Stability and performance investigation using different electrode configurations and electrolyte compositions in an oxyhydrogen gas generator.

This study aimed to develop an efficient HHO generator with higher gas production, enhanced electrodes, and stable current density. For HHO generator stack fabrication, 15 plates of 304L stainless steel were utilized, accompanied with a 4 mm rubber separator to maintain the gap between electrodes. Each plate in the stack was connected a separate wire through lug spot welding, enabling the assembly of different configurations for testing.

Influence of Operating and Electrochemical Parameters on PEMFC Performance: A Simulation Study.

Proton exchange membrane fuel cell, or polymer electrolyte fuel cell, (PEMFC) has received a significant amount of attention for green energy applications due to its low carbon emission and less other toxic pollution capacity. Herein, we develop a three-dimensional (3D) computational fluid dynamic model. The values of temperature, pressure, relative humidity, exchange coefficient, reference current density (RCD), and porosity values of the gas diffusion layer (GDL) were taken from the published literature.

Mechanical and Biomimetic Characteristics of Bulk-Fill Resin Dental Composites Following Exposure in a Simulated Acidic Oral Environment.

During the last 10 years, various companies have marketed different "bulk-fill" resin dental composites for the restoration of posterior stress-bearing teeth; however, the impact of acidic conditions on these relatively newer materials has not been thoroughly investigated. Therefore, an attempt was made to evaluate the effect of acidic beverages on the mechanical biomimetic characteristics of four bulk-fill and one conventional nanohybrid resin-based dental composites (RBCs). The specimens of each RBC were stored in two acidic beverages namely 'Orange Juice' and 'Coca-Cola', whereas 'dry' and 'distilled water' storage of specimens served as controls.