Superlative and Selective Sensing of Serotonin in Undiluted Human Serum Using Novel Polystyrene Sulfonate Conductive Polymer.

In the past 5 years, real-time health monitoring has become ubiquitous with the development of watches and rings that can measure and report on the physiological state. As an extension, real-time biomarker sensors, such as the continuous glucose monitor, are becoming popular for both health and performance monitoring. However, few real-time sensors for biomarkers have been made commercially available; this is primarily due to problems with cost, stability, sensitivity, selectivity, and reproducibility of biosensors.

Peptide-Functionalized Carbon Nanotube Chemiresistors: The Effect of Nanotube Density on Gas Sensing.

Biorecognition element (BRE)-based carbon nanotube (CNT) chemiresistors have tremendous potential to serve as highly sensitive, selective, and power-efficient volatile organic compound (VOC) sensors. While many research groups have studied BRE-functionalized CNTs in material science and device development, little attention has been paid to optimizing CNT density to improve chemiresistor performance. To probe the effect of CNT density on VOC detection, we present the chemiresistor-based sensing results from two peptide-based CNT devices counting more than 60 different individual measurements.

Rapid and Simple Buffer Exchange Using Cation-Exchange Chromatography to Improve Point-of-Care Detection of Pharmacological Agents.

The current COVID-19 pandemic has highlighted the power, speed, and simplicity of point-of-care (POC) diagnostics. POC diagnostics are available for a wide range of targets, including both drugs of abuse as well as performance-enhancing drugs. For pharmacological monitoring, minimally invasive fluids such as urine and saliva are commonly sampled.

Detection of Asthma Inhaler Use via Terahertz Spectroscopy.

Inhaled medications are commonplace for administering bronchodilators, anticholinergics, and corticosteroids. While they have a defined legitimate use, they are also used in sporting events as performance-enhancing drugs. These performance enhancers can be acquired via both legal (i.

Terahertz Spectroscopic Molecular Sensor for Rapid and Highly Specific Quantitative Analytical Gas Sensing.

Quantitative analytical gas sampling is of great importance in a range of environmental, safety, and scientific applications. In this article, we present the design, operation, and performance of a recently developed tabletop terahertz (THz) spectroscopic molecular sensor capable of rapid (minutes) and sensitive detection of polar gaseous analytes with near "absolute" specificity. A novel double-coil absorption cell design and an array of room-temperature sorbent-based preconcentration modules facilitate quantitative THz detection of light polar volatile compounds, which often challenge the capabilities of established gas sensing techniques.

Myopericarditis in a Young Adult Secondary to COVID-19 Vaccination.

We present the case of a healthy 29-year-old male with no significant medical history who presented with electrocardiogram findings consistent with pericarditis and elevated troponin levels, commonly seen in myocarditis, after receiving his second Pfizer-BioNTec vaccination for SARS-CoV-2 (severe acute respiratory syndrome coronavirus 2). The patient had significant clinical improvement shortly after receiving aspirin and colchicine and was discharged home with these medications. His laboratory findings returned to baseline less than 2 weeks after his illness.

Electrochemical biosensor for rapid detection of fungal contamination in fuel systems.

There is an increased demand for real-time monitoring of biological and biochemical processes. While most sensor research focuses on physiological conditions, less has been done towards developing real-time biosensors that can operate in and survive exposure to extreme environments and harsh chemicals such as fuel. One interesting application is monitoring microbial load in fuel tanks to prevent both fuel spoilage and biocorrosion.

Microfluidic Thermal Flowmeters for Drug Injection Monitoring.

This paper presents a microfluidic thermal flowmeter for monitoring injection pumps, which is essential to ensure proper patient treatment and reduce medication errors that can lead to severe injury or death. The standard gravimetric method for flow-rate monitoring requires a great deal of preparation and laboratory equipment and is impractical in clinics. Therefore, an alternative to the standard method suitable for remote, small-scale, and frequent infusion-pump monitoring is in great demand.

Laser-Fabricated 2D Molybdenum Disulfide Electronic Sensor Arrays for Rapid, Low-Cost, Ultrasensitive Detection of Influenza A and SARS-Cov-2.

