Hybrid absorption/interference wide-angle filter using PECVD Si-Rich SiN and SiO for LED lighting.

We propose a method to fabricate interference filters using Plasma Enhanced Chemical Vapor Deposition (PECVD) to reduce blue and near-infrared wavelengths that are inherent to LED lighting, but that have a negative impact on human health and the environment respectively. We developed a Si-rich silicon nitride (Si-rich SiN) material, with a very high refractive index, a high extinction coefficient in the blue range and a very low extinction coefficient in the rest of the spectrum. We combined this Si-rich SiN with silicon oxide (SiO) to realize an LED interference filter.

Tunable Emission Wavelength Stacked InAs/GaAs Quantum Dots by Chemical Beam Epitaxy for Optical Coherence Tomography.

We report on Chemical Beam Epitaxy (CBE) growth of wavelength tunable InAs/GaAs quantum dots (QD) based superluminescent diode's active layer suitable for Optical Coherence Tomography (OCT). The In-flush technique has been employed to fabricate QD with controllable heights, from 5 nm down to 2 nm, allowing a tunable emission band over 160 nm. The emission wavelength blueshift has been ensured by reducing both dots' height and composition.

Real-Time Microfluidic Blood-Counting System for PET and SPECT Preclinical Pharmacokinetic Studies.

Unlabelled: Small-animal nuclear imaging modalities have become essential tools in the development process of new drugs, diagnostic procedures, and therapies. Quantification of metabolic or physiologic parameters is based on pharmacokinetic modeling of radiotracer biodistribution, which requires the blood input function in addition to tissue images. Such measurements are challenging in small animals because of their small blood volume.

Tuneable four-wave mixing in AlGaAs nanowires.

We have experimentally demonstrated broadband tuneable four-wave mixing in AlGaAs nanowires with the widths ranging between 400 and 650 nm and lengths from 0 to 2 mm. We performed a detailed experimental study of the parameters influencing the FWM performance in these devices (experimental conditions and nanowire dimensions). The maximum signal-to-idler conversion range was 100 nm, limited by the tuning range of the pump source.

Precise localized thinning and vertical taper fabrication for silicon photonics using a modified local oxidation of silicon (LOCOS) fabrication process.

This paper presents a method to locally fine tune silicon-on-insulator (SOI) device layer thickness for the fabrication of optimal silicon photonics devices. Very precise control of thickness can be achieved with a modified local oxidation of silicon (LOCOS) process. The fabrication process is robust, complementary metal-oxide-semiconductor (CMOS) compatible and has the advantage of creating vertical tapers (~5.

Excimer laser induced quantum well intermixing: a reproducibility study of the process for fabrication of photonic integrated devices.

Excimer (ultraviolet) laser-induced quantum well intermixing (UV-Laser-QWI) is an attractive technique for wafer level post-growth processing and fabrication of a variety of monolithically integrated photonic devices. The results of UV-Laser-QWI employed for the fabrication of multibandgap III-V semiconductor wafers have demonstrated the attractive character of this approach although the process accuracy and reproducibility have remained relatively weakly covered in related literature. We report on a systematic investigation of the reproducibility of this process induced with a KrF excimer laser.

Characterization and reduction of spectral distortions in silicon-on-insulator integrated Bragg gratings.

A major issue in the fabrication of integrated Bragg grating filters in highly confined waveguides is the average effective index fluctuations caused by waveguide dimension variations. Lateral variations are caused by the sidewall roughness created during the etching process while vertical variations are coming from the wafer silicon layer thickness non-uniformity. Grating spectral distortions are known to result solely from the low spatial frequency components of these variations.

Optimal overlayer inspired by Photuris firefly improves light-extraction efficiency of existing light-emitting diodes.

In this paper the design, fabrication and characterization of a bioinspired overlayer deposited on a GaN LED is described. The purpose of this overlayer is to improve light extraction into air from the diode's high refractive-index active material. The layer design is inspired by the microstructure found in the firefly Photuris sp.

Blood compatible microfluidic system for pharmacokinetic studies in small animals.

New radiotracer developments for nuclear medicine imaging require the analysis of blood as a function of time in small animal models. A microfluidic device was developed to monitor the radioactivity concentration in the blood of rats and mice in real time. The microfluidic technology enables a large capture solid angle and a reduction in the separation distance between the sample and detector, thus increasing the detection efficiency.

Waveguide-coupled drop filters on SOI using quarter-wave shifted sidewalled grating resonators.

We report on the design, fabrication, and demonstration of waveguide coupled channel drop filters at 1550 nm, on a silicon-on-insulator (SOI) substrate. These devices rely on resonant power transfer from a bus waveguide to side-walled Bragg resonators with quarter-wave shifts in the middle. By employing a second mirror resonator, and a tap-off waveguide, reflections along the bus waveguide can be reduced, leading to realization of circulator-free resonance filters.

CMOS buried quad p-n junction photodetector for multi-wavelength analysis.

