The purpose of this study was to establish an acid-etching procedure for altering the Ca/P ratio of the nanostructured surface of hydroxyapatite (HAP) by using surface chemical and morphological analyses (XPS, XRD, SEM, surface roughness, and wettability) and to evaluate the in vitro response of osteoblast-like cells (MC3T3-E1 cells) to the modified surfaces. This study utilized HAP and HAP treated with 10%, 20%, 30%, 40%, 50%, or 60% phosphoric acid solution for 10 minutes at 25°C, followed by rinsing 3 times with ultrapure water. The 30% phosphoric acid etching process that provided a Ca/P ratio of 1.
View Article and Find Full Text PDFThe purpose of this study was to evaluate preoperative CT-derived bone densities in Hounsfield units (HU) at implant sites that acquired primary stability, and to compare these values to the optimal bone densities proposed in the literature. Fifty-one patients, 18 males (37 implant sites) and 33 females (67 implant sites) between 2003 and 2010 were assessed. CT data for different jaw sections, regions, and operating procedures were compared using the Kruskal-Wallis test and Scheffe's test for multiple comparisons (P < 0.
View Article and Find Full Text PDFThe purpose of this study was to measure the time-dependent chemical interaction between synthetic RGDS(PO(3)H(2))PA (P-RGD) peptide and titanium surfaces using a titanium surface plasmon resonance (SPR) biosensor and to determine the degree of peptide immobilization on the surfaces. An SPR instrument for 'single-spot' analysis was used for nanometer-scale detection of biomolecular adsorption using a He-Ne laser light according to Knoll's method. The oxidized titanium surface was etched when exposed to H(3)PO(4) solutions with a pH of 2.
View Article and Find Full Text PDFThe purpose of this study was to compare the influence of three kinds of storage methods on surface roughness of tissue conditioners. Four commercial tissue conditioners (GC Soft Liner, Softone, Fictioner, and Hydro-Cast) were used in this study. Five samples of each material were stored in distilled water, air, and a denture cleanser (Polident).
View Article and Find Full Text PDF