Direct measurement of brake wear particles from a light-duty vehicle under real-world driving conditions.

As tailpipe emissions have decreased, there is a growing focus on the relative contribution of non-exhaust sources of vehicle emissions. Addressing these emissions is key to better evaluating and reducing vehicles' impact on air quality and public health. Tailoring solutions for different non-exhaust sources, including brake emissions, is essential for achieving sustainable mobility.

Evaluation of Two Particle Number (PN) Counters with Different Test Protocols for the Periodic Technical Inspection (PTI) of Gasoline Vehicles.

Thousands of particle number (PN) counters have been introduced to the European market, following the implementation of PN tests during the periodic technical inspection (PTI) of diesel vehicles equipped with particulate filters. Expanding the PN-PTI test to gasoline vehicles may face several challenges due to the different exhaust aerosol characteristics. In this study, two PN-PTI instruments, type-examined for diesel vehicles, measured fifteen petrol passenger cars with different test protocols: low and high idling, with or without additional load, and sharp accelerations.

Regulated and unregulated emissions from Euro VI Diesel and CNG heavy-duty vehicles.

This study compares emissions from Euro VI-D Diesel and CNG buses across temperatures from -7 °C to 35 °C. Pollutants including NOx, THC, CH, CO, NH, NO, HCHO, Solid Particle Number larger than 23 nm (SPN23) and larger than 10 nm (SPN10) were measured. Both buses complied with Euro VI-D but exceeded European Commission's proposed Euro 7 limits, notably for NOx and SPN10.

Evaluation of Measurement Procedures for Solid Particle Number (SPN) Measurements during the Periodic Technical Inspection (PTI) of Vehicles.

Periodic technical inspection (PTI) of vehicles guarantees safety and environmental compliance during their lifetime. Particulate matter emissions of diesel vehicles are controlled with opacity measurements. After the introduction of diesel particulate filters (DPFs), particulate matter emissions have drastically decreased and the sensitivity of the opacity method is questioned.

Driver models for the definition of safety requirements of automated vehicles in international regulations. Application to motorway driving conditions.

UN Regulation 157, the first global regulation regarding the type-approval of Automated Driving Systems (ADS), has been adopted in 2021. In it, safety performance requirements are being defined for vehicles of automation Level 3, according to the SAE J3016, with a limited Operational Design Domain (ODD). In particular, for three types of events that are related to motorway driving, two models are provided to distinguish between preventable traffic scenarios, for which the ADS is expected to avoid an accident, and unpreventable traffic scenarios, for which accidents cannot be avoided and the ADS can only mitigate their severity.

Evaluation of Solid Particle Number Sensors for Periodic Technical Inspection of Passenger Cars.

Following the increase in stringency of the European regulation limits for laboratory and real world automotive emissions, one of the main transport related aspects to improve the air quality is the mass scale in-use vehicle testing. Solid particle number (SPN) emissions have been drastically reduced with the use of diesel and gasoline particulate filters which, however, may get damaged or even been tampered. The feasibility of on-board monitoring and remote sensing as well as of the current periodical technical inspection (PTI) for detecting malfunctioning or tampered particulate filters is under discussion.

Comparisons of Laboratory and On-Road Type-Approval Cycles with Idling Emissions. Implications for Periodical Technical Inspection (PTI) Sensors.

For the type approval of compression ignition (diesel) and gasoline direct injection vehicles, a particle number (PN) limit of 6 × 10 p/km is applicable. Diesel vehicles in circulation need to pass a periodical technical inspection (PTI) test, typically every two years, after the first four years of circulation. However, often the applicable smoke tests or on-board diagnostic (OBD) fault checks cannot identify malfunctions of the diesel particulate filters (DPFs).

Effect of Low Ambient Temperature on Emissions and Electric Range of Plug-In Hybrid Electric Vehicles.

Plug-in hybrid electrical vehicles (PHEVs) are generally considered to be a cleaner alternative to conventional passenger cars. However, there is still very limited information available regarding criteria pollutant emissions from these vehicles. This paper shows, for the first time, the emissions of criteria pollutants, unregulated pollutants, and CO and also electric range from two very different PHEVs, one Euro 6 parallel plug-in hybrid and one range-extended battery electric vehicle (BEVx), applying the new world harmonized light-duty test procedure at ambient temperatures equal to 23 and -7 °C.

On-road emissions of passenger cars beyond the boundary conditions of the real-driving emissions test.

Passenger cars are an important source of air pollution, especially in urban areas. Recently, real-driving emissions (RDE) test procedures have been introduced in the EU aiming to evaluate nitrogen oxides (NOx) and particulate number (PN) emissions from passenger cars during on-road operation. Although RDE accounts for a large variety of real-world driving, it excludes certain driving situations by setting boundary conditions (e.

Reducing the exhaust emissions of unregulated pollutants from small gasoline engines with alkylate fuel and low-ash lube oil.

We report exhaust emissions of regulated and unregulated gaseous compounds (aromatic, oxygenated, and nitrogen-containing compounds), particle mass and soot content for a series of 5 utility hand-held machines typically used in gardening and forestry operation in Europe. The engines were tested in the Vehicle Emissions Laboratory of the European Commission - Joint Research Centre. Two fuels, standard and alkylate fuel (trace content of aromatics), and 2 lubricant oils (semi-synthetic and low-ash) were used.

