Photodegradation applied to the treatment of phenol and derived substances catalyzed by TiO/BiPO and biological toxicity analysis.

For this work, a phenol solution model was treated by an advanced oxidation process (AOPs), using the heterogeneous catalyst TiO/BiPO and hydrogen peroxide combined with UVA for 240 min. An annular reactor containing a UVA lamp (80 W) was employed. A central composite rotacional design was developed employing a TiO/BiPO concentration of 87 mg L and a hydrogen peroxide concentration of 1800 mg L, being evaluated by the degradation percentage and phenol mineralization percentage as responses; 94.

Adsorption of azo dyes using peanut hull and orange peel: a comparative study.

This work proposes the use of agro-industrial wastes, specifically peanut hull (HP) and orange peel (OP), as adsorbents for dyes, such as Remazol Golden Yellow RNL-150% (RYG), Gray Reactive BF-2R (RG) and Reactive Turquoise Q-G125 (RT). Characterization by Brunauer-Emmett-Teller indicates that the adsorbents are mesoporous, with pHzpc values of 5.0 for HP and 4.

Nanoencapsulation of quercetin and resveratrol into elastic liposomes.

Based on the fact that quercetin (QUE) and resveratrol (RES) induce a synergic inhibition of the adipogenesis and increase apoptosis in adipocytes, and that sodium deoxycholate (SDC) has necrotic effects, the nanoencapsulation of QUE and RES into SDC-elastic liposomes is proposed as a new approach for dissolving the subcutaneous fat. The concentration of constituents and the effect of the drug incorporation into cyclodextrin inclusion complexes on the stability of QUE/RES-loaded liposomes were studied. The best liposomal formulation reduced the use of phosphatidylcholine and cholesterol in 17.

Physical-chemical parameters and validation of a colorimetric method for deoxycholic and ursodeoxycholic acids: kit reagent and optical sensor.

The simple and low cost β-cyclodextrin (β-CD)-phenolphthalein (PHP) inclusion complex was used for both the study of physical-chemical parameters and validation of analytical procedures for deoxycholic acid (DCA) and ursodeoxycholic acid (UDCA) determinations in different formulations. The usefulness of this inclusion complex is proposed either in the form of kit reagent and as an original optical sensor for DCA and UDCA. The results showed that temperature had a negative effect on the equilibrium constant resulting in high negative values of enthalpy and positive values of entropy.

Potential of a simplified measurement scheme and device structure for a low cost label-free point-of-care capacitive biosensor.

A simplified measurement scheme and device structure aiming at developing a low cost, label-free, point-of-care capacitive biosensor were investigated. The detection principle is the increase of low frequency capacitance between two planar Al electrodes observed after antibody-antigen interaction. The electrodes, deposited on oxidized Si wafers, were covered with an antibody layer, with and without using self-assembled thiol monolayer.

Simple determination of deoxycholic and ursodeoxycholic acids by phenolphthalein-beta-cyclodextrin inclusion complex.

An expeditious colorimetric methodology for the determination of the deoxycholic acid (DCA) and of the ursodeoxycholic acid (UDCA) in pharmaceutical formulations is reported. The method is based on their competitive complexation reaction with a color indicator to form beta-cyclodextrin-inclusion complexes. Several pH color indicators were tested, but phenolphthalein (PHP) showed the best interaction with the beta-cyclodextrin (beta-CD) with an inclusion yield higher than 95%.

Potassium permanganate oxidation of phenanthrene and pyrene in contaminated soils.

Potassium permanganate, widely used in water treatment, has shown its applicability to reduce PAH contamination in groundwater and soils. The first stage to design a treatment at the site scale is the feasibility study at the bench scale, generally performed by means of batch experiments. The aim of the present contribution was to investigate the influence of two factors on PAH degradation in spiked soils, following the method of factorial designs.

A flow-batch internal standard procedure for iron determination in hydrated ethanol fuel by flame atomic absorption spectrometry.