Multiplex electronic antigen sensors for detection of SARS-Cov-2 spike glycoproteins and hemagglutinin from influenza A are fabricated using scalable processes for straightforward transition to economical mass-production. The sensors utilize the sensitivity and surface chemistry of a 2D MoS transducer for attachment of antibody fragments in a conformation favorable for antigen binding with no need for additional linker molecules. To make the devices, ultra-thin layers (3 nm) of amorphous MoS are sputtered over pre-patterned metal electrical contacts on a glass chip at room temperature.

Biomarkers and Detection Platforms for Human Health and Performance Monitoring: A Review.

Human health and performance monitoring (HHPM) is imperative to provide information necessary for protecting, sustaining, evaluating, and improving personnel in various occupational sectors, such as industry, academy, sports, recreation, and military. While various commercially wearable sensors are on the market with their capability of "quantitative assessments" on human health, physical, and psychological states, their sensing is mostly based on physical traits, and thus lacks precision in HHPM. Minimally or noninvasive biomarkers detectable from the human body, such as body fluid (e.

Impact of Self-Assembled Monolayer Design and Electrochemical Factors on Impedance-Based Biosensing.

Real-time sensing of proteins, especially in wearable devices, remains a substantial challenge due to the need to convert a binding event into a measurable signal that is compatible with the chosen analytical instrumentation. Impedance spectroscopy enables real-time detection via either measuring electrostatic interactions or electron transfer reactions while simultaneously being amenable to miniaturization for integration into wearable form-factors. To create a more robust methodology for optimizing impedance-based sensors, additional fundamental studies exploring components influencing the design and implementation of these sensors are needed.

Air2Liquid Method for Selective, Sensitive Detection of Gas-Phase Organophosphates.

Environmental hazards typically are encountered in the gaseous phase; however, selective sensing modalities for identifying and quantitating compounds of interest in an inexpensive, pseudo-real-time format are severely lacking. Here, we present a novel proof-of-concept that combines an Air2Liquid sampler in conjunction with an oil-in-water microfluidic assay for detection of organophosphates. We believe this proof-of-concept will enable development of a new platform technology for semivolatile detection that we have demonstrated to detect 50 pmoles (2 ppb) of neurotoxic organophosphates.

Portable Skin Analyzers with Simultaneous Measurements of Transepidermal Water Loss, Skin Conductance and Skin Hardness.

Simultaneous measurement of skin physiological and physical properties are important for the diagnosis of skin diseases and monitoring of human performance, since it provides more comprehensive understanding on the skin conditions. Current skin analysis devices, however, require each of probes and unique protocols for the measurement of individual skin properties, resulting in inconvenience and increase of measurement uncertainty. This paper presents a pen-type skin analyzing device capable tomeasure three key skin properties at the same time: transepidermal water loss (TEWL), skin conductance, and skin hardness.

Achievements and Challenges for Real-Time Sensing of Analytes in Sweat within Wearable Platforms.

Physiological sensors in a wearable form have rapidly emerged on the market due to technological breakthroughs and have become nearly ubiquitous with the Apple Watch, FitBit, and other wearable devices. While these wearables mostly monitor simple biometric signatures, new devices that can report on the human readiness level through sensing molecular biomarkers are critical to optimizing the human factor in both commercial sectors and the Department of Defense. The military is particularly interested in real-time, wearable, minimally invasive monitoring of fatigue and human performance to improve the readiness and performance of the war fighter.

Chemically Enhanced Polymer-Coated Carbon Nanotube Electronic Gas Sensor for Isopropyl Alcohol Detection.

Breathing-air quality within commercial airline cabins has come under increased scrutiny because of the identification of volatile organic compounds (VOCs) from the engine bleed air used to provide oxygen to cabins. Ideally, a sensor would be placed within the bleed air pipe itself, enabling detection before it permeated through and contaminated the entire cabin. Current gas-phase sensors suffer from issues with selectivity, do not have the appropriate form factor, or are too complex for commercial deployment.

Insight on Structure of Water and Ice Next to Graphene Using Surface-Sensitive Spectroscopy.

The water/graphene interface has received considerable attention in the past decade due to its relevance in various potential applications including energy storage, sensing, desalination, and catalysis. Most of our knowledge about the interfacial water structure next to graphene stems from simulations, which use experimentally measured water contact angles (WCAs) on graphene (or graphite) to estimate the water-graphene interaction strength. However, the existence of a wide spectrum of reported WCAs on supported graphene and graphitic surfaces makes it difficult to interpret the water-graphene interactions.

