Thermodynamic Studies on the Hydrolysis of Trivalent Plutonium and Solubility of Pu(OH)(am).

The temperature-dependent reaction properties of actinide elements are of particular interest in the safety assessment of high-level radioactive waste (HLRW) disposal systems. In this study, the hydrolysis of Pu(III) and the solubility of Pu(OH)(am) were investigated at various temperatures (10-40 °C) in 0.1 M NaClO.

Structural and spectroscopic studies of spontaneously formed crystalline Eu(iii)-aliphatic dicarboxylates at room temperature.

Complexation of actinides and lanthanides with carboxylic organic ligands is a critical issue affecting radionuclide migration from deep geological disposal systems of spent nuclear fuel. A series of Eu(iii)-aliphatic dicarboxylate compounds, as chemical analogs of radioactive Am(iii) species, Eu(Ox)(HO), Eu(Mal)(HO), and Eu(Suc)(HO), were synthesized and characterized using X-ray crystallography and time-resolved laser fluorescence spectroscopy to examine the ligand-dependent binding modes and the corresponding changes in spectroscopic properties. Powder X-ray crystallography results confirmed that all of the compounds presented a crystalline polymer structure with a trigonal prism square-face tricapped polyhedron geometry centered on Eu(iii) in a nine-coordinate environment involving nine oxygen atoms.

Studies of aqueous U(iv) equilibrium and nanoparticle formation kinetics using spectrophotometric reaction modeling analysis.

Hydrolysis of tetravalent uranium (U(iv)) and U(iv)-nanoparticle formation kinetics were examined over a wide range of temperatures using spectrophotometric reaction modeling analysis. The characteristic absorption bands representing U, U(OH), and a proposed oxohydroxo species were newly identified in the UV region (190-300 nm). Dynamic absorption band changes in the UV and visible regions (360-800 nm) were explored to reevaluate the binary ion interaction coefficients for U(iv) ions and the thermodynamic constants of the primary hydrolysis reaction, including complexation constants, enthalpy, and entropy.

Study of Aqueous Am(III)-Aliphatic Dicarboxylate Complexes: Coordination Mode-Dependent Optical Property and Stability Changes.

The thermodynamics of Am(III) complex formation in natural groundwater systems is one of the major topics of research in the field of high-level radioactive waste management. In this study, we investigate the absorption and luminescence properties of aqueous Am(III) complexes with a series of aliphatic dicarboxylates in order to learn the thermodynamic complexation behaviors in relation to binding geometries. The formation of Am(III) complexes with these carboxylate ligands induced distinct red shifts in the absorption spectra, which enabled chemical speciation.

Electronic Effect on the Molecular Motion of Aromatic Amides: Combined Studies Using VT-NMR and Quantum Calculations.

Rotational barrier energy studies to date have focused on the amide bond of aromatic compounds from a kinetic perspective using quantum calculations and nuclear magnetic resonance (NMR). These studies provide valuable information, not only regarding the basic conformational properties of amide bonds but also the molecular gear system, which has recently gained interest. Thus, we investigate the precise motion of the amide bonds of two aromatic compounds using an experimental rotational barrier energy estimation by NMR experiments and a theoretical evaluation of the density functional theory calculation.

Hydrolysis of trivalent plutonium and solubility of Pu(OH) (am) under electrolytic reducing conditions.

The aim of this work is to determine the solubility product of plutonium hydroxide under reducing conditions and to ascertain the stability of Pu(OH) (am) in water. Hydrolysis of Pu(iii) and solubility of Pu(OH) (am) were investigated at a constant ionic strength of 0.1 M NaClO.

Quantitative analysis of uranium in aqueous solutions using a semiconductor laser-based spectroscopic method.

A simple analytical method based on the simultaneous measurement of the luminescence of hexavalent uranium ions (U(VI)) and the Raman scattering of water, was investigated for determining the concentration of U(VI) in aqueous solutions. Both spectra were measured using a cw semiconductor laser beam at a center wavelength of 405 nm. The empirical calibration curve for the quantitative analysis of U(VI) was obtained by measuring the ratio of the luminescence intensity of U(VI) at 519 nm to the Raman scattering intensity of water at 469 nm.

