Polarization-resolved mode evolution in TMI-limited Yb-doped fiber amplifiers using a novel high-speed Stokes polarimeter.

In this work we have developed a high-speed Stokes polarimeter method based on simultaneous 4-channel imaging with a high-speed camera. Thus, current speed limitations of imaging polarimeters for wavelengths around 1 µm can be overcome, allowing a sub-ms polarization-resolved characterization of transverse mode instability (TMI). Additionally, the Stokes parameters of each individual mode are calculated by a simultaneous 4-beam mode reconstruction algorithm during post-processing and can be analyzed with unprecedented temporal resolution.

Experimental analysis of Raman-induced transverse mode instability in a core-pumped Raman fiber amplifier.

The effect of transverse mode instability is a limitation for the power scaling of fiber laser systems, that can originate due to heat caused by stimulated Raman scattering. In this contribution, we experimentally investigate the threshold of transverse mode instability caused by stimulated Raman scattering in a passive fiber. Both, the Stokes seed power and the fiber length of a core-pumped Raman fiber amplifier are varied to systematically study this effect.

Continuous-wave cascaded second Stokes diamond Raman laser at 1477 nm.

We report a high brightness cascaded Stokes diamond Raman laser with a diffraction limited beam quality pumped by an Yd-doped fiber laser. The Raman laser operated at 1477 nm and reached an output power of 63 W with 214 W pump power in continuous-wave mode. Conversion efficiency over 30% was achieved using a single pump pass concentric cavity that was highly resonant at the first Stokes and had high outcoupling at the second Stokes (45%).

Transverse mode instability in a passive fiber induced by stimulated Raman scattering.

Transverse mode instabilities are a major limitation for power scaling of fiber lasers but have so far only been observed in laser-active fibers. In this contribution we present experimental observations of transverse mode instabilities in a passive fiber. In this fiber, stimulated Raman scattering acted as heat source.

Highly customized 1010 nm, ns-pulsed Yb-doped fiber amplifier as a key tool for on-demand single-photon generation.

The development of highly customized technical devices is a decisive feature of technically complex setups, as frequently observed in quantum experiments. This paper describes the development and realization of an Yb-doped all-fiber amplifier system designed for such a special application, more specifically, an on-demand single-photon source based on four-wave mixing with rubidium Rydberg atoms. The laser is capable of generating bandwidth-limited configurable nanosecond pulses up to peak powers of >100 W and with pulse repetition frequencies (PRF) between 50 Hz and 1 MHz at selectable wavelengths (1008-1024 nm).

Diamond Raman oscillator operating at 1178 nm.

In this contribution, we report high-power Raman frequency downconversion based on an Yb-doped fiber amplifier and a linear external diamond Raman cavity. A maximum output power of 136 W with nearly diffraction-limited beam quality was achieved by pumping in quasi-continuous-wave mode with 10% duty cycle and 10 ms on-time duration. For continuous-wave operation, we achieved record average power of 46 W centered at 1178 nm.

Ring-up-doped fiber for the generation of more than 600 W single-mode narrow-band output at 1018 nm.

We present the amplification of a narrow-bandwidth signal at a wavelength of 1018 nm to a power exceeding 600 W with a stable output polarization state. The beam showed an excellent, nearly diffraction-limited beam quality. The high-power output could be realized using an in-house designed and fabricated fiber with a core-cladding diameter ratio of 32/260, ultra-low NA of 0.

Measuring thermal load in fiber amplifiers in the presence of transversal mode instabilities.

We report on detailed in situ distributed temperature measurements inside a high power fiber amplifier. The deducted thermal load and the transversal mode instability (TMI) threshold of a commercial large mode area fiber with 25 μm core and 400 μm cladding were measured at various seed wavelengths. By matching these results with detailed simulations we show that photodarkening has a negligible impact on the thermal load and, therefore, on the TMI threshold in this fiber.

Monolithic thulium fiber laser with 567 W output power at 1970 nm.

We report on a monolithic thulium fiber laser with 567 W output power at 1970 nm which, to the best of our knowledge, is the highest power reported so far directly from a thulium oscillator. This is achieved by optimization of the splice parameters for the active fiber (minimizing signal light in the fiber cladding) and direct water cooling. Dual transverse mode operation is visible from the optical spectrum and can be deduced from the measured beam quality of M=2.

Experimental realization of femtosecond transverse mode conversion using optically induced transient long-period gratings.

We present the experimental realization of transverse mode conversion in an optical fiber via an optically induced long-period grating. The transient gratings are generated by femtosecond laser pulses, exploiting the Kerr effect to translate intensity patterns emerging from multimode interference into a spatial refractive index modulation. Since these modulations exist only while the pump beam is present, they can be used for optical switching of transverse modes.

Optical repetition rate stabilization of a mode-locked all-fiber laser.

We designed an all-fiber mode-locked Erbium laser with optically stabilized repetition rate of 31.4 MHz. The stabilization was achieved by changing the refractive index of an Ytterbium-doped fiber in the resonator via optical pumping at a wavelength of 978 nm; and for long-term stability the local temperature of the fiber was additionally controlled with a thermo-electric element.

Multimode interference filter for tuning of a mode-locked all-fiber erbium laser.

We present a mode-locked all-fiber erbium laser that can be tuned in wavelength while in pulsed operation. A low-cost multimode interference bandpass filter based solely on standard fibers was employed in a sigma-shaped cavity design. By bending the fiber filter, the spectrum could be continuously shifted by up to 11.

Experimental investigations on nonlinear dynamics in supercontinuum generation with feedback.

A system for supercontinuum generation by using a photonic crystal fiber within a synchronously pumped ring cavity is presented. The feedback led to an interaction of the generated supercontinuum with the following femtosecond laser pulses and thus to the formation of a nonlinear oscillator. The nonlinear dynamical behavior of this system was investigated experimentally and compared with numerical simulations.

Nonlinear dynamics of femtosecond supercontinuum generation with feedback.

We numerically study the impact of feedback on supercontinuum generation within a microstructured fiber inside a ring resonator, synchronously pumped with femtosecond pulses. In certain parameter ranges we observe a steady-state oscillator-like operation mode of the system. Depending on pump power also period doubling up to chaos is shown by the system.