Influence of WC Particle Size on the Mechanical Properties and Residual Stress of HVOF Thermally Sprayed WC-10Co-4Cr Coatings.

Cermet coatings deposited using high-velocity oxy-fuel (HVOF) are widely used due to their excellent wear and corrosion resistance. The new agglomeration-rapid sintering method is an excellent candidate for the preparation of WC-Co-Cr feedstock powders. In this study, four different WC-10Co-4Cr feedstock powders containing WC particles of different sizes were prepared by the new agglomeration-rapid sintering method and deposited on steel substrates using the HVOF technique.

Effect of Fe and Cr on the Macro/Micro Tribological Behaviours of Copper-Based Composites.

Fe and Cr are regarded as two of the most important friction components in Cu-based composites (Cu-BCs). In this study, the microstructural detection and micro- and macro-tribology evaluation of Cu-BCs containing Fe and Cr were performed. The results indicated that both Fe and Cr formed diffusion interfaces with the copper matrix.

Effect of CNTs in Copper Matrix on Mechanical Characteristics and Tribological Behavior under Dry Sliding and Boundary Lubrication Conditions.

In the present work, the mechanical and tribological properties of carbon nanotube (CNT)-reinforced Cu matrix composites featuring 0-1.8 vol% CNTs prepared by spark plasma sintering under dry sliding and boundary lubrication conditions were investigated. The results of microstructure revealed that the bonding interface in Cu/CNT composites was very well established.