Plants with genetically modified events combined by conventional breeding: an assessment of the need for additional regulatory data.

Crop varieties with multiple GM events combined by conventional breeding have become important in global agriculture. The regulatory requirements in different countries for such products vary considerably, placing an additional burden on regulatory agencies in countries where the submission of additional data is required and delaying the introduction of innovative products to meet agricultural needs. The process of conventional plant breeding has predictably provided safe food and feed products both historically and in the modern era of plant breeding.

Simplified pressure method for respirator fit testing.

A simplified pressure method has been developed for fit testing air-purifying respirators. In this method, the air-purifying cartridges are replaced by a pressure-sensing attachment and a valve. While wearers hold their breath, a small pump extracts air from the respirator cavity until a steady-state pressure is reached in 1 to 2 sec.

Identification of linear epitopes of the BPV-1 L1 protein recognized by sera of infected or immunized animals.

Sera from cattle that had been inoculated with BPV-1 virions or with recombinant L1 proteins and serum from a rabbit that had been immunized with SDS-denatured virions were evaluated for their reactivity with 466 overlapping synthetic peptides corresponding to 95% of the BPV-1 L1 protein. The late serological response of cattle to both intact virions and recombinant L1 proteins exhibited a similar profile of reactivity with approximately 70% (7 of 10) of L1 antigenic sites. However, the L1 serological response of the rabbit to SDS-denatured virions exhibited a significant difference from bovine serum antibodies in the profile of epitopes recognized, including a relative lack of response to major bovine epitopes located between L1 amino acids (AAs) 300-400.

Filter and leak penetration characteristics of a dust and mist filtering facepiece.

The filtering facepiece, also referred to as a disposable respirator, is an extensively used type of respirator without an officially accepted fit testing method. This study describes an aerosol generator and a sampling train, which have been developed for investigating the aerosol penetration characteristics through the filter element and the face seal. Electrostatic attraction and impaction are the two primary filtration mechanisms for micrometer- and supermicrometer-sized aerosols, respectively.