Evaluation of NO emissions of a retrofitted Euro 5 passenger car for the Horizon prize "Engine retrofit".

The Horizon 2020 prize for the "Engine Retrofit for Clean Air" aims at reducing the pollution in cities by spurring the development of retrofit technology for diesel engines. A Euro 5 passenger car was retrofitted with an under-floor SCR (Selective Catalytic Reduction) for NO catalyst in combination with a solid ammonia based dosing system as the NO reductant. The vehicle was tested both on the road and on the chassis dynamometer under various test cycles and ambient temperatures.

Impact of cold temperature on Euro 6 passenger car emissions.

Hydrocarbons, CO, NOx, NH, NO, CO and particulate matter emissions affect air quality, global warming and human health. Transport sector is an important source of these pollutants and high pollution episodes are often experienced during the cold season. However, EU vehicle emissions regulation at cold ambient temperature only addresses hydrocarbons and CO vehicular emissions.

NO, NH, NO and PN real driving emissions from a Euro VI heavy-duty vehicle. Impact of regulatory on-road test conditions on emissions.

Euro VI emission standards for heavy-duty vehicles (HDVs) introduced for the first time limits for solid particle number (PN) and NH emissions. EU regulation also includes a Portable Emissions Measurement System (PEMS) based test at type approval, followed by in-service conformity (ISC) testing. A comprehensive study on the real-time on-road emissions of NO, NH, NO and PN from a Euro VI HDV equipped with a Diesel Oxidation Catalyst (DOC), a Diesel Particle Filter (DPF), a Selective Catalytic Reduction (SCR) system and an Ammonia Oxidation Catalyst (AMOX) is presented.

Gasoline cars produce more carbonaceous particulate matter than modern filter-equipped diesel cars.

Carbonaceous particulate matter (PM), comprising black carbon (BC), primary organic aerosol (POA) and secondary organic aerosol (SOA, from atmospheric aging of precursors), is a highly toxic vehicle exhaust component. Therefore, understanding vehicle pollution requires knowledge of both primary emissions, and how these emissions age in the atmosphere. We provide a systematic examination of carbonaceous PM emissions and parameterisation of SOA formation from modern diesel and gasoline cars at different temperatures (22, -7 °C) during controlled laboratory experiments.

Intercomparison of real-time tailpipe ammonia measurements from vehicles tested over the new world-harmonized light-duty vehicle test cycle (WLTC).

Four light-duty vehicles (two diesel, one flex-fuel, and one gasoline vehicle) were tested as part of an intercomparison exercise of the world-harmonized light-duty vehicle test procedure (WLTP) aiming at measuring real-time ammonia emissions from the vehicles' raw exhaust at the tailpipe. The tests were conducted in the Vehicle Emission Laboratory (VELA) at the European Commission Joint Research Centre (EC-JRC), Ispra, Italy. HORIBA, CGS, and the Sustainable Transport Unit of the Joint Research Centre (JRC) took part in the measurement and analysis of the four vehicles' exhaust emissions over the world-harmonized light-duty vehicle test cycle class 3, version 5.

Two-stroke scooters are a dominant source of air pollution in many cities.

Fossil fuel-powered vehicles emit significant particulate matter, for example, black carbon and primary organic aerosol, and produce secondary organic aerosol. Here we quantify secondary organic aerosol production from two-stroke scooters. Cars and trucks, particularly diesel vehicles, are thought to be the main vehicular pollution sources.

Atmospheric fate of a series of carbonyl nitrates: photolysis frequencies and OH-oxidation rate constants.

Multifunctional organic nitrates are potential NO(x) reservoirs whose atmospheric chemistry is somewhat little known. They could play an important role in the spatial distribution of reactive nitrogen species and consequently in ozone formation and distribution in remote areas. In this work, the rate constants for the reaction with OH radical and the photolysis frequencies of α-nitrooxyacetone, 3-nitrooxy-2-butanone, and 3-methyl-3-nitrooxy-2-butanone have been determined at room temperature at 1000 mbar total pressure of synthetic air.

Electrocatalytic dihydrogen evolution mechanism of [Fe2(CO)4(kappa(2)-Ph2PCH2CH2PPh2)(mu-S(CH2)3S)] and related models of the [FeFe]-hydrogenases active site: a DFT investigation.

A DFT study of protonation thermodynamics in H(2)-evolving biomimetic catalysts related to [FeFe]-hydrogenases active site is presented here. Taking as a reference system the electrocatalytic dihydrogen evolution mechanism recently proposed for the synthetic assembly [Fe(2)(CO)(4)(kappa(2)-Ph(2)PCH(2)CH(2)PPh(2))(mu-S(CH(2))(3)S)] (a, which is able to release H(2) after having undergone monoelectron reduction steps and three sequential protonation reactions), we show how the reduction of model complexes to oxidation states lower than those observed in [FeFe]-hydrogenases cofactor leads to a protonation regiochemistry that has no counterpart in the enzymatic mechanism of H(2) production. In particular, double protonation of the metal centers turned out to be disfavored in a by up to 12.