Responses of endothelial cells to extremely slow flows.

The process of blood vessel formation is accompanied by very minimal flow in the beginning, followed by increased flow rates once the vessel develops sufficiently. Many studies have been performed for endothelial cells at shear stress levels of 0.1-60 dyn∕cm(2); however, little is known about the effect of extremely slow flows (shear stress levels of 10(-4)-10(-2) dyn∕cm(2)) that endothelial cells may experience during early blood vessel formation where flow-sensing by indirect mass transport sensing rather than through mechanoreceptor sensing mechanisms would become more important.

Patterned electrode-based amperometric gas sensor for direct nitric oxide detection within microfluidic devices.

This article describes a thin amperometric nitric oxide (NO) sensor that can be microchannel embedded to enable direct real-time detection of NO produced by cells cultured within the microdevice. A key for achieving the thin ( approximately 1 mm) planar sensor configuration required for sensor-channel integration is the use of gold/indium-tin oxide patterned electrode directly on a porous polymer membrane (pAu/ITO) as the base working electrode. The electrochemically deposited Au-hexacyanoferrate layer on pAu/ITO is used to catalyze NO oxidation to nitrite at lower applied potentials (0.

Hard top soft bottom microfluidic devices for cell culture and chemical analysis.

We report fabrication and characterization of microfluidic devices made of thermoplastic and elastomeric polymers. These hard-soft hybrid material devices are motivated by the combined need for large scale manufacturability, enhanced barrier properties to gas permeation and evaporation of aqueous solutions compared to poly(dimethyl siloxane) (PDMS) devices, and compatibility with deformation-based actuation. Channel features are created on rigid polymers such as polyethylene terephthalate glycol (PETG), cyclic olefin copolymer (COC), and polystyrene (PS) by hot embossing.

Amperometric S-nitrosothiol sensor with enhanced sensitivity based on organoselenium catalysts.

A new S-nitrosothiol (RSNO) detection strategy based on an electrochemical sensor is described for rapidly estimating levels of total RSNOs in blood and other biological samples. The sensor employs a cellulose dialysis membrane covalently modified with an organoselenium catalyst that converts RSNOs to NO at the distal tip of an amperometric NO sensor. The sensor is characterized by very low detection limits (<20 nM), good long-term stability, and can be employed for the rapid detection of total low-molecular-weight (LMW) RSNO levels in whole blood samples using a simple standard addition method.

S-nitrosothiol detection via amperometric nitric oxide sensor with surface modified hydrogel layer containing immobilized organoselenium catalyst.

A novel electrochemical device for the direct detection of S-nitrosothiol species (RSNO) is proposed by modifying an amperometric nitric oxide (NO) gas sensor with thin hydrogel layer containing an immobilized organoselenium catalyst. The diselenide, 3,3'-dipropionicdiselenide, is covalently coupled to primary amine groups in polyethylenimine (PEI), which is further cross-linked to form a hydrogel layer on a dialysis membrane support. Such a polymer film containing the organoselenium moiety is capable of decomposing S-nitrosothiols to generate NO(g) at the distal tip of the NO sensor.

Catalytic generation of nitric oxide from S-nitrosothiols using immobilized organoselenium species.

Novel nitric oxide (NO) generating polymeric materials possessing immobilized organoselenium species are described. These materials mimic the capability of small organoselenium molecules as well as a known selenium-containing enzyme, glutathione peroxidase (GPx), by catalytically decomposing S-nitrosothiols (RSNO) into NO and the corresponding free thiol. Model polymeric materials, e.

Direct detection of S-nitrosothiols using planar amperometric nitric oxide sensor modified with polymeric films containing catalytic copper species.

The direct amperometric detection of S-nitrosothiol species (RSNOs) is realized by modifying a previously reported amperometric nitric oxide gas sensor with thin hydrophilic polyurethane films containing catalytic Cu(II)/(I) sites. Catalytic Cu(II)/(I)-mediated decomposition of S-nitrosothiols generates NO(g) in the thin polymeric film at the distal tip of the NO sensor. Three different species are examined to create the catalytic layer: (1) a lipophilic Cu(II)-ligand complex; (2) Cu(II)-phosphate salt; and (3) small (3-microm) metallic Cu(0) particles.