Assessment of titanium metallization thin film deposited on alumina substrate: Microstructure and nano-indentation.

Surface titanium (Ti) metallization was conducted on alumina (AlO) through chemical vapor deposition (CVD) method derived from non-contact pack cementation. The effects of different deposition temperature (1000 °C, 1050 °C, and 1100 °C) were examined in this scenario. The morphology, phase composition, and interfacial defects of the resulting films were systematically investigated through scanning electron microscopy, energy dispersive spectrometry, and X-ray diffraction.

Quasi-static and dynamic experimental studies on the tensile strength and failure pattern of concrete and mortar discs.

As concrete and mortar materials widely used in structural engineering may suffer dynamic loadings, studies on their mechanical properties under different strain rates are of great importance. In this paper, based on splitting tests of Brazilian discs, the tensile strength and failure pattern of concrete and mortar were investigated under quasi-static and dynamic loadings with a strain rate of 1-200 s. It is shown that the quasi-static tensile strength of mortar is higher than that of concrete since coarse aggregates weaken the interface bonding strength of the latter.

Strain-induced phase transformation behavior of stabilized zirconia ceramics studied via nanoindentation.

To study the tetragonal-to-monoclinic (T-M) phase transformation behavior under different strain rates and indentation depths, nanoindentation tests were performed on stabilized zirconia ceramics with Continuous Stiffness Measurements. The results indicate decreased phase transformation velocities at both lower and higher strain rates, but increased velocity under medium strain rate during loading. The phase transformation process is sensitive to Ṗ/P but the final volume fractions are almost identical (45%).

Spherical and cylindrical cavity expansion models based prediction of penetration depths of concrete targets.

The cavity expansion theory is most widely used to predict the depth of penetration of concrete targets. The main purpose of this work is to clarify the differences between the spherical and cylindrical cavity expansion models and their scope of application in predicting the penetration depths of concrete targets. The factors that influence the dynamic cavity expansion process of concrete materials were first examined.

Microstructure, corrosion and tribological and antibacterial properties of Ti-Cu coated stainless steel.

A Ti-Cu coated layer on 316L stainless steel (SS) was obtained by using the Closed Field Unbalanced Magnetron Sputtering (CFUBMS) system to improve antibacterial activity, corrosion and tribological properties. The microstructure and phase constituents of Ti-Cu coated layer were characterized by using X-ray diffraction (XRD), scanning electron microscopy (SEM) and glow discharge optical emission spectrometry (GDOES). The corrosion and tribological properties of a stainless steel substrate, SS316L, when coated with Ti-Cu were investigated in a simulated body fluid (SBF) environment.