Electronic and Geometric Structures of Rechargeable Lithium Manganese Sulfate LiMn(SO) Cathode.

Here, we report the use of LiMn(SO) as a potential energy storage material and describe its route of synthesis and structural characterization over one electrochemical cycle. LiMn(SO) is synthesized by ball milling of MnSO·HO and LiSO·HO and characterized using a suite of techniques, in particular, ex situ X-ray diffraction, X-ray photoelectron spectroscopy, and X-ray absorption spectroscopy on the Mn and S K-edges to investigate the electronic and local geometry around the absorbing atoms. The prepared LiMn(SO) electrodes undergo electrochemical cycles to different potential points on the charge-discharge curve and are then extracted from the cells at these points for ex situ structural analysis.

Crystal Chemistry and Antibacterial Properties of Cupriferous Hydroxyapatite.

Copper-doped hydroxyapatite (HA) of nominal composition Ca(PO)[Cu(OH)O] (0.0 ≤ x ≤ 0.8) was prepared by solid-state and wet chemical processing to explore the impact of the synthesis route and mode of crystal chemical incorporation of copper on the antibacterial efficacy against () and () strains.

Phase Transitions of Formamidinium Lead Iodide Perovskite under Pressure.

The pressure-induced structural evolution of formamidinium-based perovskite FAPbI was investigated using in situ synchrotron X-ray diffraction and laser-excited photoluminescence methods. Cubic α-FAPbI ( Pm3̅ m) partially and irreversibly transformed to hexagonal δ-FAPbI ( P6 mc) at a pressure less than 0.1 GPa.

Hybrid Nanomaterials with Single-Site Catalysts by Spatially Controllable Immobilization of Nickel Complexes via Photoclick Chemistry for Alkene Epoxidation.

Catalyst deactivation is a persistent problem not only for the scientific community but also in industry. Isolated single-site heterogeneous catalysts have shown great promise to overcome these problems. Here, a versatile anchoring strategy for molecular complex immobilization on a broad range of semiconducting or insulating metal oxide ( e.

Spinel CoO nanomaterials for efficient and stable large area carbon-based printed perovskite solar cells.

Carbon based perovskite solar cells (PSCs) are fabricated through easily scalable screen printing techniques, using abundant and cheap carbon to replace the hole transport material (HTM) and the gold electrode further reduces costs, and carbon acts as a moisture repellent that helps in maintaining the stability of the underlying perovskite active layer. An inorganic interlayer of spinel cobaltite oxides (CoO) can greatly enhance the carbon based PSC performance by suppressing charge recombination and extracting holes efficiently. The main focus of this research work is to investigate the effectiveness of CoO spinel oxide as the hole transporting interlayer for carbon based perovskite solar cells (PSCs).

Effect of Formamidinium/Cesium Substitution and PbI on the Long-Term Stability of Triple-Cation Perovskites.

Altering cation and anion ratios in perovskites has proven an excellent means of tuning the perovskite properties and enhancing the performance. Recently, methylammonium/formamidinium/cesium triple-cation mixed-halide perovskites have demonstrated efficiencies up to 22 %. Similar to the widely explored methylammonium lead halide, excess PbI is added to these perovskite films to enhance their performances.

Hierarchical Porous LiNi1/3Co1/3Mn1/3O2 Nano-/Micro Spherical Cathode Material: Minimized Cation Mixing and Improved Li(+) Mobility for Enhanced Electrochemical Performance.

Although being considered as one of the most promising cathode materials for Lithium-ion batteries (LIBs), LiNi1/3Co1/3Mn1/3O2 (NCM) is currently limited by its poor rate performance and cycle stability resulting from the thermodynamically favorable Li(+)/Ni(2+) cation mixing which depresses the Li(+) mobility. In this study, we developed a two-step method using fluffy MnO2 as template to prepare hierarchical porous nano-/microsphere NCM (PNM-NCM). Specifically, PNM-NCM microspheres achieves a high reversible specific capacity of 207.

Pressure-Dependent Polymorphism and Band-Gap Tuning of Methylammonium Lead Iodide Perovskite.

We report the pressure-induced crystallographic transitions and optical behavior of MAPbI3 (MA=methylammonium) using in situ synchrotron X-ray diffraction and laser-excited photoluminescence spectroscopy, supported by density functional theory (DFT) calculations using the hybrid functional B3PW91 with spin-orbit coupling. The tetragonal polymorph determined at ambient pressure transforms to a ReO3 -type cubic phase at 0.3 GPa.

Interstitial Oxide Ion Distribution and Transport Mechanism in Aluminum-Doped Neodymium Silicate Apatite Electrolytes.

