Fourier spectral shaper assisted feedback for wavelength and linewidth control of cascaded Raman fiber lasers.

Cascaded Raman fiber lasers (CRFLs) with wavelength-independent feedback can provide power at any wavelength in near-IR regions. However, broad feedback leads to a broad output spectrum, decreasing spectral power density at a desired wavelength. The output characteristics of CRFLs can be controlled by controlling the feedback.

Linewidth reduced cascaded Raman fiber lasers and their harmonic conversion for visible laser sources.

Cascaded Raman Fiber Lasers (CRFLs) are wavelength versatile sources that can provide power at any wavelength in the Near-Infrared (NIR) region. Conventional CRFLs with broadband feedback are widely wavelength tunable but have broad line widths. A feedback mechanism must be used to reduce the broadening of the linewidth without compromising the wavelength tunability.

Cascaded Raman fiber lasers with ultrahigh spectral purity.

Random distributed feedback (RDFB) cascaded Raman fiber lasers (CRFLs) are simple, wavelength agile, and enable high-power fiber lasers outside emission bandwidths of rare-earth doped fiber lasers. However, the spectral purity, defined as the percentage of total output power in the desired Stokes wavelength band, and relative intensity noise (RIN) of these systems are limited due to the intensity noise of the pump source used for Raman conversion. RIN gets amplified and transferred to Raman Stokes orders which causes incomplete Raman conversion and hence limits the spectral purity.

Microwave power induced resonance shifting of silicon ring modulators for continuously tunable, bandwidth scaled frequency combs.

We demonstrate a technique to continuously tune center frequency and repetition rate of optical frequency combs generated in silicon microring modulators and bandwidth scale them. We utilize a drive frequency dependent, microwave power induced shifting of the microring modulator resonance. In this work, we demonstrate center frequency tunability of frequency combs generated in silicon microring modulators over a wide range (∼8nm) with fixed number of lines.

Enhanced nonlinear spectral broadening and sub-picosecond pulse generation by adaptive spectral phase optimization of electro-optic frequency combs.

We utilize adaptive optimization to enhance the spectral broadening of an amplified electro-optic frequency comb with a 25 GHz repetition rate in a highly nonlinear fiber and subsequently generate sub-picosecond pulses. The spectral phase of the comb is adaptively optimized by a Fourier pulse shaper in a closed control loop with the HNLF output spectrum as the process variable to be optimized. Enhanced spectral broadening also increases the stimulated Brillouin scattering threshold allowing increased power scaling and thereby boosting the bandwidth by a factor of more than 13 times over the initial comb.

Octave-spanning, continuous-wave supercontinuum generation with record power using standard telecom fibers pumped with power-combined fiber lasers: publisher's note.

This publisher's note contains corrections to Opt. Lett.45, 1172 (2020).

Octave-spanning, continuous-wave supercontinuum generation with record power using standard telecom fibers pumped with power-combined fiber lasers.

We have demonstrated a record output power of ∼72, octave-spanning, nearly single-mode, continuous-wave supercontinuum with a bandwidth of ∼1050 using standard telecom fiber as the nonlinear medium in an all-fiber architecture. We have utilized the recently proposed nonlinear power combining architecture by which power scaling is achieved using multiple independent Ytterbium lasers operating at different wavelengths. In this Letter, Raman conversions in the fiber assist in combining multiple input laser lines into a single wavelength which then undergoes supercontinuum generation.

Visible light generation in the cladding of optical fibers carrying near-infrared continuous-wave lasers due to Cherenkov-phase matched harmonic conversion.

In this work, we report and analyze the cause of the surprising observation of visible light generation in the cladding of silica-based continuous-wave (CW), near-infrared fiber lasers. We observe a visible rainbow of hues in a cascaded Raman fiber laser, which we attribute to second and third harmonic conversion of the different wavelength components propagating in the core of the fiber. The light in the cladding of the fiber occurs through Cherenkov-type phase matching, and a mathematical analysis is presented to estimate the power of the harmonic light generated.

Optical frequency comb based on nonlinear spectral broadening of a phase modulated comb source driven by dual offset locked carriers.

We demonstrate a versatile technique to generate a broadband optical frequency comb source in the C-band. This is accomplished by nonlinear spectral broadening of a phase modulated comb source driven by dual frequency offset locked carriers. The locking is achieved by setting up a heterodyne optical frequency locked loop to lock two phase modulated electro-optic 25 GHz frequency combs sourced from individual seed carriers offset by 100 GHz, to within 6.

High-power, cascaded random Raman fiber laser with near complete conversion over wide wavelength and power tuning.

Cascaded Raman fiber lasers based on random distributed feedback (RDFB) are proven to be wavelength agile, enabling high powers outside rare-earth doped emission windows. In these systems, by simply adjusting the input pump power and wavelength, high-power lasers can be achieved at any wavelength within the transmission window of optical fibers. However, there are two primary limitations associated with these systems, which in turn limits further power scaling and applicability.

High-power, widely wavelength tunable, grating-free Raman fiber laser based on filtered feedback.

The cascaded Raman fiber laser is a proven technology that provides wavelength agile high-power fiber lasers outside the rare-earth emission windows. However, conventional cascaded Raman fiber lasers lack wavelength agility due to the use of fixed wavelength fiber Bragg gratings. Recently, proposed cascaded Raman fiber lasers based on random distributed feedback have provided a grating-free solution enabling wavelength agility.

High-power continuous-wave supercontinuum generation in highly nonlinear fibers pumped with high-order cascaded Raman fiber amplifiers.

