A Gas Pressure Scale Based on Primary Standard Piston Gauges.

The National Institute of Standards and Technology (NIST) has redefined its gas pressure scale, up to 17 MPa, based on two primary standard piston gauges. The primary standard piston gauges are 35.8 mm in diameter and operate from 20 kPa to 1 MPa.

A capacitive probe for measuring the clearance between the piston and the cylinder of a gas piston gauge.

We used a capacitive technique to determine the radial clearance between the piston and cylinder of a gas piston gauge. This method determines the effective area of a piston gauge pressure standard, independent of calibration against another piston gauge or manometer, as long as the diameter of the piston is dimensionally measured. It also allows an independent determination of piston gauge distortion due to pressure.

A Double-Primary Dead-Weight Tester for Pressures (35-175) kPa in Gage Mode.

Primary pressure standards in the atmospheric pressure range are often established using mercury manometers. Less frequently, controlled-clearance dead-weight testers in which one component (normally the piston) has been dimensionally measured have also been used. Recent advances in technology on two fronts i) the fabrication of large-diameter pistons and cylinders with good geometry; and ii) the ability to measure the dimensions of these components, have allowed some dead-weight testers at NIST to approach total relative uncertainties (k = 2) in dimensionally-derived effective areas near 5 × 10(-6).