Cone-beam reprojection using projection-matrices.

This paper addresses reprojection of three-dimensional (3-D) reconstructions obtained from cone-beam scans using a C-arm imaging equipment assisted by a pose-determining system. The emphasis is on reprojecting without decomposing the estimated projection matrix (P-matrix) associated with a pose. Both voxel- and ray-driven methods are considered.

Implementation of a cone-beam reconstruction algorithm for the single-circle source orbit with embedded misalignment correction using homogeneous coordinates.

We present an efficient implementation of an approximate cone-beam image reconstruction algorithm for application in tomography, which accounts for scanner mechanical misalignment. The implementation is based on the algorithm proposed by Feldkamp et al. and is directed at circular scan paths.

Enhanced 3-D-reconstruction algorithm for C-arm systems suitable for interventional procedures.

Increasingly, three-dimensional (3-D) imaging technologies are used in medical diagnosis, for therapy planning, and during interventional procedures. We describe the possibilities of fast 3-D-reconstruction of high-contrast objects with high spatial resolution from only a small series of two-dimensional (2-D) planar radiographs. The special problems arising from the intended use of an open, mechanically unstable C-arm system are discussed.

Techniques to alleviate the effects of view aliasing artifacts in computed tomography.

Due to practical limitations in data acquisition, 3-D computed tomography systems must attempt to provide rapid reconstructions of acceptable quality from a limited number of views. The use of convolution backprojection (CBP) for image reconstruction from an inadequate number of projections, results in view aliasing artifacts. In this paper we investigate different post-processing methods of alleviating the effects of view aliasing artifacts.