The Use of Graphite Micropowder in the Finish Turning of the Ti-6Al-4V Titanium Alloy Under Minimum Quantity Lubrication Conditions.

The use of the minimum quantity lubrication (MQL) method during machining leads to the reduced consumption of cooling and lubricating liquids, thus contributing to sustainable machining. To improve the properties of liquids used under MQL conditions, they are enriched with various types of micro- and nanoparticles. The purpose of this study was to investigate the effect of the addition of graphite micropowder (GMP) on tool life, cutting force components, and selected surface roughness parameters during the finish turning of the Ti-6Al-4V titanium alloy under MQL conditions.

Dimensional Accuracy After Precision Milling of Magnesium Alloys Using Coated and Uncoated Cutting Tools.

Magnesium alloys are an important group of materials that are used in many industries, primarily due to their low weight. Constantly increasing quality requirements make it necessary to improve the accuracy of manufactured products. In this study, the precision milling process for AZ91D and AZ31B magnesium alloys was investigated, and the results obtained with uncoated and TiB-coated end mills were compared.

The Influence of nc-AlCrTiN/α-BN Coatings on Increasing the Durability of WC/Co Cutting Inserts in the Inconel Alloy Machining Process.

Anti-wear coatings obtained through PVD methods may significantly increase the durability of cutting tools by impacting their wear mechanisms. This study presents and discusses the results of studies on the impact of the thermal conductivity of PVD coatings on the intensity of the built-up edge (BUE) and built-up layer (BUL) formation in Inconel 600 alloy machining processes. The authors determine the microstructure, phase structure, mechanical properties (hardness, Young's modulus, and adhesion), and thermal conductivity of different PVD coatings selected for the purpose of the study and varying in terms of conductivity-i.

Methodology of Chip Temperature Measurement and Safety Machining Assessment in Dry Rough Milling of Magnesium Alloys Using Different Helix Angle Tools.

This paper presents the methodology of measuring chip temperature in the cutting zone in the rough milling of magnesium alloys. Infrared measurements are taken to determine the effect of variable cutting speed, feed per tooth, and depth of cut on the maximum temperature of chips. Thermal images of chip temperature for a generated collective frame and corresponding histograms are presented.

[Surgical management of severe Peyronie's disease].

Peyronie's disease (lat. induratio penis plastica) is a process of the fibrotic plaques oand other localized fibrotic conditions have been considered to be the result of an abnormal size, pain and improved penile curvature. At early stages intralesional injections may decrease penile curvature and decrease plaque volume although the exact mechanism of action on Peyronie disease is unknown.