Mechanical and numerical characterization of ceramic femoral components for hip resurfacing arthroplasty.

Hip resurfacing arthroplasty may have distinct advantages for young and active patients, but large metal-on-metal bearings can be associated with increased wear, adverse tissue reactions and higher rate of implant loosening. Ceramic wear couples are a commonly used alternative to metals and therefore might be an alternative for hip resurfacing arthroplastys. The aim of this study was to evaluate the mechanical strength of femoral components made of an alumina-toughened zirconia composite by means of experimental testing and finite element analysis.

Combined wear and ageing of ceramic-on-ceramic bearings in total hip replacement under edge loading conditions.

Ceramic-on-ceramic bearings in total hip replacement have shown the potential to provide low wear solutions in hip replacement. Assessing the tribological performance of these materials is important to predict their long-term performance in patients. In this study, a methodology was devised to assess the tribological in vitro behaviour of composite ceramics under combined adverse edge loading conditions and accelerated ageing.

Sub-surface assessment of hydrothermal ageing in zirconia-containing femoral heads for hip joint applications.

Unlabelled: Zirconia-based materials have been used in orthopaedics since the 1980s, with large success, mainly thanks to transformation toughening. On the other hand, their main drawback is their potential sensitivity to hydrothermal ageing, i.e.

Wear of composite ceramics in mixed-material combinations in total hip replacement under adverse edge loading conditions.

Ceramic composites have performed very well under adverse edge loading conditions when used in like-on-like configurations, where the femoral head and acetabular cup are of the same material. The aim of this study was to determine the wear of pure alumina (Al O ), alumina toughened zirconia (ATZ) and zirconia toughened alumina (ZTA) when used in mixed bearing combinations, under edge loading conditions due to translational mal-positioning. The head-on-cup configurations of three ceramic materials were ATZ-on-ZTA, ZTA-on-ATZ, Al O -on-ATZ, ATZ-on-Al O , Al O -on-ZTA, and ZTA-on-Al O .

Edge loading does not increase wear rates of ceramic-on-ceramic and metal-on-polyethylene articulations.

The mal-positioning of total hip arthroplasty components can result in edge loading conditions. Purpose of this study was to determine if the wear rate of ceramic-on-ceramic and metal-on-polyethylene increases under edge loading conditions. The literature was reviewed to determine which of the commonly used hip bearings is the most forgiving to implant mal-orientation.