Effect of internal structure and resin deformability on drying rate and stress in convective drying of silica-latex coatings.

Latex paint is an aqueous dispersion of nano-sized polymer particles that can form a thin film by itself or mixed with rigid particles. We have developed an apparatus that can simultaneously measure drying rate and stress generation and have investigated the film formation process of a latex-only coating layer under convection drying. In the present study, we adopted the same method to investigate the film formation process of the silica-latex coating layer.

Process intensification of synthesis of metal organic framework particles assisted by ultrasound irradiation.

This study synthesized UiO-66, a typical Zr-Metal Organic Framework (MOF), by using an ultrasound-assisted synthesis method to reduce the synthesis time. This method was short-time ultrasound irradiation at the initial stage of the reaction. As compared with average particle size of conventional solvothermal method (=192 nm), averaged particle size by the ultrasound-assisted synthesis method showed particle sizes that were smaller on average, ranging from 56 to 155 nm.

Drying rate of latex coating affected by the deformability of resin particles in convection drying.

Latex paints are widely used, and many researchers pointed out that the film formation process depends on the deformability of dispersed polymer particles. However, the relationship between the film formation process and drying rate has not been totally understood due to the lack of accurate data on drying rate throughout the drying process. In the present study, we measured the drying rate of latex coating by the temperature change method proposed by Imakoma in convective drying.

Advances in Biological Liquid Crystals.

Biological liquid crystals, a rich set of soft materials with rod-like structures widely existing in nature, possess typical lyotropic liquid crystalline phase properties both in vitro (e.g., cellulose, peptides, and protein assemblies) and in vivo (e.

Effect of geometrical configuration of reactor on a ZrP nano-dispersion process using ultrasonic irradiation.

This study investigated the position of ultrasonic irradiation source and reactor geometry on fragmentation rate of a layered compound, α-zirconium phosphate (α-ZrP). By numerically solving the acoustic pressure distribution using COMSOL Multiphysics®, it is clarified the mechanism whereby the operating factors influenced the α-ZrP dispersion to make a suggestion of guideline of the process design method. Two vessels made of glass with a flat-bottom and a spherical-bottom, respectively, were used.

Process development of starch hydrolysis using mixing characteristics of Taylor vortices.

In food industries, enzymatic starch hydrolysis is an important process that consists of two steps: gelatinization and saccharification. One of the major difficulties in designing the starch hydrolysis process is the sharp change in its rheological properties. In this study, Taylor-Couette flow reactor was applied to continuous starch hydrolysis process.

Effect of ultrasonic pretreatment on emulsion polymerization of styrene.

This study investigated the effect of pretreatment of ultrasonic irradiation on emulsion polymerization of styrene to propose a process intensification method which gives high conversion, high reaction rate, and high energy efficiency. The solution containing styrene monomer was irradiated by a horn mounted on the ultrasonic transducer with the diameter of 5mm diameter and the frequency of 28 kHz before starting polymerization. The pretreatment of ultrasound irradiation as short as 1 min drastically improved monomer dispersion and increased reaction rate even under the agitation condition with low rotational speed of impeller.