Rare earth silicate apatites are one-dimensional channel structures that show potential as electrolytes for solid oxide fuel cells (SOFC) due to their high ionic conductivity at intermediate temperatures (500-700 °C). This advantageous property can be attributed to the presence of both interstitial oxygen and cation vacancies, that create diffusion paths which computational studies suggest are less tortuous and have lower activation energies for migration than in stoichiometric compounds. In this work, neutron diffraction of Nd(28+x)/3AlxSi6-xO26 (0 ≤ x ≤ 1.

Correlation of Local Structure and Diffusion Pathways in the Modulated Anisotropic Oxide Ion Conductor CeNbO(4.25).

CeNbO4.25 is reported to exhibit fast oxygen ion diffusion at moderate temperatures, making this the prototype of a new class of ion conductor with applications in a range of energy generation and storage devices. To date, the mechanism by which this ion transport is achieved has remained obscure, in part due to the long-range commensurately modulated structural motif.

Lead-Free MA2CuCl(x)Br(4-x) Hybrid Perovskites.

Despite their extremely good performance in solar cells with efficiencies approaching 20% and the emerging application for light-emitting devices, organic-inorganic lead halide perovskites suffer from high content of toxic, polluting, and bioaccumulative Pb, which may eventually hamper their commercialization. Here, we present the synthesis of two-dimensional (2D) Cu-based hybrid perovskites and study their optoelectronic properties to investigate their potential application in solar cells and light-emitting devices, providing a new environmental-friendly alternative to Pb. The series (CH3NH3)2CuCl(x)Br(4-x) was studied in detail, with the role of Cl found to be essential for stabilization.

Structure and Thermal Expansion of Calcium-Thorium Apatite, [Ca4]F[Ca2Th4]T[(SiO4)6]O2.

Thorium silicate apatite with the formula [Ca3.84Th0.16]F[Ca2.

Incorporation of Cl into sequentially deposited lead halide perovskite films for highly efficient mesoporous solar cells.

Organic-inorganic lead halide perovskites have been widely used as absorbers on mesoporous TiO2 films as well as thin films in planar heterojunction solar cells, yielding very high photovoltaic conversion efficiencies. Both the addition of chloride and sequential deposition methods were successfully employed to enhance the photovoltaic performance. Here, both approaches are combined in a sequential method by spincoating PbCl2 + PbI2 on a mesoporous TiO2 film followed by the perovskite transformation.

Lead-free halide perovskite solar cells with high photocurrents realized through vacancy modulation.

Lead free perovskite solar cells based on a CsSnI3 light absorber with a spectral response from 950 nm is demonstrated. The high photocurrents noted in the system are a consequence of SnF2 addition which reduces defect concentrations and hence the background charge carrier density.

Structural study of the apatite Nd₈Sr₂Si₆O₂₆ by Laue neutron diffraction and single-crystal Raman spectroscopy.

A single-crystal structure determination of Nd8Sr2Si6O26 apatite, a prototype intermediate-temperature electrolyte for solid oxide fuel cells grown by the floating-zone method, was completed using the combination of Laue neutron diffraction and Raman spectroscopy. While neutron diffraction was in good agreement with P6₃/m symmetry, the possibility of P6₃ could not be convincingly excluded. This ambiguity was removed by the collection of orientation-dependent Raman spectra that could only be consistent with P6₃/m.

Hydrothermal synthesis, structure investigation, and oxide ion conductivity of mixed Si/Ge-based apatite-type phases.

Apatite-type oxides ([A(I)4][A(II)6][(BO4)6]O2), particularly those of the rare-earth silicate and germanate systems, are among the more promising materials being considered as alternative solid oxide fuel cell electrolytes. Nonstoichiometric lanthanum silicate and germanate apatites display pure ionic conductivities exceeding those of yttria-stabilized zirconia at moderate temperatures (500-700 °C). In this study, mixed Si/Ge-based apatites were prepared by hydrothermal synthesis under mild conditions rather than the conventional solid-state method at high temperatures.

Understanding the synthetic pathway of a single-phase quarternary semiconductor using surface-enhanced Raman scattering: a case of wurtzite Cu₂ZnSnS₄ nanoparticles.

Single-phase Cu2ZnSnS4 (CZTS) is an essential prerequisite toward a high-efficiency thin-film solar cell device. Herein, the selective phase formation of single-phase CZTS nanoparticles by ligand control is reported. Surface-enhanced Raman scattering (SERS) spectroscopy is demonstrated for the first time as a characterization tool for nanoparticles to differentiate the mixed compositional phase (e.