This paper presents a buried quad p-n junction (BQJ) photodetector fabricated with a HV (high-voltage) CMOS process. Multiple buried junction photodetectors are wavelength-sensitive devices developed for spectral analysis applications where a compact integrated solution is preferred over systems involving bulk optics or a spectrometer due to physical size limitations. The BQJ device presented here is designed for chip-based biochemical analyses using simultaneous fluorescence labeling of multiple analytes such as with advanced labs-on-chip or miniaturized photonics-based biosensors.

Extremely high aspect ratio GaAs and GaAs/AlGaAs nanowaveguides fabricated using chlorine ICP etching with N2-promoted passivation.

Semiconductor nanowaveguides are the key structure for light-guiding nanophotonics applications. Efficient guiding and confinement of single-mode light in these waveguides require high aspect ratio geometries. In these conditions, sidewall verticality becomes crucial.

Integrated active mixing and biosensing using surface acoustic waves (SAW) and surface plasmon resonance (SPR) on a common substrate.

This article presents a device incorporating surface plasmon resonance (SPR) sensing and surface acoustic wave (SAW) actuation integrated onto a common LiNbO(3) piezoelectric substrate. The device uses Rayleigh-type SAW to provide active microfluidic mixing in the fluid above the SPR sensor. Validation experiments show that SAW-induced microfluidic mixing results in accelerated binding kinetics of an avidin-biotin assay.

An integrated hybrid interference and absorption filter for fluorescence detection in lab-on-a-chip devices.

We present a hybrid optical filter design that combines interference and absorbing components for enhanced fluorescence detection in miniaturized highly-integrated lab-on-a-chip devices. The filter is designed in such a way that the advantages of each technology are used to offset the disadvantages of the other. The filter is fabricated with microfabrication compatible processes and materials for monolithic integration with microelectronics and microfluidics devices.

Surface Plasmon Resonance Monitoring of Cell Monolayer Integrity: Implication of Signaling Pathways Involved in Actin-Driven Morphological Remodeling.

Morphological changes occurring in individual cells largely influence the physiological functions of various cell layers. The control of barrier function of epithelia and endothelia is a prime example of processes highly dependent on cellular morphology and cell layer integrity. Here, we applied the surface plasmon resonance (SPR) technique to the quantification of cellular activity of an epithelial cell monolayer stimulated by angiotensin II.

Biosensing based on surface plasmon resonance and living cells.

We propose the combination of surface plasmon resonance (SPR) with living cells as a biosensing method. Our detection scheme is based on the premise that cellular activity induced by external agents is often associated with changes in cellular morphology, which in turn should lead to a variation of the effective refractive index at the interface between the cell membrane and the metal layer. We monitored surface plasmon resonance signals originating from a gold surface coated with cells on a custom apparatus after injection of various agents known to influence cellular activity and morphology.

Monitoring of native chemical ligation on solid substrate by surface plasmon resonance.

During the last years native chemical ligation (NCL) gained in popularity as a method allowing the chemical synthesis of large peptides and entire proteins. NCL is particularly well-suited for chemoselective and nondenaturing attachment of biomolecules on solid substrates. In the present work, we show the feasibility of monitoring of peptide synthesis, NCL and its catalysis on silicon oxide modified gold surfaces by surface plasmon resonance (SPR).

Single beam mapping of nonlinear phase shift profiles in planar waveguides with an embedded mirror.

We demonstrate a technique for a single shot mapping of nonlinear phase shift profiles in spatial solitons that are formed during short pulse propagation through one-dimensional slab AlGaAs waveguides, in the presence of a focusing Kerr nonlinearity. The technique uses a single beam and relies on the introduction of a lithographically etched reflective planar mirror surface positioned in proximity to the beam's input position. Using this setup we demonstrate nonlinearity-induced sharp lateral phase variations for certain initial conditions, and creation of higher spatial harmonics when the beam is in close proximity to the mirror.

Reprogrammable optical phase array.

A novel reprogrammable optical phase array (ROPA) device is presented as a reconfigurable electro-optic element. One specific application of the ROPA, a 1 x 6 electro-optic space switch, is fully described. Switching angles are within 2 degrees , and switching is achieved through a complementary metal-oxide semiconductor (CMOS) controlled, diffraction based, optical phase array in a bulk BaTiO3 crystal.

Bulk electro-optic deflector-based switches.

We propose two novel electro-optic (EO) deflectors based on two new nonrectangular geometries: the parabolic and the half-horn configurations. These devices not only provide excellent deflection angles, but also have the potential to build nonblocking 2 x 2 optical switches. A deflector figure of merit is defined, and comparisons with existing EO deflectors are given.

CASINO V2.42: a fast and easy-to-use modeling tool for scanning electron microscopy and microanalysis users.

Monte Carlo simulations have been widely used by microscopists for the last few decades. In the beginning it was a tedious and slow process, requiring a high level of computer skills from users and long computational times. Recent progress in the microelectronics industry now provides researchers with affordable desktop computers with clock rates greater than 3 GHz.

Optical modes at the interface between two dissimilar discrete meta-materials.

We have studied theoretically and experimentally the properties of optical surface modes at the hetero-interface between two meta-materials. These meta-materials consisted of two 1D AlGaAs waveguide arrays with different band structures.