Near real-time quantification of microbial volatile organic compounds from mycoparasitic fungi: Potential for advanced monitoring and pest control.

Microbial volatile organic compounds (MVOCs) are thought to play a key role in the interactions between mycoparasitic fungi, such as the biocontrol agent Trichoderma atroviride (T. atroviride), and their environment. However, the analysis of MVOC emissions from fungal samples is challenging because of low analyte concentrations, typically in the ppb-range, and the complex chemical nature of biological samples.

Establishing a cell-based screening workflow for determining the efficiency of CYP2C9 metabolism: moving towards the use of breath volatiles in personalised medicine.

The use of volatile biomarkers in exhaled breath as predictors to individual drug response would advance the field of personalised medicine by providing direct information on enzyme activity. This would result in enormous benefits, both for patients and for the healthcare sector. Non-invasive breath tests would also gain a high acceptance by patients.

Microplastics and nanoplastics: Size, surface and dispersant - What causes the effect?

There is increasing evidence that humans are exposed to microplastic particles through contaminated food. Although suitable analytical methods are still lacking, it is likely that these contaminations also contain a nanoplastics fraction. It is known from nanotoxicology that particles may acquire altered toxicological properties with decreasing particle sizes.

Photoactive Titanium Dioxide Films with Embedded Gold Nanoparticles for Quantitative Determination of Mercury Traces in Humic Matter-Containing Freshwaters.

Mercury detection in humic matter-containing natural waters is often associated with environmental harmful substances for sample preparation. Herein we report an approach based on photoactive titanium dioxide films with embedded gold nanoparticles (AuNP@TiO dipstick) for chemical-free sample preparation and mercury preconcentration. For this purpose, AuNPs are immobilized onto a silicon wafer and further covered with a thin photoactive titanium dioxide layer.

Intestinal and hepatic effects of iron oxide nanoparticles.

Iron oxide nanoparticles gain increasing attention due to their broad industrial use. However, safety concerns exist since their effects on human cells are still under investigation. The presence of iron oxide nanoparticles in the food pigment E172 has been shown recently.

Uptake and cellular effects of PE, PP, PET and PVC microplastic particles.

Humans are exposed to small plastic particles through contaminated food. Such contaminations usually comprise different particulate plastic materials differing in size, shape and surface. Up to now, data on intestinal uptake and adverse effects resulting from plastic particles other than polystyrene are scarce.

NanoPASS: an easy-to-use user interface for nanoparticle dosimetry with the 3DSDD model.

Nanoparticles exhibit a specific diffusion and sedimentation behavior under cell culture conditions as used in nantoxicological in vitro testing. How a particular particle suspension behaves depends on the particular physicochemical characteristics of the particles and the cell culture system. Only a fraction of the nanoparticles applied to a cell culture will thus reach the cells within a given time frame.

Impact of iron oxide nanoparticles on xenobiotic metabolism in HepaRG cells.

Iron oxide nanoparticles are used in various industrial fields, as a tool in biomedicine as well as in food colorants, and can therefore reach human metabolism via oral uptake or injection. However, their effects on the human body, especially the liver as one of the first target organs is still under elucidation. Here, we studied the influence of different representative iron oxide materials on xenobiotic metabolism of HepaRG cells.

Micro- and nanoplastics - current state of knowledge with the focus on oral uptake and toxicity.

The production and use of plastics has constantly increased over the last 30 years. Over one third of the plastics is used in disposables, which are discarded within three years of their production. Despite efforts towards recycling, a substantial volume of debris has accumulated in the environment and is slowly degraded to micro- and nanoplastics by weathering and aging.

The presence of iron oxide nanoparticles in the food pigment E172.

Iron oxides used as food colorants are listed in the European Union with the number E172. However, there are no specifications concerning the fraction of nanoparticles in these pigments. Here, seven E172 products were thoroughly characterized.

Isolation methods for particle protein corona complexes from protein-rich matrices.

: Nanoparticles become rapidly encased by a protein layer when they are in contact with biological fluids. This protein shell is called a corona. The composition of the corona has a strong influence on the surface properties of the nanoparticles.

An inverse cell culture model for floating plastic particles.

Plastic waste has become a major environmental problem. An increasing number of studies investigate microplastic particles with regard to their uptake and effects in cell culture systems. Individual plastic materials vary in their molecular structure, composition, size distribution, material density, and may also differ with respect to their toxicological effects.

Impact of artificial digestion on the sizes and shapes of microplastic particles.

Current analyses show a widespread occurrence of microplastic particles in food products and raise the question of potential risks to human health. Plastic particles are widely considered to be inert due to their low chemical reactivity and therefore supposed to pose, if at all only minor hazards. However, variable physicochemical conditions during the passage of the gastrointestinal tract gain strong importance, as they may affect particle characteristics.

Uptake and effects of orally ingested polystyrene microplastic particles in vitro and in vivo.

Evidence exists that humans are exposed to plastic microparticles via diet. Data on intestinal particle uptake and health-related effects resulting from microplastic exposure are scarce. Aim of the study was to analyze the uptake and effects of microplastic particles in human in vitro systems and in rodents in vivo.

