A Sensitive Visible Light Photodetector Using Cobalt-Doped Zinc Ferrite Oxide Thin Films.

In this study, a highly sensitive trilayer photodetector using Co-doped ZnFeO thin films annealed at 400 °C was synthesized successfully. Trilayer-photodetector devices with a film stack of 5 at % Co-doped-zinc-ferrite-thin-film/indium-tin-oxide on p-Si substrates were fabricated by radio-frequency sputtering. The absorbance spectra, photoluminescence spectra, transmission electron microscopy images, and - characteristics under various conditions were comprehensively investigated.

Investigation on the Voltage Hysteresis of MnO for Lithium-Ion Battery Applications.

In lithium-ion batteries (LIBs), conversion-based electrodes such as transition-metal oxides and sulfides exhibit promising characteristics including high capacity and long cycle life. However, the main challenge for conversion electrodes to be industrialized remains on voltage hysteresis. In this study, MnO powder was used as an anode material for LIBs to investigate the root cause of the hysteresis.

Stable water layers on solid surfaces.

Liquid layers adhered to solid surfaces and that are in equilibrium with the vapor phase are common in printing, coating, and washing processes as well as in alveoli in lungs and in stomata in leaves. For such a liquid layer in equilibrium with the vapor it faces, it has been generally believed that, aside from liquid lumps, only a very thin layer of the liquid, i.e.

Direct-growth carbon nanotubes on 3D structural microelectrodes for electrophysiological recording.

A novel 3D carbon nanotube (CNT) microelectrode was developed through direct growth of CNTs on a gold pin-shaped 3D microelectrode at a low temperature (400 °C) for applications in neural and cardiac recording. With an electroplated Ni catalyst layer covering the entire surface of the pin-shaped structure, CNTs were synthesized on a 3D microelectrode by catalytic thermal chemical vapor deposition (CVD). According to the analyses by electrochemical impedance spectroscopy, the impedance of 3D microelectrodes after CNT growth and UV/O3 treatment decreased from 9.

Direct-Writing of Cu Nano-Patterns with an Electron Beam.

We demonstrate direct electron beam writing of a nano-scale Cu pattern on a surface with a thin aqueous layer of CuSO4 solution. Electron beams are highly maneuverable down to nano-scales. Aqueous solutions facilitate a plentiful metal ion supply for practical industrial applications, which may require continued reliable writing of sophisticated patterns.

Non-stoichiometric W(18)O(49-x)S(x) nanowires for wide spectrum photosensors with high internal gain.

This study reports successful synthesis of non-stoichiometric single-crystal W18O49-xSx nanowires for photosensors with a high absorption rate (>83%) across a wide spectrum (300-2000 nm), a high internal gain (G = 10(6)-10(7)) and a relatively fast response time (approximately 1-3 s). In addition, the correlation between the photoconductivity gain (G) and the surface-to-volume ratio of non-stoichiometric single-crystal W18O49-xSx nanowires was studied. The surface-to-volume ratio and non-stoichiometric material of W18O49-xSx contributed to the photoconductivity gain; hence, the nanowires are favorable for photosensor devices.

Enhancement of the stability of electron field emission behavior and the related microplasma devices of carbon nanotubes by coating diamond films.

The enhanced lifetime stability for the carbon nanotubes (CNTs) by coating hybrid granular structured diamond (HiD) films on Au-decorated CNTs/Si using a two-step microwave plasma enhanced chemical vapor deposition process was reported. Electron field emission (EFE) properties of HiD/Au/CNTs emitters show a low turn-on field (E0) of 3.50 V/μm and a high emission current density (Je) of 0.

Carbon nanotubes for highly sensitive colorimetric immunoassay biosensor.

A colorimetric immunoassay biosensor is developed employing CNTs as a label material, which allowed direct observation of the sensing result by the naked eye. Implemented for HSA, the detection limit is 3 × 10 mg ml when characterized using UV-Vis.

Liver-cell patterning lab chip: mimicking the morphology of liver lobule tissue.

A lobule-mimetic cell-patterning technique for on-chip reconstruction of centimetre-scale liver tissue of heterogeneous hepatic and endothelial cells via an enhanced field-induced dielectrophoresis (DEP) trap is demonstrated and reported. By mimicking the basic morphology of liver tissue, the classic hepatic lobule, the lobule-mimetic-stellate-electrodes array was designed for cell patterning. Through DEP manipulation, well-defined and enhanced spatial electric field gradients were created for in-parallel manipulation of massive individual cells.

Flexible direct-growth CNT biosensors.

A biosensor was fabricated by growing carbon nanotubes (CNTs) directly on a polyimide flexible substrate at low temperatures (≤400 °C). A biocompatible polymer (poly(para-xylylene), parylene) was subsequently coated on the surface without CNTs as an insulator for future applications of flexible biosensors in in vivo sensing. The feasibility of the CNT flexible biosensor was demonstrated by quantitatively detecting human serum albumin (HSA).

Quantitative characterization of nanoparticles in blood by transmission electron microscopy with a window-type microchip nanopipet.

Transmission electron microscopy (TEM) is a unique and powerful tool for observation of nanoparticles. However, due to the uneven spatial distribution of particles conventionally dried on copper grids, TEM is rarely employed to evaluate the spatial distribution of nanoparticles in aqueous solutions. Here, we present a microchip nanopipet with a narrow chamber width for sorting nanoparticles from blood and preventing the aggregation of the particles during the drying process, enabling quantitative analysis of their aggregation/agglomeration states and the particle concentration in aqueous solutions.

Identification of protein domains on major pilin MrkA that affects the mechanical properties of Klebsiella pneumoniae type 3 fimbriae.

