Eco-friendly cellulose hydrogels as controlled release fertilizer for enhanced growth and yield of upland rice.

The effect of urea-loaded cellulose hydrogel, a controlled-release fertilizer (CRF) on growth and yield of upland rice were investigated in upland rice. As with the initial research, nitrogen (N) treatments were applied as CRF treatments; T2H (30 kg N ha), T3H (60 kg N ha), T4H (90 kg N ha), T5H (120 kg N ha) and recommended dose of fertilizer (RDF) at 120 kg N ha RDF (T6U) in split application and T1 (0 N) as control. Results from this study indicated that applying CRF at the optimum N rate, T4H resulted in maximum grain yield, increasing by 71%.

Conversion of Sago (Metroxylon sagu) Pith Waste to Fermentable Sugars via a Facile Depolymerization Process.

The conversion of starchy sago (Metroxylon sagu) pith waste (SPW), a lignocellulosic biomass waste, to fermentable sugars under mild conditions had been successfully demonstrated. The optimum depolymerization of SPW was achieved at 2 wt% sample loading which was catalyzed by 100 mM of oxalic acid in the presence of 25 wt% NaCl solution at 110 °C for 3 h. Up to 97% SPW sample was being converted into fermentable sugars with limited formation of by-products after two sequential depolymerization cycles.

A unique "turn-on" fluorescence signalling strategy for highly specific detection of ascorbic acid using carbon dots as sensing probe.

Carbon dots (CDs) that showed strong blue fluorescence were successfully synthesised from sodium alginate via furnace pyrolysis. The single step pyrolytic synthesis was simple to perform while yielded CDs with high photostability, good water solubility and minimum by-products. In order to design the probe with "turn-on" sensing capability, the CDs were screened against a series of metal cations to first "turn-off" the fluorescence.

Carbon nanodots as molecular scaffolds for development of antimicrobial agents.

We report the potential of carbon nanodots (CNDs) as a molecular scaffold for enhancing the antimicrobial activities of small dendritic poly(amidoamines) (PAMAM). Carbon nanodots prepared from sago starch are readily functionalized with PAMAM by using N-ethyl-N'-(3-dimethylaminopropyl)carbodiimide hydrochloride (EDC) and N-hydroxysuccinimide (NHS). Electron microscopy images of these polyaminated CNDs show that they are approximately 30-60nm in diameter.

Regeneration of cello-oligomers via selective depolymerization of cellulose fibers derived from printed paper wastes.

Cellulose extracted from printed paper wastes were selectively depolymerized under controlled conditions into cello-oligomers of controllable chain lengths via dissolution in an ionic liquid, 1-allyl-3-methylimidazolium chloride (AMIMCl), and in the presence of an acid catalyst, Amberlyst 15DRY. The depolymerization process was optimized against reaction temperature, concentration of acid catalyst, and reaction time. Despite rapid initial depolymerization process, the rate of cellulose depolymerization slowed down gradually upon prolonged reaction time, with 75.

Integrated miniature fluorescent probe to leverage the sensing potential of ZnO quantum dots for the detection of copper (II) ions.

Quantum dots are fluorescent semiconductor nanoparticles that can be utilised for sensing applications. This paper evaluates the ability to leverage their analytical potential using an integrated fluorescent sensing probe that is portable, cost effective and simple to handle. ZnO quantum dots were prepared using the simple sol-gel hydrolysis method at ambient conditions and found to be significantly and specifically quenched by copper (II) ions.

Encapsulation and sustained release of curcumin using superparamagnetic silica reservoirs.

For controlled release and targeted delivery of curcumin in an aqueous medium a method of encapsulating curcumin and magnetic nanoparticles inside porous silica matrix has been developed. Curcumin and superparamagnetic nanoparticles are loaded inside porous silica in a single process. The graphic shows the TEM image of microtomed sample of Fe(3)O(4) particles surrounded by a silica matrix.

Fabrication of carbon nano-tubes decorated with ultra fine superparamagnetic nano-particles under continuous flow conditions.

Ultra fine (2-3 nm) magnetite (Fe(3)O(4)) nano-particles are uniformly deposited on single-walled carbon nano-tubes (SWCNTs) pre-functionalised with carboxylic acid groups using microwave radiation. The deposition process involves chemical precipitation associated with continuous flow spinning disc processing (SDP), as a rapid, environmentally friendly approach which is readily scalable for large scale synthesis. The resulting decorated SWCNTs are superparamagnetic with specific saturated magnetization of 30 emu g(-1).

Magnetite ferrofluids stabilized by sulfonato-calixarenes.

Magnetite (Fe304) nanoparticles stabilised by sulfonatocalixarene macrocycles are readily accessible by a rapid in situ co-precipitation, and exhibit ferro-fluidic and superparamagnetic behaviour.

Redox equilibria of iron oxides in aqueous-based magnetite dispersions: effect of pH and redox potential.

The effect of pH and redox potential on the redox equilibria of iron oxides in aqueous-based magnetite dispersions was investigated. The ionic activities of each dissolved iron species in equilibrium with magnetite nanoparticles were determined and contoured within the Eh-pH framework of a composite stability diagram. Both standard redox potentials and equilibrium constants for all major iron oxide redox equilibria in magnetite dispersions were found to differ from values reported for noncolloidal systems.