A novel method for efficient generation of a high-power, equalized continuous-wave supercontinuum source in an all-conventional silica fiber architecture is demonstrated. Highly nonlinear fiber is pumped in its anomalous dispersion region using a novel, high-power, L-band laser. The L-band laser encompasses a sixth-order cascaded Raman amplifier which is pumped with a high-power Ytterbium-doped fiber laser and amplifies a low-power, tunable L-band seed source.

Generation of tunable, high repetition rate optical frequency combs using on-chip silicon modulators.

We experimentally demonstrate tunable, highly-stable frequency combs with high repetition-rates using a single, charge injection based silicon PN modulator. In this work, we demonstrate combs in the C-band with over eight lines in a 20-dB bandwidth. We demonstrate continuous tuning of the center frequency in the C-band and tuning of the repetition-rate from 7.

High power, high efficiency, continuous-wave supercontinuum generation using standard telecom fibers.

We demonstrate a simple module for octave spanning continuous-wave supercontinuum generation using standard telecom fiber. This module can accept any high power ytterbium-doped fiber laser as input. The input light is transferred into the anomalous dispersion region of the telecom fiber through a cascade of Raman shifts.

High-power, fixed, and tunable wavelength, grating-free cascaded Raman fiber lasers.

Cascaded Raman lasers enable high powers at various wavelength bands inaccessible with conventional rare-earth-doped lasers. The input and output wavelengths of conventional implementations are fixed by the constituent fiber gratings necessary for cascaded Raman conversion. We demonstrate here a simple architecture for high-power, fixed, and wavelength tunable, grating-free, cascaded Raman conversion between different wavelength bands.

Simultaneous Raman based power combining and wavelength conversion of high-power fiber lasers.

We present a technique for simultaneous power-combining and wavelength-conversion of multiple fiber lasers into a single, longer wavelength in a different band through Raman-based, nonlinear power combining. We illustrate this by power combining of two independent Ytterbium lasers into a single wavelength around 1.5micron with high output powers of upto 99W.

All passive architecture for high efficiency cascaded Raman conversion.

Cascaded Raman fiber lasers have offered a convenient method to obtain scalable, high-power sources at various wavelength regions inaccessible with rare-earth doped fiber lasers. A limitation previously was the reduced efficiency of these lasers. Recently, new architectures have been proposed to enhance efficiency, but this came at the cost of enhanced complexity, requiring an additional low-power, cascaded Raman laser.

Fully programmable two-dimensional pulse shaper for broadband line-by-line amplitude and phase control.

We introduce a fully programmable two-dimensional (2D) pulse shaper, able to simultaneously control the amplitude and phase of very fine spectral components over a broad bandwidth. This is achieved by aligning two types of spectral dispersers in a cross dispersion setup: a virtually imaged phased array for accessing fine resolution and a transmission grating for achieving broad bandwidth. We take advantage of the resultant 2D dispersion profile as well as introduce programmability by adding a 2D liquid crystal on silicon spatial light modulator at the masking plane.

A high efficiency architecture for cascaded Raman fiber lasers.

We demonstrate a new high efficiency architecture for cascaded Raman fiber lasers based on a single pass cascaded amplifier configuration. Conversion is seeded at all intermediate Stokes wavelengths using a multi-wavelength seed source. A lower power Raman laser based on the conventional cascaded Raman resonator architecture provides a convenient seed source providing all the necessary wavelengths simultaneously.

Stimulated Brillouin scattering thresholds in optical fibers for lasers linewidth broadened with noise.

Phase and/or intensity modulation techniques to broaden the Linewidth of an optical source are well known methods to suppress stimulated Brillouin scattering (SBS) in optical fibers. A common technique used to achieve significant bandwidth enhancement in a simple fashion is to phase modulate with a filtered noise source. We will demonstrate here that, in this case the stochastic nature of noise requires an inclusion of length dependent corrections to the SBS threshold enhancement.

Scaling the effective area of higher-order-mode erbium-doped fiber amplifiers.

We demonstrate scaling of the effective area of higher-order mode, Er-doped fiber amplifiers. Two Er-doped higher-order mode fibers, one with 3800 μm(2) A(eff) in the LP(0,11) mode, and one with 6000 μm(2) effective area in the LP(0,14) mode, are demonstrated. Output beam profiles show clean higher order modes, and S(2) imaging measurements show low extraneous higher order mode content.

Cladding-pumped erbium-doped multicore fiber amplifier.

A cladding pumped multicore erbium-doped fiber amplifier for simultaneous amplification of 6 channels is demonstrated. Peak gain over 32 dB has been obtained at a wavelength of 1560 nm and the bandwidth measured at 20-dB gain was about 35 nm. Numerical modeling of cladding pumped multicore erbium-doped amplifier was also performed to study the properties of the amplifier.

Bandwidth scaling and spectral flatness enhancement of optical frequency combs from phase-modulated continuous-wave lasers using cascaded four-wave mixing.

We introduce a new cascaded four-wave mixing technique that scales up the bandwidth of frequency combs generated by phase modulation of a continuous-wave (CW) laser while simultaneously enhancing the spectral flatness. As a result, we demonstrate a 10 GHz frequency comb with over 100 lines in a 10 dB bandwidth in which a record 75 lines are within a flatness of 1 dB. The cascaded four-wave mixing process increases the bandwidth of the initial comb generated by the modulation of a CW laser by a factor of five.

Generation of very flat optical frequency combs from continuous-wave lasers using cascaded intensity and phase modulators driven by tailored radio frequency waveforms.

We demonstrate a scheme based on a cascade of lithium niobate intensity and phase modulators driven by specially tailored RF waveforms to generate an optical frequency comb with very high spectral flatness. In this Letter, we demonstrate a 10 GHz comb with 38 comb lines within a spectral power variation below 1 dB. The number of comb lines that can be generated is limited by the power handling capability of the phase modulator, and this can be scaled without compromising the spectral flatness.