Detection of Prompt Gamma Radiation Near the LVR-15 Research Reactor.

The paper describes a method of pulse height spectrum measurement in a wide energy range. The LVR‑15 research reactor building was chosen to demonstrate this method. Pulse height spectra were measured on the third floor of the reactor building.

The influence of core power distribution on neutron flux density behind a pressure vessel of a VVER-1000 Mock Up in LR-0 reactor.

The neutron flux distribution behind a reactor pressure vessel (RPV) is an important parameter that is monitored to determine neutron fluence in the RPV. Together with mechanical testing of surveillance specimens, these are the most important parts of in-service inspection programs that are essential for a realistic and reliable assessment of the RPV residual lifetime. The fast neutron fluence values are determined by a calculation.

Study of suitability of Fricke-gel-layer dosimeters for in-air measurements to characterise epithermal/thermal neutron beams for NCT.

The reliability of Fricke gel dosimeters in form of layers for measurements aimed at the characterization of epithermal neutron beams has been studied. By means of dosimeters of different isotopic composition (standard, containing (10)B or prepared with heavy water) placed against the collimator exit, the spatial distribution of gamma and fast neutron doses and of thermal neutron fluence are attained. In order to investigate the accuracy of the results obtained with in-air measurements, suitable MC simulations have been developed and experimental measurements have been performed utilizing Fricke gel dosimeters, thermoluminescence detectors and activation foils.

Measurements of gamma dose and thermal neutron fluence in phantoms exposed to a BNCT epithermal beam with TLD-700.

Gamma dose and thermal neutron fluence in a phantom exposed to an epithermal neutron beam for boron neutron capture therapy (BNCT) can be measured by means of a single thermoluminescence dosemeter (TLD-700). The method exploits the shape of the glow curve (GC) and requires the gamma-calibration GC (to obtain gamma dose) and the thermal-neutron-calibration GC (to obtain neutron fluence). The method is applicable for BNCT dosimetry in case of epithermal neutron beams from a reactor because, in most irradiation configurations, thermal neutrons give a not negligible contribution to the TLD-700 GC.

Methods for dose measurements in small phantoms irradiated at BNCT epithermal column.

Suitable dosimeter methods have been proposed and tested, to measure the different dose contributions in small phantoms exposed to epithermal/thermal neutron beams designed for BNCT. One method is based on Fricke-gel dosimeter in small tubes of 2.8mm of external diameter, that allow determining profiles of gamma dose and of boron dose.