Demonstration of stable, long-term operation of a nanosecond pulsed DPSSL at 10 J, 100 Hz.

We report on stable, long-term operation of a diode-pumped solid-state laser (DPSSL) amplifying 15 ns pulses at 1029.5 nm wavelength to 10 J energy at 100 Hz pulse rate, corresponding to 1 kW average power, with 25.4% optical-to-optical efficiency.

Improved stability second harmonic conversion of a diode-pumped Yb:YAG laser at the 0.5 kW level.

We report on efficient and stable, type-I phase-matched second harmonic conversion of a nanosecond high-energy, diode-pumped, Yb:YAG laser. With a frequency-doubling crystal in an enclosed, temperature controller with optical windows, 0.5% energy stability was achieved for approximately half an hour.

Faraday isolator for a 100 J/10 Hz pulsed laser.

We report the first-ever, to the best of our knowledge, demonstration of the optical isolation of a kilowatt average power pulsed laser. A Faraday isolator capable of stable protection of the laser amplifier chain delivering 100 J nanosecond laser pulses at the repetition rate of 10 Hz has been developed and successfully tested. The isolator provided an isolation ratio of 30.

Thermal-stress-induced birefringence management of complex laser systems by means of polarimetry.

The novel method of the thermally-induced polarization changes driven power losses (TIPCL) analysis in the complex laser systems has been developed. The measurement has been tested on the amplifier chain of the 100 J / 10 Hz laser system 'Bivoj' operated at HiLASE Centre. By the usage of the measured non-uniform Mueller matrix of the amplifier chain, the optimization of the ideal input and output polarization state has been calculated numerically.

Adaptive optics system for a short wavelength mid-IR laser based on a Shack-Hartmann wavefront sensor and analysis of thermal noise impacts.

We present an adaptive optics (AO) system for a 1.94-µm laser source. Our system consists of a home-made Shack-Hartmann wavefront sensor and silver-coated bimorph deformable mirror operating in a closed-loop control scheme.

Investigation of the lasing performance of a crystalline-coated Yb:YAG thin-disk directly bonded onto a silicon carbide heatsink.

We investigated the use of crystalline coatings as the highly reflective coating of an Yb:YAG thin disk directly bonded onto a silicon carbide heatsink. Compared to commonly used ion-beam-sputtered coatings, it possesses lower optical losses and higher thermal conductivity, resulting in better heat management and laser outputs. We pumped the disk up to 1.

150 J DPSSL operating at 1.5 kW level.

We report on obtaining output energy of 146 J in 10 ns long pulses at 10 Hz repetition rate from Bivoj, a multi-Joule multi-slab cryogenic gas-cooled diode pumped solid state laser, by overcoming its damage threshold bottleneck. This is a 40% energy and power increase of the laser system in comparison to our previous publication and to the most powerful multi-Joule high power laser system.

Towards Rapid Fabrication of Superhydrophobic Surfaces by Multi-Beam Nanostructuring with 40,401 Beams.

Superhydrophobic surfaces attract a lot of attention due to many potential applications including anti-icing, anti-corrosion, self-cleaning or drag-reduction surfaces. Despite a list of attractive applications of superhydrophobic surfaces and demonstrated capability of lasers to produce them, the speed of laser micro and nanostructuring is still low with respect to many industry standards. Up-to-now, most promising multi-beam solutions can improve processing speed a hundred to a thousand times.

Compact, diode-pumped, unstable cavity Yb:YAG laser and its application in laser shock peening.

We present the setup of a compact, q-switched, cryogenically cooled Yb:YAG laser, which is capable of producing over 1 J output energy in a 10 ns pulse at 10 Hz. The system's design is based on the recently published unstable cavity layout with gain shaping of the spatial intra-cavity intensity distribution. Using a hexagonal homogenized pump beam, the laser generated an according hexagonal output beam profile.

Anti-Reflection Nanostructures on Tempered Glass by Dynamic Beam Shaping.

Reflectivity and surface topography of tempered glass were modified without any thermal damage to the surroundings by utilizing 1.7 ps ultrashort pulsed laser on its fundamental wavelength of 1030 nm. To speed up the fabrication, a dynamic beam shaping unit combined with a galvanometer scanning head was applied to divide the initial laser beam into a matrix of beamlets with adjustable beamlets number and separation distance.

Faraday Rotation of DyO, CeF and YFeO at the Mid-Infrared Wavelengths.

The relatively narrow choice of magneto-active materials that could be used to construct Faraday devices (such as rotators or isolators) for the mid-infrared wavelengths arguably represents a pressing issue that is currently limiting the development of the mid-infrared lasers. Furthermore, the knowledge of the magneto-optical properties of the yet-reported mid-infrared magneto-active materials is usually restricted to a single wavelength only. To address this issue, we have dedicated this work to a comprehensive investigation of the magneto-optical properties of both the emerging (Dy2O3 ceramics and CeF3 crystal) and established (Y3Fe5O12 crystal) mid-infrared magneto-active materials.

