Chemical interaction of 4-META with enamel in resin-enamel bonds.

X-ray photoelectron spectroscopy (XPS) is used to analyze 4-META resin and enamel that are debonded at an adhesive interface. The XPS spectra showed two chemical states for Ca: one resulted from Ca of hydroxyapatite and the other, an unknown chemical state, suggested that Ca was chemically bonded with 4-META. We postulate that for a chemical reaction of 4-META and hydroxyapatite, the chemical structure of carboxyl groups will resemble that of calcium phthalate.

Viscoelastic adlayers of collagen and lysozyme studied using quartz crystal microbalance with dissipation monitoring.

In this study the effects of molecular structure of proteins on their adsorption behaviour and viscoelasticity are investigated using a QCM-D method. The adsorption measurements show that spherical lysozyme is rapidly adsorbed on the gold surface as a stiff monolayer, as indicated by a sharp drop in the oscillation frequency (Deltaf) of the sensor, and by a very small increase in the energy dissipation of the adlayer (DeltaD). Fibrous calfskin collagen (CSC) is, however, adsorbed on the same surface rather slowly in two steps to form a thick and soft multilayer (large Deltaf and DeltaD) at pH 3 in salt-free conditions.

Microscopic observations and inflammatory cytokine productions of human macrophage phagocytising submicron titanium particles.

This study was performed to microscopically observe and measure inflammatory cytokine production by human macrophages phagocytosing submicron titanium (Ti) particles. Observations with secondary electron microscopy (SEM), SEM/electron probe microanalysis (EPMA) and transmission electron microscopy (TEM) indicated that macrophages [phorbol-12-myristate-13-acetate (PMA)-differentiated THP-1 cells] at 24 h in culture actively phagocytosed and accumulated submicron Ti particles in intracellular phagosomes, in which refinement of Ti particles occurred. The macrophages were also cultured for 24 h in four media with and without submicron Ti particles and lipopolysaccharide (LPS; components of bacteria).

Gene expression analyses of human macrophage phagocytizing sub-micro titanium particles by allergy DNA chip (Genopal).

The purpose of this study was to examine gene expressions of macrophage phagocytizing sub-micro Ti particles by a DNA chip. Human monocytic cell line THP-1 was differentiated into macrophages by culturing for two days in medium supplemented with 200 nM phorbol ester (PMA). The macrophages were then cultured in four media: medium without PMA (control); medium with suspended sub-micro Ti particles (0.

Preparation and in vivo evaluation of apatite/collagen packed composite by alternate immersion method and Newton press.

Further development of bio-compatible, bio-absorbable, and osteo-conductive bio-materials is desired for bone grafts in dental and medical clinics. One candidate material might be a high-density apatite/collagen composite, which cures relatively large bone defects. To produce such a composite, we freeze-dried type I collagen solution, cross-linked the formed sponge by 2 wt % glutaraldehyde, immersed the insoluble sponge in CaCl(2) and Na(2)HPO(4) solutions alternately five times, and compacted the sponge by Newton press at 5000 kgf.

Effect of pH and addition of salt on the adsorption behavior of lysozyme on gold, silica, and titania surfaces observed by quartz crystal microbalance with dissipation monitoring.

The adsorption behaviors of lysozyme on dentally related Au, SiO2, and TiO2 surfaces were investigated by a quartz crystal microbalance with dissipation monitoring (QCM-D) method. Frequency shifts indicated that while lysozyme (pI 11) was fairly adsorbed on the SiO2 (pI 1.9) surface at both pH 3 and 7, it was adsorbed on TiO2 (pI 6.

Dose-dependent effects of Ni (II) ions on production of three inflammatory cytokines (TNF-alpha, IL-1beta and IL-6), superoxide dismutase (SOD) and free radical NO by murine macrophage-like RAW264 cells with or without LPS-stimulation.

The effect of Ni (II) ions on macrophages is not well understood. The purpose of this study was to examine the dose-dependent effects of Ni (II) ions up to 1,000 micromol/L on production of three inflammatory cytokines (TNF-alpha, IL-1beta and IL-6), superoxide dismutase (SOD) and nitric oxide (NO) by murine macrophage-like RAW264 cells with (+) or without (-) lipopolysaccharide (LPS) -stimulation. Ni (II) ions caused LPS (-) RAW264 cells to slightly increase production of TNF-alpha and IL-6, proportionally to the Ni (II) ion concentration while IL-1beta was not produced, and to slightly increase production of SOD and NO.