Crystal chemistry of melilite [CaLa]2[Ga]2[Ga2O7]2: a five dimensional solid electrolyte.

Melilite-type [A(2)](2)[B(I)](2)[B(II)(2)O(7)](2) gallates are promising ion conducting electrolytes for deployment in solid oxide fuel cells. Single crystals of [CaLa](2)[Ga](2)[Ga(2)O(7)](2), grown in an optical floating zone furnace, were investigated using a combination of transmission electron microscopy and single crystal X-ray diffraction. Strong anisotropic displacements of oxygen arise from the structural misfit between the interlayer Ca/La cations and the [Ga]-[Ga(2)O(7)] tetrahedral layers.

Five-dimensional incommensurate structure of the melilite electrolyte [CaNd]2[Ga]2[Ga2O7]2.

Melilite-type gallium oxides are potential intermediate temperature electrolytes for solid oxide fuel cells. Single crystals of [CaNd](2)[Ga](2)[Ga(2)O(7)](2) grown using an optical floating zone furnace have been investigated using transmission electron microscopy and powder and single-crystal X-ray diffraction. The anion array topologically conforms to a [(3.

Polysomatic apatites.

Certain complex structures are logically regarded as intergrowths of chemically or topologically discrete modules. When the proportions of these components vary systematically a polysomatic series is created, whose construction provides a basis for understanding defects, symmetry alternation and trends in physical properties. Here, we describe the polysomatic family A(5N)B(3N)O(9N + 6)X(Ndelta) (2 < or = N < or = infinity) that is built by condensing N apatite modules (A(5)B(3)O(18)X(delta)) in configurations to create B(n)O(3n + 1) (1 < or = n < or = infinity) tetrahedral chains.

Pseudomorphic 2A--> 2M--> 2H phase transitions in lanthanum strontium germanate electrolyte apatites.

Apatite-like materials are of considerable interest as potential solid oxide fuel cell electrolytes, although their structural vagaries continue to attract significant discussion. Understanding these features is crucial both to explain the oxide ion conduction process and to optimise it. As the composition of putative P6(3)/m apatites with ideal formula [A(I)(4)][A(II)(6)][(BO(4))(6)][X](2) is varied the [A(I)(4)(BO(4))(6)] framework will flex to better accommodate the [A(II)(6)X(2)] tunnel component through adjustment of the A(I)O(6) metaprism twist angle (varphi).

The crystal chemistry of the alkaline-earth apatites A(10)(PO(4))(6)Cu(x)O(y)(H)(z) (A = Ca, Sr and Ba).

The crystal chemistry of the cuprate apatites A(I)(4)A(II)(6)(PO(4))(6)Cu(x)O(y)(H)(z) (A = Ca, Sr and Ba) was investigated by powder X-ray (PXRD) and neutron diffraction (PND) and X-ray photoelectron spectroscopy (XPS). The refined crystal structures confirmed earlier X-ray diffraction studies that showed copper resides in the apatite channels and additionally, located hydrogen. For all materials copper is primarily divalent (Cu(2+)) but in the calcium and strontium analogues co-exists with minor Cu(3+).

Crystal chemistry of mimetite, Pb10(AsO4)6Cl1.48O0.26, and finnemanite, Pb10(AsO3)6Cl2.

The crystal chemistries of synthetic mimetite, Pb(10)(As(5+)O(4))(6)(Cl(2 - x)O(x/2)), a neutral apatite, and finnemanite, Pb(10)(As(3+)O(3))(6)Cl(2), a reduced apatite, were characterized using a combination of X-ray powder diffraction, neutron diffraction, transmission electron microscopy and X-ray photoelectron spectroscopy. Both phases conform to hexagonal P6(3)/m symmetry; however, the temperature-driven transformation of clinomimetite to mimetite described earlier was not confirmed. The average mimetite structure is best described through the introduction of partially occupied oxygen sites.

Triclinic apatites.

Apatites commonly adopt P6(3)/m hexagonal symmetry. More rarely, monoclinic chemical analogues have been recognized, including the biologically significant hydroxyapatite, Ca(10)(PO(4))(6)(OH)(2), but the driving force towards lower symmetry has not been systematically examined. A combination of diffraction observations and ab initio calculations for Ca(10)(AsO(4))(6)F(2) and Ca(10)(VO(4))(6)F(2) show these materials are triclinic P\bar 1 apatites in which the AsO(4) and VO(4) tetrahedra tilt to relieve stress at the metal and metalloid sites to yield reasonable bond-valence sums.