Large-Beam Picosecond Interference Patterning of Metallic Substrates.

In this paper, we introduce a method to efficiently use a high-energy pulsed 1.7 ps HiLASE Perla laser system for two beam interference patterning. The newly developed method of large-beam interference patterning permits the production of micro and sub-micron sized features on a treated surface with increased processing throughputs by enlarging the interference area.

Spectroscopy and diode-pumped laser operation of transparent Tm:LuAlO ceramics produced by solid-state sintering.

A transparent Tm:LuAlO ceramic is fabricated by solid-state reactive sintering at 1830 °C for 30 h using commercial α-AlO and LuO/TmO powders and sintering aids - MgO and TEOS. The ceramic belongs to the cubic system and exhibits a close-packed structure (mean grain size: 21 µm). The in-line transmission at ∼1 µm is 82.

Experimental study on compression of 216-W laser pulses below 2 ps at 1030 nm with chirped volume Bragg grating.

We report on the characterization of a high-power, chirped volume Bragg grating (CVBG) pulse compressor. It includes measurements of the CVBG's diffraction efficiency, beam profile, beam quality ( parameter), pulse spectrum, the CVBG's temperature, and the thermal lens. These parameters were monitored for a wide range of input laser powers and with different clamping forces applied on the CVBG.

Laser-induced crystallization of anodic TiO nanotube layers.

In this study, crystallization of amorphous TiO nanotube (TNT) layers upon optimized laser annealing is shown. The resulting anatase TNT layers do not show any signs of deformation or melting. The crystallinity of the laser annealed TNT layers was investigated using X-ray diffraction, Raman spectroscopy, and high-resolution transmission electron microscopy (HRTEM).

Verdet constant of potassium terbium fluoride crystal as a function of wavelength and temperature.

Potassium terbium fluoride (KTF) crystal is a promising magneto-active material for creating multi-kilowatt average-power Faraday isolators operating at the visible and near-infrared wavelengths. Nevertheless, the key material's parameter needed for the design of any Faraday isolator-the Verdet constant, has not been comprehensively investigated yet. In this Letter, we report on measurement of the Verdet constant of the KTF crystal for wavelengths between 600 and 1500 nm and for temperatures ranging from 15 to 295 K.

New observations on DUV radiation at 257 nm and 206 nm produced by a picosecond diode pumped thin-disk laser.

We report new observations on picosecond deep ultraviolet coherent beams generated in a CLBO as the fourth and fifth harmonics of a diode pumped high average power Yb:YAG thin disk laser operating at 77 kHz repetition rate at 1030 nm. The effects of the two-photon absorption were observed, e.g.

Novel unstable resonator configuration for highly efficient cryogenically cooled Yb:YAG Q-switched laser.

A novel method to shape the intensity distribution within an unstable laser cavity is demonstrated. This method is characterized by inscribing a tailored gain profile generated by a spatially tophat-shaped longitudinal pump beam into the gain medium. The mode shaping mechanism is still effective with zero output coupling.

High power picosecond parametric mid-IR source tunable between 1.7 and 2.6 μm.

A high-average-power wavelength-tunable picosecond mid-IR source based on parametric downconversion has been developed. The conversion system consists of two stages, optical parametric generator and optical parametric amplifier (OPA), which are pumped by an Yb:YAG thin-disk laser operated at 77 kHz repetition rate, 1030 nm wavelength, and pulse duration down to 1.3 ps.

Passive Q switching of Yb:CNGS lasers by Cr:YAG and V:YAG saturable absorbers.

Trigonal langasite-type ordered silicate crystal : (Yb:CNGS) is a promising material for efficient ∼1   lasers. We report on the first passively -switched Yb:CNGS laser using : and : saturable absorbers (SAs) with a 976 nm volume-Bragg-grating-stabilized diode as a pump source. The laser crystal was a cut 3 at.

Femtosecond 8.5 μm source based on intrapulse difference-frequency generation of 2.1 μm pulses.

We report on a femtosecond ∼8.5  μm, ∼2  μJ source based on the intrapulse difference-frequency generation (DFG) of 2.1 μm pulses in an AgGaSe (AGSe) crystal.

Efficient diode-pumped Er:KLu(WO) laser at ∼1.61 μm.

We report on an efficient diode-pumped continuous-wave erbium-doped monoclinic double tungstate laser. It is based on a 1 at. % Er:KLu(WO) (Er:KLuW) crystal cut along the N optical indicatrix axis.