Comparative study of cytotoxicity of detonation nanodiamond particles with an osteosarcoma cell line and primary mesenchymal stem cells.

Recently, nanodiamonds (NDs) have attracted great interest due to their unique physical and chemical properties that could be used in various biological applications. However, depending on the origin, NDs often contain different impurities which may affect cellular functions and viability. Therefore, before their biomedical application, the cytotoxicity of newly produced NDs should be assessed.

Zeolitic imidazolate framework-71 nanocrystals and a novel SOD-type polymorph: solution mediated phase transformations, phase selection via coordination modulation and a density functional theory derived energy landscape.

We report a rapid additive-free synthesis of nanocrystals (NCs) of RHO-type ZIF-71 () of composition [Zn(dcim)2] (dcim = 4,5-dichloroimidazolate) in 1-propanol as solvent at room temperature. NC- has a size of 30-60 nm and exhibits permanent microporosity with a surface area (SBET = 970 m(2) g(-1)) comparable to that of microcrystalline material. When kept under the mother solution NC- undergoes transformation into a novel SOD-type polymorph (), which in turn converts into known ZIF-72 () with lcs topology.

In situ static and dynamic light scattering and scanning electron microscopy study on the crystallization of the dense zinc imidazolate framework ZIF-zni.

The kinetics and mechanism of crystallization of the dense zinc imidazolate framework with zni topology, from comparatively dilute methanol solutions containing Zn(NO(3))·6H(2)O and imidazole with variation of the zinc-to-imidazole ratio, were followed in situ by time-resolved static and dynamic light scattering. The light scattering data revealed that metastable primary particles of about 100 nm in diameter form rapidly upon mixing the component solutions. After a lag time that is dependent on the imidazole concentration, the primary particles aggregate into secondary particles by a monomer addition mechanism with the primary particles as the monomers.

Interfacial Cu/ZnO contact by selective photodeposition of copper onto the surface of small ZnO nanoparticles in non-aqueous colloidal solution.

Nanoscale copper was selectively photodeposited onto the surface of hexadecylamine (HDA) stabilized (monodispersed not agglomerated) ZnO nanoparticles (NPs) of a diameter of 2-5 nm, which leads to HDA-stabilized Cu/ZnO NPs of varied Cu loading. The particles are soluble in non-polar organic solvents. The line broadening and the red shift of the surface plasmon band of Cu/ZnO NPs relative to HDA-stabilized Cu NPs, the profound decrease of the Cu/ZnO NPs visible photoluminescence at 525 nm, the increase of the UV emission intensity at 365 nm and the enhancement of the Raman scattering (RS) intensity in comparison to the parent ZnO NPs confirmed the interfacial contact between the Cu and ZnO phase.

A colloidal ZnO/Cu nanocatalyst for methanol synthesis.

Free-standing, ZnO surface decorated Cu nanoparticles of 1-3 nm size were obtained by sequential co-pyrolysis of [Cu(OCHMeCH2NMe2)2] and ZnEt2 in squalane in the absence of additional surfactants and proved to be highly active quasi homogeneous catalysts for methanol synthesis from CO and H2.

Selective photo-deposition of Cu onto the surface of monodisperse oleic acid capped TiO2 nanorods probed by FT-IR CO-adsorption studies.

A novel, non-aqueous, organometallic route to nanocomposite Cu@TiO2 materials is presented. TiO2 nanorods stabilized with oleic acid (OLA) were used as support for the photo-assisted deposition of Cu using the organometallic Cu(II) precursor [Cu(OCH(CH3)CH2N(CH3)2)2] (1). The copper precursor penetrates through the shell of OLA and is photo reduced to deposit Cu0 directly at the surface of the TiO2 rods.