Polymer-Doped Molten Salt Mixtures as a New Concept for Electrolyte Systems in Dye-Sensitized Solar Cells.

A conceptually new polymer electrolyte for dye-sensitized solar cells is reported and investigated. The benefits of using this type of electrolyte based on ionic liquid mixtures (ILMs) and room temperature ionic liquids are highlighted. Impedance spectroscopy and transient electron measurements have been used to elucidate the background of the photovoltaic performance.

Microwave-enhanced electrochemical cycling performance of the LiNi0.2Mn1.8O4 spinel cathode material at elevated temperature.

The well-established poor electrochemical cycling performance of the LiMn2O4 (LMO) spinel cathode material for lithium-ion batteries at elevated temperature stems from the instability of the Mn(3+) concentration. In this work, a microwave-assisted solid-state reaction has been used to dope LMO with a very low amount of nickel (i.e.

Multiple-quantum spin counting in magic-angle-spinning NMR via low-power symmetry-based dipolar recoupling.

By using a symmetry-based R2(8)(1)R2(8)(-1) double-quantum (2Q) dipolar recoupling sequence, we demonstrate high-order multiple-quantum coherence (MQC) excitation at fast magic-angle spinning (MAS) frequencies up to 34 kHz. This scheme combines several attractive features, such as a relatively high dipolar scaling factor, good compensation to rf-errors, isotropic and anisotropic chemical shifts, as well as an ultra-low radio-frequency (rf) power requirement. The latter translates into nutation frequencies below 30 kHz for MAS rates up to 60 kHz, thereby permitting rf application for very long excitation periods without risk of damaging the NMR probehead or sample, while the compensation to chemical shifts improves as the MAS rate increases.

A quasi-liquid polymer-based cobalt redox mediator electrolyte for dye-sensitized solar cells.

Recently, cobalt redox electrolyte mediators have emerged as a promising alternative to the commonly used iodide/triiodide redox shuttle in dye-sensitized solar cells (DSCs). Here, we report the successful use of a new quasi-liquid, polymer-based electrolyte containing the Co(3+)/Co(2+) redox mediator in 3-methoxy propionitrile solvent in order to overcome the limitations of high cell resistance, low diffusion coefficient and rapid recombination losses. The performance of the solar cells containing the polymer based electrolytes increased by a factor of 1.