latter covers methods for the dispersion of single-atom sites within solid supports as well as the use of complex nanostructures, and it includes the post-modification of materials via processes such as silylation and atomic layer deposition.

Adsorption of crotonaldehyde on metal surfaces: Cu vs Pt.

The thermal chemistry of crotonaldehyde on the surface of a polished polycrystalline copper disk was characterized by temperature-programmed desorption (TPD) and reflection-absorption infrared spectroscopy (RAIRS) and contrasted with previous data obtained on a Pt(111) single crystal substrate. A clear difference in the adsorption mode was identified between the two surfaces, highlighted by the prevalence of RAIRS peaks for the C=C bond on Cu vs for C=O on Pt. Adsorption was also determined to be much weaker on Cu vs Pt, with an adsorption energy on the former ranging from -50 kJ/mol to -65 kJ/mol depending on the surface coverage.

Nucleation and Initial Stages of Growth during the Atomic Layer Deposition of Titanium Oxide on Mesoporous Silica.

A chemical approach to the deposition of thin films on solid surfaces is highly desirable but prone to affect the final properties of the film. To better understand the origin of these complications, the initial stages of the atomic layer deposition of titania films on silica mesoporous materials were characterized. Adsorption-desorption measurements indicated that the films grow in a layer-by-layer fashion, as desired, but initially exhibit surprisingly low densities, about one-quarter of that of bulk titanium oxide.

Adsorption Site Regulation to Guide Atomic Design of Ni-Ga Catalysts for Acetylene Semi-Hydrogenation.

Atomic regulation of metal catalysts has emerged as an intriguing yet challenging strategy to boost product selectivity. Here, we report a density functional theory-guided atomic design strategy for the fabrication of a NiGa intermetallic catalyst with completely isolated Ni sites to optimize acetylene semi-hydrogenation processes. Such Ni sites show not only preferential acetylene π-adsorption, but also enhanced ethylene desorption.

Use of Au@Void@TiO yolk-shell nanostructures to probe the influence of oxide crystallinity on catalytic activity for low-temperature oxidations.

A series of Au@Void@TiO yolk-shell structures were synthesized and characterized, and their catalytic activity was tested for the oxidation of carbon monoxide. The target of this work was to evaluate the effects of (1) the crystallinity of the TiO shell and (2) the presence of titanate phases. Transmission electron microscopy and X-ray diffraction data show that increasing calcination temperatures, from 850 to 1250 K, leads to the formation of larger titania crystallites.

Porous LaFeO Prepared by an in Situ Carbon Templating Method for Catalytic Transfer Hydrogenation Reactions.

Catalytic transfer hydrogenation is an attractive route for the synthesis of biomass-derived chemicals. However, development of efficient, low-cost, and stable catalysts for that reaction is still a challenge. Here, we report on the preparation and testing of a non-noble perovskite oxide (LaFeO) catalyst synthesized by an in situ carbon templating method.

Gas-Phase Electron-Impact Activation of Atomic Layer Deposition (ALD) Precursors: MeCpPtMe.

The use of gas-phase electron-impact activation of metalorganic complexes to facilitate atomic layer depositions (ALD) was tested for the case of (methylcyclopentadienyl)Pt(IV) trimethyl (MeCpPtMe) on silicon oxide films. Uptake enhancements of more than 1 order of magnitude were calculated from X-ray photoelectron spectroscopy (XPS) data. On the basis of the measured C:Pt ratios, the surface species were estimated to mainly consist of MeCpPt moieties, likely because of the prevalent formation of [MeCpPtMe - nH] ions after gas-phase ionization (as determined by mass spectrometry).

Selectivity in Hydrogenation Catalysis with Unsaturated Aldehydes: Parallel versus Sequential Steps.

A high-flux molecular beam setup has been used to characterize the kinetics of the steady-state catalytic hydrogenation of unsaturated aldehydes, specifically of crotonaldehyde, promoted by platinum surfaces under single-collision conditions. Surprisingly, in addition to the hydrogenation of the individual single bonds, to yield the saturated aldehyde and the unsaturated alcohol, the formation of the saturated alcohol, the product of the hydrogenation of both C═C and C═O bonds, was detected as well. This indicates that the dual hydrogenation reaction is a primary pathway and not the result of secondary hydrogenation of the other products as commonly assumed.

High-Potential Metalless Nanocarbon Foam Supercapacitors Operating in Aqueous Electrolyte.

Light-weight graphite foam decorated with carbon nanotubes (dia. 20-50 nm) is utilized as an effective electrode without binders, conductive additives, or metallic current collectors for supercapacitors in aqueous electrolyte. Facile nitric acid treatment renders wide operating potentials, high specific capacitances and energy densities, and long lifespan over 10 000 cycles manifested as 164.

The Chemistry of Inorganic Precursors during the Chemical Deposition of Films on Solid Surfaces.

The deposition of thin solid films is central to many industrial applications, and chemical vapor deposition (CVD) methods are particularly useful for this task. For one, the isotropic nature of the adsorption of chemical species affords even coverages on surfaces with rough topographies, an increasingly common requirement in microelectronics. Furthermore, by splitting the overall film-depositing reactions into two or more complementary and self-limiting steps, as it is done in atomic layer depositions (ALD), film thicknesses can be controlled down to the sub-monolayer level.

Chirality in adsorption on solid surfaces.

In the present review we survey the main advances made in recent years on the understanding of chemical chirality at solid surfaces. Chirality is an important topic, made particularly relevant by the homochiral nature of the biochemistry of life on Earth, and many chiral chemical reactions involve solid surfaces. Here we start our discussion with a description of surface chirality and of the different ways that chirality can be bestowed on solid surfaces.

Correlation between Chiral Modifier Adsorption and Enantioselectivity in Hydrogenation Catalysis.

Infrared absorption spectroscopy performed in situ at the solid-liquid interface revealed that the adsorption on platinum supported catalysts of 1-(1-naphthyl)-ethylamine, which is used as a chiral modifier in hydrogenation catalysis, occurs through the amine group, not the aromatic ring as is widely believed. Comparisons were performed against a set of related modifier compounds with targeted substitutions to help identify the key moiety involved in the adsorption. It was determined that neither naphthalene-based modifiers without amine groups nor those with tertiary amine moieties are capable of adsorbing on the metal surface to any significant extent.

Monte Carlo Simulations of the Uptake of Chiral Compounds on Solid Surfaces.

A Monte Carlo algorithm was developed and used to describe and explain previous experimental results associated with the kinetics of the uptake of chiral molecules on solid surfaces. The specific system simulated in this study is the adsorption of propylene oxide (PO) on Pt(111) surfaces. The surface was represented by a square lattice, and the time evolution of the adsorption, starting from a clean surface, was simulated via a number of sequential events chosen using a stochastic approach based on the so-called Master equation and derived from the formalism advanced by Gillespie.

Effect of the nature of the substrate on the surface chemistry of atomic layer deposition precursors.

The thermal chemistry of Cu(I)-sec-butyl-2-iminopyrrolidinate, a promising copper amidinate complex for atomic layer deposition (ALD) applications, was explored comparatively on several surfaces by using a combination of surface-sensitive techniques, specifically temperature-programmed desorption and x-ray photoelectron spectroscopy (XPS). The substrates explored include single crystals of transition metals (Ni(110) and Cu(110)), thin oxide films (NiO/Ni(110) and SiO/Ta), and oxygen-treated metals (O/Cu(110)). Decomposition of the pyrrolidinate ligand leads to the desorption of several gas-phase products, including CHCN, HCN and butene from the metals and CO and CO from the oxygen-containing surfaces.