A flow-batch manifold coupled to a flame atomic absorption spectrometer was evaluated to assess the iron content by the internal standard method in hydrated ethanol used as fuel in automotive industry. For this assessment official methods require calibration procedures with matrix matching, making it difficult to obtain accurate results for samples adulterated by the addition of water. Nickel was selected as the internal standard since it is usually absent in samples and because it requires similar conditions of atomization.

Sequential injection analysis of chloride and nitrate in waters with improved accuracy using potentiometric detection.

Accurate simultaneous analysis of different anionic species using ion-selective electrodes (ISEs) can be achieved even for non-specific sensors by resorting to an ordinary least squares multiple regression in the vicinity of the predicted concentrations. In this work the potentialities of this approach are evidenced by the determination of nitrate and chloride in synthetic and real water samples in which chloride concentration was significantly higher than nitrate. An AgCl/Ag(2)S electrode based on a homogeneous crystalline membrane together with a PVC electrode based on tert-octylammonium bromide dissolved in dibutylphthalate were used as potentiometric detectors for chloride and nitrate, respectively.

Phenanthrene and pyrene oxidation in contaminated soils using Fenton's reagent.

Fenton's reagent has shown its applicability to oxidizing these biorefractory organic contaminants. The purpose of this contribution was to investigate the influence of operating parameters on the process efficiency for soil highly contaminated by PAHs. Five variables were selected: pH, reaction time, UV irradiation, hydrogen peroxide concentration and Fe (II) amendment.

Extraction and recovery of chromium from electroplating sludge.

This work reports a study of the extraction and recovery of chromium from the wastes (class I dangerous) generated by a galvanic manufacturer. Commercial HCl at room temperature was employed, and the conditions of the extraction process were optimized according to a sequential experimental design, which also included the acid concentration and contact time as variables. The best extraction conditions (80% v/v; 30 min; 97.

Silicone sensing phase for detection of aromatic hydrocarbons in water employing near-infrared spectroscopy.

The use of silicone for detection of aromatic hydrocarbons in water using near-infrared spectroscopy is proposed. A sensing phase of poly(dimethylsiloxane) (PDMS) was prepared, and a rod of this material was adapted to a transflectance probe for measurements from 850 to 1800 nm. Deionized water samples contaminated separately with known amounts of benzene, toluene, ethylbenzene, and m-xylene were used for evaluation of the PDMS sensing phase, and measurements were made in a closed reactor with constant stirring.

Flow-injection amperometric determination of dopamine in pharmaceuticals using a polyphenol oxidase biosensor obtained from soursop pulp.

The amperometric determination of dopamine (Do) in pharmaceuticals formulations by flow injection analysis (FIA) is proposed. An enzymatically modified carbon paste electrode constituted by 25% (w/w) of polyphenol oxidase obtained from Annona muricata L. tissue, 30% (w/w) of graphite, 30% (w/w) of silicone and 15% (w/w) of 7,7,8,8 tetracyanoquinodimethane (TCNQ), was used as flow-through detector.

Simple and inexpensive flow L-glutamate determination using pumpkin tissue.

This work refers to a very easy to implementate flow injection system with potentiometric detection for l-glutamate determination in food samples. The proposed procedure is based on measurement of carbon dioxide produced by decarboxylation of l-glutamate catalyzed by l-glutamate decarboxylase (E.C.

Determination of dipyrone in pharmaceutical products by flow injection analysis with potentiometric detection.

This work describes an FIA potentiometric procedure for the quantification of dipyrone in pharmaceutical products. For the detector, a tubular electrode comprising a polymeric membrane containing tetraoctylammonium as an electroactive material (5% w/w), dibutylphtalate as a mediator solvent (65% w/w) and PVC (30% w/w) directly applied above a graphite conductor support was used. This unit was incorporated into a monochannel FI-system with a 0.