New index for the stability of a type I collagen affected by hydrophobic environment.

Effects of hydrophobic environment adjusted by various alcohols on the structural stability of calfskin collagen (CSC) were studied to elucidate the nature of collagen-monomer interaction in adhesion. The stability of CSC in aqueous alcohol solutions was represented by its denaturation temperature, Td, measured by DSC. The hydrophobicity of the alcohol solutions was quantified with their specific dielectric constants, epsilon(r), calculated from their concentrations.

Accumulation of element Ti in macrophage-like RAW264 cells cultured in medium with 1 ppm Ti and effects on cell viability, SOD production and TNF-alpha secretion.

The adverse effect of Ti on body-defense macrophage is not well understood. The aims of this study were twofold: (1) to examine the intracellular accumulation of Ti element; and (2) to measure the cell viability, superoxide dismutase (SOD) production, and TNF-alpha secretion of macrophage-like RAW264 cells cultured for two days in medium with 1 ppm Ti prepared from acidic ICP Ti standard solution. PIXE analysis showed that element Ti was accumulated up to 7.

Sulfuration resistance of five experimental Ag-Pd-Au-Cu alloys with low Pd content of 10 or 12%.

Commercial Ag-based alloy (46Ag-20Pd-12Au-20Cu alloy) is widely used in Japan as a casting alloy. As opposed to the commercial composition, we prepared five experimental Ag-based alloys with reduced Pd content of 10 or 12%, increased Au content of 20 to 30%, and reduced Cu content of 12 to 20%. We then evaluated their sulfuration resistance by analyzing cast specimen surfaces dipped in 0.

Effects of Ni2+ ions on cell viability and NO production of murine peritoneal exudate cells (macrophages) with and without lipopolysaccharide stimulation.

The purpose of this study was to clarify the cytotoxicity of Ni2+ ions against murine peritoneal exudate cells (PEC) (macrophages). First, we examined the cell viability of PEC with and without lipopolysaccharide (LPS) stimulation in culture media containing Ni2+ ions up to 1000 micromol/L. Results showed that the cytotoxicity of Ni2+ ions against PEC was dose-dependent and accelerated by LPS stimulation, especially in media with Ni2+ ions exceeding 100 micromol/L.

Nonlinear large-deflection analysis of orthodontic wires.

The purposes of this study were (1) to measure the nonlinear force-deflection behavior of selected orthodontic wires using a conventional tensile test, (2) to extend a mathematical model for simulating the force system produced by orthodontic wires based on the small-deflection linear theory to the large-deflection nonlinear theory, and (3) to examine the effects of the cross-section and mechanical properties of orthodontic wires on nonlinear characteristics. A method for extending a mathematical model for simulating the force system produced by orthodontic wires based on the small-deflection linear theory to the large-deflection nonlinear theory was established, and this can provide a clear view of the true nature of orthodontic wires. Furthermore, our results demonstrated that the nonlinear properties of orthodontic wires were affected more by the cross-sectional shape than by mechanical properties.

Micromorphological changes in resin-dentin bonds after 1 year of water storage.

The purpose of this study was to evaluate the degradation of resin-dentin bonds after 1 year of water storage. Resin-dentin-bonded specimens were prepared with the use of an adhesive resin system (One-Step: Bisco). Half of the experimental specimens were sectioned perpendicular to the adhesive interface to produce a beam (adhesive area: 0.

A novel method for the three-dimensional (3-D) analysis of orthodontic tooth movement-calculation of rotation about and translation along the finite helical axis.

The purpose of this study was to establish a novel method for evaluating orthodontic tooth movement in three-dimensional (3-D) space. The present system consisted of the following procedures at a given treatment period: (1) 3-D tooth positions were measured with a 3-D surface-scanning system using a slit laser beam; (2) the 3-D shape data were registered automatically at the maxillary first molars, and the coordinate systems were normalized; (3) the rotation matrix and translation vector were calculated from the automatic registration of the two position data for a given tooth; (4) the finite helical axes of teeth were calculated as the locus of zero rotational displacement; and (5) tooth movement was presented as rotation about and translation along the finite helical axis. To test this system, a male patient (age 22 yr 2 months) with Angle Class III malocclusion and moderate crowding of the anterior teeth, who had been treated using a standard multi-bracket appliance, was used as a model case in this study.