Polarization mode control of long-wavelength VCSELs by intracavity patterning.

Polarization mode control is enhanced in wafer-fused vertical-cavity surface-emitting lasers emitting at 1310 nm wavelength by etching two symmetrically arranged arcs above the gain structure within the laser cavity. The intracavity patterning introduces birefringence and dichroism, which discriminates between the two polarization states of the fundamental transverse modes. We find that the cavity modifications define the polarization angle at threshold with respect to the crystal axes, and increase the gain anisotropy and birefringence on average, leading to an increase in the polarization switching current.

Increasing single mode power of 1.3-μm VCSELs by output coupling optimization.

We report on the single mode emission power enhancement of 1.3-μm VCSELs by adjusting the reflectivity of the top GaAs-based DBR for output coupling optimization using selective removal of Bragg reflector layers. Devices with record single mode power of 6.

Control of cavity lifetime of 1.5 µm wafer-fused VCSELs by digital mirror trimming.

Digital chemical etching is used to trim the output mirror thickness of wafer-fused VCSELs emitting at a wavelength near 1.5µm. The fine control of the photon cavity lifetime thus achieved is employed to extract important device parameters and optimize the combination of the threshold current, output power, and direct current modulation characteristics.

Transverse mode discrimination in long-wavelength wafer-fused vertical-cavity surface-emitting lasers by intra-cavity patterning.

Transverse mode discrimination is demonstrated in long-wavelength wafer-fused vertical-cavity surface-emitting lasers using ring-shaped air gap patterns at the fused interface between the cavity and the top distributed Bragg reflector. A significant number of devices with varying pattern dimensions was investigated by on-wafer mapping, allowing in particular the identification of a design that reproducibly increases the maximal single-mode emitted power by about 30 %. Numerical simulations support these observations and allow specifying optimized ring dimensions for which higher-order transverse modes are localized out of the optical aperture.