Desert Abiotic Carbon Sequestration Weakening by Precipitation.

Desert carbon sequestration plays an active role in promoting carbon neutralization. However, the current understanding of the effect of hydrothermal interactions and soil properties on desert carbon sequestration after precipitation remains unclear. Based on the experiment in the hinterland of the Taklimakan Desert, we found that the heavy precipitation will accelerate the weakening of abiotic carbon sequestration in deserts under the background of global warming and intensified water cycle.

Evaluation of carbon sink in the Taklimakan Desert based on correction of abnormal negative CO flux of IRGASON.

Studies showing that deserts can sequester CO through non-photosynthetic processes have contributed to locating missing carbon sinks. However, the contradiction between the desert CO flux obtained by different observation methods leads to uncertainty in evaluating desert carbon sequestration. This has caused scepticism regarding desert carbon sequestration after years of research.

Stability Improvement of High-Pressure-Ratio Turbocharger Centrifugal Compressor by Asymmetrical Flow Control-Part II: Nonaxisymmetrical Self-Recirculation Casing Treatment.

This is part II of a two-part paper involving the development of an asymmetrical flow control method to widen the operating range of a turbocharger centrifugal compressor with high-pressure ratio. A nonaxisymmetrical self-recirculation casing treatment (SRCT) as an instance of asymmetrical flow control method is presented. Experimental and numerical methods were used to investigate the impact of nonaxisymmetrical SRCT on the surge point of the centrifugal compressor.

Stability Improvement of High-Pressure-Ratio Turbocharger Centrifugal Compressor by Asymmetric Flow Control-Part I: Non-Axisymmetrical Flow in Centrifugal Compressor.

This is Part I of a two-part paper documenting the development of a novel asymmetric flow control method to improve the stability of a high-pressure-ratio turbocharger centrifugal compressor. Part I focuses on the nonaxisymmetrical flow in a centrifugal compressor induced by the nonaxisymmetrical geometry of the volute while Part II describes the development of an asymmetric flow control method to avoid the stall on the basis of the characteristic of nonaxisymmetrical flow. To understand the asymmetries, experimental measurements and corresponding numerical simulation were carried out.