The Klebsiella pneumoniae type 3 fimbriae are mainly composed of MrkA pilins that assemble into a helixlike filament. This study determined the biomechanical properties of the fimbriae and analyzed 11 site-directed MrkA mutants to identify domains that are critical for the properties. Escherichia coli strains expressing type 3 fimbriae with an Ala substitution at either F34, V45, C87, G189, T196, or Y197 resulted in a significant reduction in biofilm formation.

Crystallization kinetics of amorphous Ga-Sb films extended for phase-change memory.

Performance of phase-change materials based on Ga-Te-Sb was found getting better with decreasing Te content in our earlier studies. We concerned much properties of Te-free, Sb-rich binary Ga-Sb, which has been known to possess extremely fast crystallization behavior. Non-isothermal and isothermal crystallization kinetics of amorphous Sb-rich Ga-Sb films were explored by temperature dependent electrical resistance measurements.

A quantum dot-based optical immunosensor for human serum albumin detection.

In this study, a CdSe/ZnS quantum dot (QD)-based immunosensor using a simple optical system for human serum albumin (HSA) detection is developed. Monoclonal anti-HSA (AHSA) immobilized on 3-aminopropyltriethoxysilane (APTES)-modified glass was used to capture HSA specifically. Bovine serum albumin (BSA) was used to block non-specific sites.

Electrical impedimetric biosensors for liver function detection.

In this study, electrical impedimetric biosensors composed of Au-electrodes were fabricated for the quantitative detection of human serum albumin (HSA), an essential biomarker of liver function. The Au-electrodes were fabricated via a single-step photolithography process, and can be easily integrated in biochips for assessing liver function in the future. The glass sensing surface between two adjacent Au-electrodes was modified with 3-aminopropyltriethoxysilane (APTES) to improve the biocompatibility for its subsequent binding to anti-human serum albumin (AHSA).

The enhancement of neural growth by amino-functionalization on carbon nanotubes as a neural electrode.

This paper reports the success of amino-functionalization on multi-walled carbon nanotubes (MWCNTs) to promote neuronal cells growth on MWCNT electrode for extracellular recording, attributed to the formation of positive charge of NH(2) molecules on their surfaces. Besides, the surface of MWCNT electrode becomes hydrophilic after amino-functionalization (AF-MWCNTs) which can enhance electrical conductivity because of lower MWCNT/electrolyte interfacial impedance and higher interfacial capacitance. Durability tests show that electrical characteristics of the MWCNTs treated by 2 wt% 1,4-diaminobutane solution (2 wt%-AF-MWCNTs) can last for at least six months in air ambient.

An active, flexible carbon nanotube microelectrode array for recording electrocorticograms.

A variety of microelectrode arrays (MEAs) has been developed for monitoring intra-cortical neural activity at a high spatio-temporal resolution, opening a promising future for brain research and neural prostheses. However, most MEAs are based on metal electrodes on rigid substrates, and the intra-cortical implantation normally causes neural damage and immune responses that impede long-term recordings. This communication presents a flexible, carbon-nanotube MEA (CMEA) with integrated circuitry.

A three-dimensional flexible microprobe array for neural recording assembled through electrostatic actuation.

We designed, fabricated and tested a novel three-dimensional flexible microprobe to record neural signals of a lateral giant nerve fiber of the escape circuit of an American crayfish. An electrostatic actuation folded planar probes into three-dimensional neural probes with arbitrary orientations for neuroscientific applications. A batch assembly based on electrostatic forces simplified the fabrication and was non-toxic.

Hydrophilic modification of neural microelectrode arrays based on multi-walled carbon nanotubes.

To decrease the impedance of microelectrode arrays, for neuroscience applications we have fabricated and tested MEA based on multi-walled carbon nanotubes. With decreasing physical size of a microelectrode, its impedance increases and charge-transfer capability decreases. To decrease the impedance, the effective surface area of the electrode must generally be increased.

A solution-processed air-stable perylene diimide derivative for N-type organic thin film transistors.

For future all-soluble organic thin film transistor (OTFT) applications, a new soluble n-type air-stable perylene diimide derivative semiconductor material with (trifluoromethyl)benzyl groups (TC-PDI-F) is synthesized. The film is formed by spin-coating in air and optimized for OTFT fabrications. The transistor characteristics and air-stability of the TC-PDI-F OTFTs is measured to investigate the feasibility of using solution-processed TC-PDI-F for future OTFT applications.

A cone-shaped 3D carbon nanotube probe for neural recording.

A novel cone-shaped 3D carbon nanotube (CNT) probe is proposed as an electrode for applications in neural recording. The electrode consists of CNTs synthesized on the cone-shaped Si (cs-Si) tip by catalytic thermal chemical vapor deposition (CVD). This probe exhibits a larger CNT surface area with the same footprint area and higher spatial resolution of neural recording compared to planar-type CNT electrodes.

Interfacing neurons both extracellularly and intracellularly using carbon-nanotube probes with long-term endurance.

This study demonstrates that carbon nanotubes (CNTs) can be fabricated into probes directly, with which neural activity can be monitored and elicited not only extracellularly but also intracellularly. Two types of CNT probes have been made and examined with the escape neural circuit of crayfish, Procambarus clarkia. The CNT probes are demonstrated to have comparable performance to conventional Ag/AgCl (silver/silver cloride) electrodes.

Surface rigidity change of Escherichia coli after filamentous bacteriophage infection.

In this study, the feasibility using atomic force microscopy (AFM) to study the interaction between bacteriophages (phages) and bacteria in situ was demonstrated here. Filamentous phage M13 specifically infects the male Escherichia coli, which expresses F-pili. After infection, E.