The performance of all active photonic devices today is greatly limited by loss. Here, we show that one can engineer a low loss path in a metal-clad lossy multi-mode waveguide while simultaneously achieving high-performance active photonic devices. We leverage non-Hermitian systems operating beyond the exceptional point to enable the redistribution of losses in a multi-mode photonic waveguide.
View Article and Find Full Text PDFTotal internal reflection (TIR) governs the guiding mechanisms of almost all dielectric waveguides and therefore constrains most of the light in the material with the highest refractive index. The few options available to access the properties of lower-index materials include designs that are either lossy, periodic, exhibit limited optical bandwidth or are restricted to subwavelength modal volumes. Here, we propose and demonstrate a guiding mechanism that leverages symmetry in multilayer dielectric waveguides as well as evanescent fields to strongly confine light in low-index materials.
View Article and Find Full Text PDFPerturbations to the effective refractive index from nanometer-scale fabrication variations in waveguide geometry plague high index-contrast photonic platforms; this includes the ubiquitous sub-micron silicon-on-insulator (SOI) process. Such variations are particularly troublesome for phase-sensitive devices, such as interferometers and resonators, which exhibit drastic changes in performance as a result of these fabrication-induced phase errors. In this Letter, we propose and experimentally demonstrate a design methodology for dramatically reducing device sensitivity to silicon width variations.
View Article and Find Full Text PDFThe mass production and commercialization of integrated photonics have been slowed down by the high cost of packaging its optical interfaces. We show a plug-and-play connector between a fiber and a nanophotonic waveguide consisting of a 3D polymer structure with a fiber entrance port that simultaneously achieves mechanical and optical passive alignment with tolerance beyond ±10 μm to the fiber input position. We take advantage of a mechanical and optical co-design, analogous to commercial fiber-to-fiber connectors.
View Article and Find Full Text PDFWe demonstrate the generation of an octave-spanning supercontinuum in InGaP membrane waveguides on a silicon substrate pumped by a 1550-nm femtosecond source. The broadband nature of the supercontinuum in these dispersion-engineered high-index-contrast waveguides is enabled by dispersive wave generation on both sides of the pump as well as by the low nonlinear losses inherent to the material. We also measure the coherence properties of the output spectra close to the pump wavelength and find that the supercontinuum is highly coherent at least in this wavelength range.
View Article and Find Full Text PDFWe propose high index contrast InGaP photonic wires as a platform for the integration of nonlinear optical functions in the telecom wavelength window. We characterize the linear and nonlinear properties of these waveguide structures. Waveguides with a linear loss of 12 dB/cm and which are coupled to a single mode fiber through gratings with a -7.
View Article and Find Full Text PDFWe experimentally and numerically study dispersive wave emission, soliton fission, and supercontinuum generation in a silicon wire at telecommunication wavelengths. Through dispersion engineering, we experimentally confirm a previously reported numerical study and show that the emission of resonant radiation from the solitons can lead to the generation of a supercontinuum spanning over 500 nm. An excellent agreement with numerical simulations is observed.
View Article and Find Full Text PDFA 1,000 nm wide supercontinuum, spanning from 1470 nm in the telecom band to 2470 nm in the mid-infrared is demonstrated in a 800 nm x 220 nm 1 cm long hydrogenated amorphous silicon strip waveguide. The pump source was a picosecond Thulium doped fiber laser centered at 1950 nm. The real part of the nonlinear parameter of this waveguide at 1950 nm is measured to be 100 ± 10 W -1m-1, while the imaginary part of the nonlinear parameter is measured to be 1.
View Article and Find Full Text PDFWe demonstrate the measurement and tuning of second-to-fourth order dispersion of a silicon wire waveguide in a spectral region of low nonlinear losses. Using white light interferometry we extract the chromatic dispersion of our waveguide from 1950 to 2300 nm. Moreover we demonstrate tuning of the zero dispersion wavelength over more than 100 nm, pushing it to longer wavelength by partially underetching the waveguide.
View Article and Find Full Text PDF