Publications by authors named "Werkema D"

There is a need to develop field-scale, in situ screening technologies for assessing variations in aqueous film-forming foam (AFFF) concentrations in soils at former fire training and storage sites. Field-scale Spectral Induced Polarization (SIP) geophysical measurements were acquired on a transect crossing an AFFF source zone. Soil samples were acquired to determine variations in poly- and per-fluoroalkyl substances (PFAS) concentrations in soils, characterize soil texture, and create triplicate soil columns for laboratory SIP measurements.

View Article and Find Full Text PDF

Few field methods are available for characterizing source zones impacted with aqueous film forming foam (AFFF). Non-invasive geophysical characterization of AFFF source zone contamination in situ could assist with the delineation and characterization of these sites, allowing for more informed sampling regimes aimed at quantifying subsurface poly- and perfluoroalkyl substances (PFAS) contamination. We present initial results from the investigation of the sensitivity of two existing surface and borehole-deployable geophysical technologies, spectral induced polarization (SIP), and low field nuclear magnetic resonance (NMR), to soils impacted with AFFF.

View Article and Find Full Text PDF

Geophysical methods can provide three-dimensional (3D), spatially continuous estimates of soil moisture. However, point-to-point comparisons of geophysical properties to measure soil moisture data are frequently unsatisfactory, resulting in geophysics being used for qualitative purposes only. This is because (1) geophysics requires models that relate geophysical signals to soil moisture, (2) geophysical methods have potential uncertainties resulting from smoothing and artifacts introduced from processing and inversion, and (3) results from multiple geophysical methods are not easily combined within a single soil moisture estimation framework.

View Article and Find Full Text PDF

We present and demonstrate a recursive-estimation framework to infer groundwater/surface-water exchange based on temperature time series collected at different vertical depths below the sediment/water interface. We formulate the heat-transport problem as a state-space model (SSM), in which the spatial derivatives in the convection/conduction equation are approximated using finite differences. The SSM is calibrated to estimate time-varying specific discharge using the Extended Kalman Filter (EKF) and Extended Rauch-Tung-Striebel Smoother (ERTSS).

View Article and Find Full Text PDF

We present the results of a lab-scaled feasibility study to assess the performance of electrical resistivity tomography for detection, characterization, and monitoring of fuel grade ethanol releases to the subsurface. Further, we attempt to determine the concentration distribution of the ethanol from the electrical resistivity tomography data using mixing-models. Ethanol is a renewable fuel source as well as an oxygenate fuel additive currently used to replace the known carcinogen methyl tert-butyl ether; however, ethanol is preferentially biodegraded and a cosolvent.

View Article and Find Full Text PDF

Groundwater/surface-water (GW/SW) exchange and hyporheic processes are topics receiving increasing attention from the hydrologic community. Hydraulic, chemical, temperature, geophysical, and remote sensing methods are used to achieve various goals (e.g.

View Article and Find Full Text PDF

Fiber-optic distributed temperature sensing (FO-DTS) has proven to be a transformative technology for the hydrologic sciences, with application to diverse problems including hyporheic exchange, groundwater/surface-water interaction, fractured-rock characterization, and cold regions hydrology. FO-DTS produces large, complex, and information-rich datasets. Despite the potential of FO-DTS, adoption of the technology has been impeded by lack of tools for data processing, analysis, and visualization.

View Article and Find Full Text PDF
Article Synopsis
  • Ground-penetrating radar (GPR) is being increasingly used in biology for non-invasive mapping of subsurface features, including tree roots and animal burrows.
  • Four case studies illustrate GPR's effectiveness in investigating the burrows of cutter ants in Brazil, groundhogs in Michigan, and burrowing bees in Pennsylvania, highlighting hazards they pose in various settings.
  • The research, conducted over two decades, showcases how GPR technology has evolved and emphasizes its role in understanding ecological impacts and potential risks related to underground structures.
View Article and Find Full Text PDF

The characterization of pore-space connectivity in porous media at the sediment/water interface is critical in understanding contaminant transport and reactive biogeochemical processes in zones of groundwater and surface-water exchange. Previous in situ studies of dual-domain (i.e.

View Article and Find Full Text PDF

Soil stabilization involves methods used to turn unconsolidated and unstable soil into a stiffer, consolidated medium that could support engineered structures, alter permeability, change subsurface flow, or immobilize contamination through mineral precipitation. Among the variety of available methods carbonate precipitation is a very promising one, especially when it is being induced through common soil borne microbes (MICP - microbial induced carbonate precipitation). Such microbial mediated precipitation has the added benefit of not harming the environment as other methods can be environmentally detrimental.