Mesoporous Silica-gold Films for Straightforward, Highly Reproducible Monitoring of Mercury Traces in Water.

Trace-level detection of mercury in waters is connected with several complications including complex multistep analysis routines, applying additional, harmful reagents increasing the risk of contamination, and the need for expensive analysis equipment. Here, we present a straightforward reagent-free approach for mercury trace determination using a novel thin film sampling stick for passive sampling based on gold nanoparticles. The nanoparticles supported on a silicon wafer and further covered with a thin layer of mesoporous silica.

Suitability of Secondary PEEK Telescopic Crowns on Zirconia Primary Crowns: The Influence of Fabrication Method and Taper.

This study investigates the retention load (RL) between ZrO₂ primary crowns and secondary polyetheretherketone (PEEK) crowns made by different fabrication methods with three different tapers. Standardized primary ZrO₂ crowns were fabricated with three different tapers: 0°, 1°, and 2° ( = 10/group). Ten secondary crowns were fabricated (i) milled from breCam BioHPP blanks (PM); (ii) pressed from industrially fabricated PEEK pellets (PP) (BioHPP Pellet); or (iii) pressed from granular PEEK (PG) (BioHPP Granulat).

Movement imagery classification in EMOTIV cap based system by Naïve Bayes.

Brain-computer interfaces (BCI) provide means of communications and control, in assistive technology, which do not require motor activity from the user. The goal of this study is to promote classification of two types of imaginary movements, left and right hands, in an EMOTIV cap based system, using the Naïve Bayes classifier. A preliminary analysis with respect to results obtained by other experiments in this field is also conducted.

Retention force of differently fabricated telescopic PEEK crowns with different tapers.

To assess the retention force between primary and secondary PEEK crowns made by different fabrication methods. Primary crowns with different tapers (0°, 1°, and 2°) were fabricated and secondary crowns that were either milled from breCam BioHPP blanks, pressed from pellets (BioHPP Pellet) or granules (BioHPP Granulat) were produced. Each specimen was measured 20 times in a pulloff-test and results were analyzed using 2-/1-way ANOVA and linear regression analyses (p<0.

Retention Load Values of Telescopic Crowns Made of Y-TZP and CoCr with Y-TZP Secondary Crowns: Impact of Different Taper Angles.

This study aimed to examine and compare the retention load values (RL) of different telescopic crown assemblies (Y-TZP and CoCr primary crowns with electroformed and Y-TZP secondary crowns each) with three different taper angles (0°, 1° and 2°). Thirty Y-TZP primary crowns with electroformed gold copings (Z/G group) and Y-TZP secondary crowns (Z/Z group) and 30 CoCr primary crowns with electroformed gold copings (C/G group) and Y-TZP secondary crowns (C/Z group), each with taper angles of 0°, 1° and 2°, were fabricated, respectively. With the exception of the electroformed gold copings, all specimens were Computer-Aided-Design/Computer-Aided-Manufacturing (CAD/CAM)-milled, then sintered and afterwards manually adapted.

Retention Load of Telescopic Crowns with Different Taper Angles between Cobalt-Chromium and Polyetheretherketone Made with Three Different Manufacturing Processes Examined by Pull-Off Test.

Purpose: To investigate the retention loads of differently fabricated secondary telescopic polyetheretherketone (PEEK) crowns on cobalt-chromium primary crowns with different tapers.

Materials And Methods: Cobalt-chromium primary crowns with 0°, 1°, and 2° tapers were constructed, milled, and sintered. Corresponding secondary crowns were fabricated by milling, pressing from pellets, and pressing from granules.

PEEK Primary Crowns with Cobalt-Chromium, Zirconia and Galvanic Secondary Crowns with Different Tapers-A Comparison of Retention Forces.

In prosthetic dentistry, double crown systems have proved their suitability as retainers for removable partial dentures. However, investigations in this context, regarding polyetheretherketone, are scarce. Therefore, the aim of this study was to test the retention force (RF) between polyetheretherketone (PEEK) primary and cobalt-chromium (CoCr), zirconia (ZrO₂) and galvanic (GAL) secondary crowns with three different tapers.

Blood Draw Barriers for Treatment with Clozapine and Development of a Point-of-Care Monitoring Device.

Background: While clozapine (CLZ) is the most effective antipsychotic drug for schizophrenia treatment, it remains underused. In order to understand the barriers of frequent blood draws for white blood cell counts (WBCs) and clozapine levels, we developed a psychiatrist survey and began an integrative approach of designing a point-of-care device that could eventually have real-time monitoring with immediate results.

Methods: We ascertained barriers related to CLZ management and the acceptance of possible solutions by sending an anonymous survey to physicians in psychiatric practice (n=860).

Prophylaxis with antipsychotic medication reduces the risk of post-operative delirium in elderly patients: a meta-analysis.

Background: Delirium commonly occurs in hospitalized elderly patients, resulting in increased morbidity and mortality. Although evidence for treatment of delirium exists, evidence supporting pharmacologic prevention of delirium in high risk patients is limited.

Objective: This review examined whether delirium in at-risk patients can be prevented with antipsychotic prophylaxis in the inpatient setting.