Peptide interactions with zigzag edges in graphene.

Recognition and manipulation of graphene edges enable the control of physical properties of graphene-based devices. Recently, the authors have identified a peptide that preferentially binds to graphene edges from a combinatorial peptide library. In this study, the authors examine the functional basis for the edge binding peptide using experimental and computational methods.

Geometrical assembly of ultrastable protein templates for nanomaterials.

The fabrication of nanoscale devices requires architectural templates on which to position functional molecules in complex arrangements. Protein scaffolds are particularly promising templates for nanomaterials due to inherent molecular recognition and self-assembly capabilities combined with genetically encoded functionalities. However, difficulties in engineering protein quaternary structure into stable and well-ordered shapes have hampered progress.

Recent Advances in Two-Dimensional Materials beyond Graphene.

The isolation of graphene in 2004 from graphite was a defining moment for the "birth" of a field: two-dimensional (2D) materials. In recent years, there has been a rapidly increasing number of papers focusing on non-graphene layered materials, including transition-metal dichalcogenides (TMDs), because of the new properties and applications that emerge upon 2D confinement. Here, we review significant recent advances and important new developments in 2D materials "beyond graphene".

Approach to multifunctional device platform with epitaxial graphene on transition metal oxide.

Heterostructures consisting of two-dimensional materials have shown new physical phenomena, novel electronic and optical properties, and new device concepts not observed in bulk material systems or purely three dimensional heterostructures. These new effects originated mostly from the van der Waals interaction between the different layers. Here we report that a new optical and electronic device platform can be provided by heterostructures of 2D graphene with a metal oxide (TiO2).

Nanomanufacturing of 2D Transition Metal Dichalcogenide Materials Using Self-Assembled DNA Nanotubes.

2D transition metal dichalcogenides (TMDCs) are nanomanufactured using a generalized strategy with self-assembled DNA nanotubes. DNA nanotubes of various lengths serve as lithographic etch masks for the dry etching of TMDCs. The nanostructured TMDCs are studied by atomic force microscopy, photoluminescence, and Raman spectroscopy.

Biotic-Abiotic Interactions: Factors that Influence Peptide-Graphene Interactions.

Understanding the factors that influence the interaction between biomolecules and abiotic surfaces is of utmost interest in biosensing and biomedical research. Through phage display technology, several peptides have been identified as specific binders to abiotic material surfaces, such as gold, graphene, silver, and so forth. Using graphene-peptide as our model abiotic-biotic pair, we investigate the effect of graphene quality, number of layers, and the underlying support substrate effect on graphene-peptide interactions using both experiments and computation.

Controlling the physicochemical state of carbon on graphene using focused electron-beam-induced deposition.

Focused electron-beam-induced deposition (FEBID) is a promising nanolithography technique using "direct-write" patterning by carbon line and dot deposits on graphene. Understanding interactions between deposited carbon molecules and graphene enables highly localized modification of graphene properties, which is foundational to the FEBID utility as a nanopatterning tool. In this study, we demonstrate a unique possibility to induce dramatically different adsorption states of FEBID-produced carbon deposits on graphene, through density functional theory calculations and complementary Raman experiments.

Electronic properties of a graphene device with peptide adsorption: insight from simulation.

In this work, to explain doping behavior of single-layer graphene upon HSSYWYAFNNKT (P1) and HSSAAAAFNNKT (P1-3A) adsorption in field-effect transistors (GFETs), we applied a combined computational approach, whereby peptide adsorption was modeled by molecular dynamics simulations, and the lowest energy configuration was confirmed by density functional theory calculations. On the basis of the resulting structures of the hybrid materials, electronic structure and transport calculations were investigated. We demonstrate that π-π stacking of the aromatic residues and proximate peptide backbone to the graphene surface in P1 have a role in the p-doping.

The effect of single wall carbon nanotube metallicity on genomic DNA-mediated chirality enrichment.

Achieving highly enriched single wall carbon nanotubes (SWNTs) is one of the major hurdles today because their chirality-dependent properties must be uniform and predictable for use in nanoscale electronics. Due to the unique wrapping and groove-binding mechanism, DNA has been demonstrated as a highly specific SWNT dispersion and fractionation agent, with its enrichment capabilities depending on the DNA sequence and length as well as the nanotube properties. Salmon genomic DNA (SaDNA) offers an inexpensive and scalable alternative to synthetic DNA.