The management and treatment of long bone defects are challenging clinical problems. In this study, in order to address the need for load bearing segmental defects, 3D printed cylindrical implants of poly(-caprolactone) (PCL) and nanohydroxyapatite (nHAp) composites were prepared and applied as lateral segments to the femurs of New Zealand white rabbits. The results obtained after 6 weeks of implantation were compared with the autografts.
View Article and Find Full Text PDFACS Biomater Sci Eng
July 2024
Mg-based biodegradable metallic implants are gaining increased attraction for applications in orthopedics and dentistry. However, their current applications are hampered by their high rate of corrosion, degradation, and rapid release of ions and gas bubbles into the physiological medium. The aim of the present study is to investigate the osteogenic and angiogenic potential of coated Mg-based implants in a sheep cranial defect model.
View Article and Find Full Text PDFAdvances in the development of vascular substitutes for small-sized arteries are ongoing because the present grafts do not entirely meet the requirements of native equivalents and are suboptimal in clinical performance. This study aims to develop a tri-layered vascular construct mimicking natural tissue using polyester blends and to investigate its endothelization through in vitro studies as a potential small-caliber vascular graft. The innermost layer is obtained by dip coating as a tubular porous film with a lumen diameter of 3 mm and a pore size of ≤8 µm.
View Article and Find Full Text PDFRespiratory infections caused by coronaviruses (CoVs) have become a major public health concern in the past two decades as revealed by the emergence of SARS-CoV in 2002, MERS-CoV in 2012, and SARS-CoV-2 in 2019. The most severe clinical phenotypes commonly arise from exacerbation of immune response following the infection of alveolar epithelial cells localized at the pulmonary blood-air barrier. Preclinical rodent models do not adequately represent the essential genetic properties of the barrier, thus necessitating the use of humanized transgenic models.
View Article and Find Full Text PDFOsteochondral tissue regeneration is quite difficult to achieve due to the complexity of its organization. In the design of these complex multilayer structures, a fabrication method, 3D printing, started to be employed, especially by using extrusion, stereolithography and inkjet printing approaches. In this paper, the designs are discussed including biphasic, triphasic, and gradient structures which aim to mimic the cartilage and the calcified cartilage and the whole osteochondral tissue closely.
View Article and Find Full Text PDF