Volatile organic compounds (VOCs) are important atmospheric constituents because they contribute to formation of ozone and secondary aerosols, and because some VOCs are toxic air pollutants. We measured concentrations of a suite of anthropogenic VOCs during summer and winter at 70 locations representing different microenvironments around Pittsburgh, PA. The sampling sites were classified both by land use (e.
View Article and Find Full Text PDFEnviron Sci Technol
January 2018
We conducted a mobile sampling campaign in a historically industrialized terrain (Pittsburgh, PA) targeting spatial heterogeneity of organic aerosol. Thirty-six sampling sites were chosen based on stratification of traffic, industrial source density, and elevation. We collected organic carbon (OC) on quartz filters, quantified different OC components with thermal-optical analysis, and grouped them based on volatility in decreasing order (OC1, OC2, OC3, OC4, and pyrolyzed carbon (PC)).
View Article and Find Full Text PDFWe measured the gas-particle partitioning of vehicle emitted primary organic aerosol (POA) in a traffic tunnel with three independent methods: artifact corrected bare-quartz filters, thermodenuder (TD) measurements, and thermal-desorption gas-chromatography mass-spectrometry (TD-GC-MS). Results from all methods consistently show that vehicle emitted POA measured in the traffic tunnel is semivolatile under a wide range of fleet compositions and ambient conditions. We compared the gas-particle partitioning of POA measured in both tunnel and dynamometer studies and found that volatility distributions measured in the traffic tunnel are similar to volatility distributions measured in the dynamometer studies, and predict similar gas-particle partitioning in the TD.
View Article and Find Full Text PDFUnlabelled: The impacts of emissions plumes from major industrial sources on black carbon (BC) and BTEX (benzene, toluene, ethyl benzene, xylene isomers) exposures in communities located >10 km from the industrial source areas were identified with a combination of stationary measurements, source identification using positive matrix factorization (PMF), and dispersion modeling. The industrial emissions create multihour plume events of BC and BTEX at the measurement sites. PMF source apportionment, along with wind patterns, indicates that the observed pollutant plumes are the result of transport of industrial emissions under conditions of low boundary layer height.
View Article and Find Full Text PDFEffects of fleet modernization and use of diesel particle filters (DPF) and selective catalytic reduction (SCR) on heavy-duty diesel truck emissions were studied at the Port of Oakland in California. Nitrogen oxides (NOx), black carbon (BC), particle number (PN), and size distributions were measured in the exhaust plumes of ∼1400 drayage trucks. Average NOx, BC, and PN emission factors for newer engines (2010-2013 model years) equipped with both DPF and SCR were 69 ± 15%, 92 ± 32%, and 66 ± 35% lower, respectively, than 2004-2006 engines without these technologies.
View Article and Find Full Text PDFEthylene glycol (HOCH2CH2OH), used as engine coolant for most on-road vehicles, is an intermediate volatility organic compound (IVOC) with a high Henry's law coefficient. We present measurements of ethylene glycol (EG) vapor in the Caldecott Tunnel near San Francisco, using a proton transfer reaction mass spectrometer (PTR-MS). Ethylene glycol was detected at mass-to-charge ratio 45, usually interpreted as solely coming from acetaldehyde.
View Article and Find Full Text PDFEnviron Sci Technol
March 2015
Equipment- and site-level methane emissions from 45 compressor stations in the transmission and storage (T&S) sector of the US natural gas system were measured, including 25 sites required to report under the EPA greenhouse gas reporting program (GHGRP). Direct measurements of fugitive and vented sources were combined with AP-42-based exhaust emission factors (for operating reciprocating engines and turbines) to produce a study onsite estimate. Site-level methane emissions were also concurrently measured with downwind-tracer-flux techniques.
View Article and Find Full Text PDFMotor vehicles are major sources of primary organic aerosol (POA), which is a mixture of a large number of organic compounds that have not been comprehensively characterized. In this work, we apply a recently developed gas chromatography mass spectrometry approach utilizing "soft" vacuum ultraviolet photoionization to achieve unprecedented chemical characterization of motor vehicle POA emissions in a roadway tunnel with a mass closure of >60%. The observed POA was characterized by number of carbon atoms (NC), number of double bond equivalents (NDBE) and degree of molecular branching.
View Article and Find Full Text PDFVehicle emissions of nitrogen oxides (NOx), carbon monoxide (CO), fine particulate matter (PM2.5), organic aerosol (OA), and black carbon (BC) were measured at the Caldecott tunnel in the San Francisco Bay Area. Measurements were made in bore 2 of the tunnel, where light-duty (LD) vehicles accounted for >99% of total traffic and heavy-duty trucks were not allowed.
View Article and Find Full Text PDFMotor vehicles are major sources of gas-phase organic carbon, which includes volatile organic compounds (VOCs) and other compounds with lower vapor pressures. These emissions react in the atmosphere, leading to the formation of ozone and secondary organic aerosol (SOA). With more chemical detail than previous studies, we report emission factors for over 230 compounds from gasoline and diesel vehicles via two methods.
View Article and Find Full Text PDFEmissions from gasoline and diesel vehicles are predominant anthropogenic sources of reactive gas-phase organic carbon and key precursors to secondary organic aerosol (SOA) in urban areas. Their relative importance for aerosol formation is a controversial issue with implications for air quality control policy and public health. We characterize the chemical composition, mass distribution, and organic aerosol formation potential of emissions from gasoline and diesel vehicles, and find diesel exhaust is seven times more efficient at forming aerosol than gasoline exhaust.
View Article and Find Full Text PDFPollutant concentrations in the exhaust plumes of individual diesel trucks were measured at high time resolution in a highway tunnel in Oakland, CA, during July 2010. Emission factors for individual trucks were calculated using a carbon balance method, in which pollutants measured in each exhaust plume were normalized to measured concentrations of carbon dioxide. Pollutants considered here include nitric oxide, nitrogen dioxide (NO(2)), carbon monoxide, formaldehyde, ethene, and black carbon (BC), as well as optical properties of emitted particles.
View Article and Find Full Text PDFHeavy-duty diesel drayage trucks have a disproportionate impact on the air quality of communities surrounding major freight-handling facilities. In an attempt to mitigate this impact, the state of California has mandated new emission control requirements for drayage trucks accessing ports and rail yards in the state beginning in 2010. This control rule prompted an accelerated diesel particle filter (DPF) retrofit and truck replacement program at the Port of Oakland.
View Article and Find Full Text PDF