View Article and Find Full Text PDF

Noninvasive geophysical estimation of soil moisture has potential to improve understanding of flow in the unsaturated zone for problems involving agricultural management, aquifer recharge, and optimization of landfill design and operations. In principle, several geophysical techniques (e.g.

View Article and Find Full Text PDF

Brook trout spawn in fall and overwintering egg development can benefit from stable, relatively warm temperatures in groundwater-seepage zones. However, eggs are also sensitive to dissolved oxygen concentration, which may be reduced in discharging groundwater (i.e.

View Article and Find Full Text PDF
Article Synopsis
  • The study examines how clay-organic interactions affect complex conductivity measurements in sand mixtures containing kaolinite and illite, specifically as ethanol concentration varies.
  • Specific polarizability, a key measure in the analysis, decreased with increased ethanol levels, indicating significant changes in electrical conductivity responses across the mixtures.
  • Results suggest that surface chemistry changes due to ethanol have a greater impact on clay behavior than the type of clay mineral present, highlighting the importance of specific surface area in these measurements.
View Article and Find Full Text PDF

Groundwater flow advects heat, and thus, the deviation of subsurface temperatures from an expected conduction-dominated regime can be analysed to estimate vertical water fluxes. A number of analytical approaches have been proposed for using heat as a groundwater tracer, and these have typically assumed a homogeneous medium. However, heterogeneous thermal properties are ubiquitous in subsurface environments, both at the scale of geologic strata and at finer scales in streambeds.

View Article and Find Full Text PDF

Geophysical tools have much to offer users in environmental, water resource, and geotechnical fields; however, techniques such as electrical resistivity imaging (ERI) are often oversold and/or overinterpreted due to a lack of understanding of the limitations of the techniques, such as the appropriate depth intervals or resolution of the methods. The relationship between ERI data and resistivity is nonlinear; therefore, these limitations depend on site conditions and survey design and are best assessed through forward and inverse modeling exercises prior to field investigations. In this approach, proposed field surveys are first numerically simulated given the expected electrical properties of the site, and the resulting hypothetical data are then analyzed using inverse models.

View Article and Find Full Text PDF
Article Synopsis
  • Geophysical methods are becoming increasingly important for understanding and monitoring fractured-rock aquifers, aiding groundwater remediation efforts despite challenges posed by their complexity.
  • Many remediation professionals face difficulties as geophysical results often require interpretation to relate them to critical properties, leading to a need for more practical demonstrations of these methods in real-life scenarios.
  • The article aims to enhance the use of geophysical methods by providing a summary of these techniques, reviewing case studies, and discussing best practices for method selection based on modeling and decision support tools.
View Article and Find Full Text PDF

The increase in the use of nanoscale materials in consumer products has resulted in a growing concern of their potential hazard to ecosystems and public health from their accidental or intentional introduction to the environment. Key environmental, health, and safety research needs include knowledge and methods for their detection, characterization, fate, and transport. Specifically, techniques available for the direct detection and quantification of their fate and transport in the environment are limited.

View Article and Find Full Text PDF

A new version of the computer program 1DTempPro extends the original code to include new capabilities for (1) automated parameter estimation, (2) layer heterogeneity, and (3) time-varying specific discharge. The code serves as an interface to the U.S.

View Article and Find Full Text PDF

Numerous adverse effects are associated with the accidental release of ethanol (EtOH) and its persistence in the subsurface. Geophysical techniques may permit non-invasive, real time monitoring of microbial degradation of hydrocarbon. We performed complex resistivity (CR) measurements in conjunction with geochemical data analysis on three microbial-stimulated and two control columns to investigate changes in electrical properties during EtOH biodegradation processes in porous media.

View Article and Find Full Text PDF

We performed complex resistivity (CR) measurements on laboratory columns to investigate changes in electrical properties as a result of varying ethanol (EtOH) concentration (0% to 30% v/v) in a sand-clay (bentonite) matrix. We applied Debye decomposition, a phenomenological model commonly used to fit CR data, to determine model parameters (time constant: τ, chargeability: m, and normalized chargeability: mn). The CR data showed a significant (P≤0.

View Article and Find Full Text PDF

A new computer program, 1DTempPro, is presented for the analysis of vertical one-dimensional (1D) temperature profiles under saturated flow conditions. 1DTempPro is a graphical user interface to the U.S.

View Article and Find Full Text PDF

Ethanol (EtOH), an emerging contaminant with potential direct and indirect environmental effects, poses threats to water supplies when spilled in large volumes. A series of experiments was directed at understanding the electrical geophysical signatures arising from groundwater contamination by ethanol. Conductivity measurements were performed at the laboratory scale on EtOH-water mixtures (0 to 0.

View Article and Find Full Text PDF