Dual-comb spectroscopy using plasmon-enhanced-waveguide dispersion-compensated quantum cascade lasers.

In this Letter, we report on sub-millisecond response time mid-infrared dual-comb spectroscopy using a balanced asymmetric (dispersive) dual-comb setup with a matched pair of plasmon-enhanced-waveguide dispersion-compensated quantum cascade lasers. The system performance is demonstrated by measuring spectra of Bromomethane (CHBr) and Freon 134a (CHFCF) at approximately 7.8 μm.

Frequency stability of a dual wavelength quantum cascade laser.

We characterized the dual wavelength operation of a distributed Bragg reflector (DBR) quantum cascade laser (QCL) operating at 4.5 μm using two independent optical frequency discriminators. The QCL emits up to 150 mW fairly evenly distributed between two adjacent Fabry-Perot modes separated by ≈11.

Plasmon-enhanced waveguide for dispersion compensation in mid-infrared quantum cascade laser frequency combs.

We demonstrate dispersion compensation in mid-infrared quantum cascade laser frequency combs (FCs) emitting at 7.8 μm using the coupling of a dielectric waveguide to a plasmonic resonance in the top cladding layer of the latter. Devices with group velocity dispersion lower than 110  fs/mm were fabricated, and narrow beatnotes with FWHM linewidths below 1 kHz were measured on the entire operation range.

Mid infrared quantum cascade laser operating in pure amplitude modulation for background-free trace gas spectroscopy.

We present a single mode multi-section quantum cascade laser source composed of three different sections: master oscillator, gain and phase section. Non-uniform pumping of the QCL's gain reveals that the various laser sections are strongly coupled. Simulations of the electronic and optical properties of the laser (based on the density matrix and scattering matrix formalisms, respectively) were performed and a good agreement with measurements is obtained.

Purely wavelength- and amplitude-modulated quartz-enhanced photoacoustic spectroscopy.

We report here on a quartz-enhanced photoacoustic (QEPAS) sensor employing a quantum cascade laser (QCL) structure capable of operating in a pure amplitude or wavelength modulation configuration. The QCL structure is composed of three electrically independent sections: Gain, Phase (PS) and Master Oscillator (MO). Selective current pumping of these three sections allows obtaining laser wavelength tuning without changes in the optical power, and power modulation without emission wavelength shifts.

High power and single mode quantum cascade lasers.

We present a single mode quantum cascade laser with nearly 1 W optical power. A buried distributed feedback reflector is used on the back section for wavelength selection. The laser is 6 mm long, 3.

Extended tuning of mid-ir quantum cascade lasers using integrated resistive heaters.

We present single mode quantum cascade lasers including a microscopic heater for spectral emission tuning. Through the use of a buried heater element, the active region temperature can be modified without changing the submount one. Emission frequency tuning in continuous-wave as large as 9 cm(-1) at 1270 cm(-1) and 14 cm(-1) at 2040 cm(-1) are observed, corresponding to an increase of the active region temperatures of ∼ 90 K.

All-electrical frequency noise reduction and linewidth narrowing in quantum cascade lasers.

A novel all-electrical method of frequency noise reduction in quantum cascade lasers (QCLs) is proposed. Electrical current through the laser was continuously adjusted to compensate for fluctuations of the laser internal resistance, which led to an active stabilization of the optical emission frequency. A reduction of the linewidth from 1.