Effect of Milling Speed on the Properties of Zirconia Restorations.

Background: The purpose of this study was to evaluate the effect of milling speed on the surface roughness, marginal gap, marginal gap volume, marginal offset, and fracture load of zirconia restorations.

Material And Methods: A mandibular molar #30 typodont tooth was digitally scanned and an ideal crown preparation for a zirconia restoration was digitally created. A single master model die of the crown preparation was milled out of a resin material.

Accuracy of an intraoral scanner based on sleeve type, decontamination, and calibration.

The purpose of this study was to evaluate the accuracy of an intraoral scanner based on camera sleeve type, decontamination protocol, and calibration status. Five extracted human teeth were set into a gypsum stone model and prepared for various indirect restorations. An optical impression was completed with a benchtop scanner to serve as a reference standard.

Novel chairside spectrometer-trained system for measuring the irradiance of light-curing units.

The purpose of this study was to compare the performances of 5 different instruments in measuring the irradiance of light-curing units (LCUs). A novel spectrometer-trained radiometer (CheckUp), 2 conventional chairside radiometers (Bluephase Meter I and Bluephase Meter II), and 2 devices considered to be gold standards for measuring irradiance (an integrating sphere spectrometer and a thermopile sensor) were used to evaluate 7 LCUs. The irradiance of each LCU was measured 10 times with each meter.

Fracture load of zirconia crowns based on preparation and cement type.

Limited research has been published evaluating the failure of zirconia crowns with less retentive tooth preparations. The purpose of this study was to evaluate the effect of axial wall height (AWH) and cement type on the fracture load of cubic phase-containing zirconia crowns. Standardized crown preparations with an AWH of 0, 2, or 4 mm (n = 10) were made in 90 extracted human maxillary third molars.

Management of dental anxiety via distraction technique.

Background: The purpose of this study was to evaluate the use of a stress ball as a distraction technique on stress levels of patients undergoing a dental procedure.

Material And Methods: A randomized, split-mouth design was conducted using 20 adult subjects requiring scaling and root planing (Sc/RP) in all four quadrants. Each side of the mouth (maxillary/mandibular) received Sc/RP with local anesthetic with or without the use of a stress-ball distraction over two separate sessions.