We propose a technique of on-site quantitative analysis of Zn(2+) in aqueous solution based on the combination of electrodeposition for preconcentration of Zn onto a Cu electrode and successive underwater laser-induced breakdown spectroscopy (underwater LIBS) of the electrode surface under electrochemically controlled potential. Zinc emission lines are observed with the present technique for a Zn(2+) concentration of 5 ppm. It is roughly estimated that the overall sensitivity over 10 000 times higher is achieved by the preconcentration.
View Article and Find Full Text PDFWe propose a new method to evaluate the interaction potential energy between the particles adsorbed at an oil/water interface as a function of interparticle distance. The method is based on the measurement of the interparticle distance at a vertical oil/water interface, at which the gravitational force is naturally applied to compress the particle monolayer in the in-plane direction. We verified the method by examining whether we obtained the same potential curve upon varying the gravitational acceleration by tilting the interface.
View Article and Find Full Text PDFStratified optical filters with distinct spectral features and layered surface chemistry were prepared on silicon substrates with stepwise anodic porosification and thermal carbonization. The use of differing parameters for successive carbonization treatments enabled the production of hydrolytically stable porous silicon-based layered optical structures where the adsorption of water to the lower layer is inhibited. This enables selective shifting of reflectance bands by means of liquid infiltration.
View Article and Find Full Text PDFWe investigated spatially resolved emission spectra of Al atoms in a very small (∼0.1 mm) laser ablation plasma produced by a single long-pulse (∼100 ns) irradiation of an Al target in water. The spectral feature varied considerably, depending on the position to be measured.
View Article and Find Full Text PDFIn the present work, the characterization of cobalt-porous silicon (Co-PSi) hybrid systems is performed by a combination of magnetic, spectroscopic, and structural techniques. The Co-PSi structures are composed by a columnar matrix of PSi with Co nanoparticles embedded inside, as determined by Transmission Electron Microscopy (TEM). The oxidation state, crystalline structure, and magnetic behavior are determined by X-Ray Absorption Spectroscopy (XAS) and Alternating Gradient Field Magnetometry (AGFM).
View Article and Find Full Text PDFMacroporous structure of silicon can be obtained with anodization in hydrogen fluoride (HF) solution. The macropore formation in the presence of alcohol was studied. Macroporous layer formation in a low-concentration HF solution is stabilized with the increasing number of carbon in alcohol.
View Article and Find Full Text PDFElectrodeposition of platinum and silver into hydrophobic and hydrophilic microporous silicon layers was investigated using chemically-modified microporous silicon electrodes. Hydrophobic microporous silicon enhanced the electrodeposition of platinum in the porous layer. Meanwhile hydrophilic one showed that platinum was hardly deposited within the porous layer and a filmy growth of platinum on the top of the porous layer was observed.
View Article and Find Full Text PDF: Thermally promoted addition of undecylenic acid is studied as a method for modifying porous silicon optical reflectors that have been pre-treated with thermal hydrocarbonization. Successful derivatization of undecylenic acid is demonstrated and confirmed with Fourier transform infrared and X-ray photoelectron spectroscopies. The results indicate that the hydrocarbonization pre-treatment considerably improves stability against oxidation and chemical dissolution in basic environments.
View Article and Find Full Text PDFWe experimentally study the dynamics of the plasma induced by the double-laser-pulse irradiation of solid target in water, and find that an appropriate choice of the pulse energies and pulse interval results in the production of an unprecedentedly mild (low-density) plasma, the emission spectra of which are very narrow even without the time-gated detection. The optimum pulse interval and pulse energies are 15-30 μs and about ~1 mJ, respectively, where the latter values are much smaller than those typically employed for this kind of study. In order to clarify the mechanism for the formation of mild plasma we examine the role of the first and second laser pulses, and find that the first pulse produces the cavitation bubble without emission (and hence plasma), and the second pulse induces the mild plasma in the cavitation bubble.
View Article and Find Full Text PDFDifferent designs for producing multiple stopband mesoporous silicon rugate filters via electrochemical anodization are compared. The effects of light absorption and dispersion to visible range filter design are investigated. Thermal oxidation is applied for passivating the chemically reactive porous silicon surface, and the response of the passivated structures to ethanol vapor is examined.
View Article and Find Full Text PDFElectrodeposition of gold into porous silicon was investigated. In the present study, porous silicon with ~100 nm in pore diameter, so-called medium-sized pores, was used as template electrode for gold electrodeposition. The growth behavior of gold deposits was studied by scanning electron microscope observation of the gold deposited porous silicon.
View Article and Find Full Text PDFThe capability of acousto-optic modulator (AOM) to perform time-gated measurements for laser ablation plasma spectroscopy has been examined. Especially, we focused on the capability of the "AOM gating" to exclude the continuum and extremely broadened spectra usually observed immediately after the laser ablation. Final goal of the use of the AOM is to achieve considerable downsizing of the system for in situ and on-site analyses.
View Article and Find Full Text PDFPeriodic and chaotic oscillations were observed for the potential of p-type Si(111) immersed in an aqueous (HF+CuSO(4)) solution, accompanied by electroless Cu deposition on p-Si. They were, to our knowledge, the first examples of open-circuit potential oscillations observed for semiconductor electrodes. The oscillations appeared only when the Cu deposit formed a continuous porous film composed of mutually connected submicrometer-sized particles.
View Article and Find Full Text PDF