A finite element model for investigating the influence of keel design and position on unicompartmental knee replacement cementless tibial component fixation.

Objectives: The cementless Oxford Unicompartmental Knee Replacement (OUKR) tibial component relies on an interference fit to achieve initial fixation. The behaviour at the implant-bone interface is not fully understood and hence modelling of implants using Finite Element (FE) software is challenging. With a goal of exploring alternative implant designs with lower fracture risk and adequate fixation, this study aims to investigate whether optimisation of FE model parameters could accurately reproduce experimental results of a pull-out test which assesses fixation.

Microporous titanium and hydroxyapatite improve fixation of the tibial wall in unicompartmental knee replacement.

Purpose: Cementless Oxford unicompartmental knee replacement (OUKR) is associated with less pain than cemented OUKR 5 years postoperatively. This may be due to improved fixation at the tibial wall, which transmits tension and reduces stress in the bone below the tibial component. This study compares tibial wall fixation with three different types of fixation: cemented, cementless with hydroxyapatite (HA) and cementless with a microporous titanium coat and HA (HA + MPC).

Polyethylene bearing wear is comparable for cemented and cementless Oxford unicompartmental knee replacements: Ten-year results of a randomized controlled trial.

Purpose: There is concern that using cementless components may increase polyethylene wear of the Oxford unicompartmental knee replacement (OUKR). Therefore, this study aimed to measure bearing wear at 10 years in patients from a randomized trial comparing Phase 3 cemented and cementless OUKRs and to investigate factors that may affect wear. It was hypothesized that there would be no difference in wear rate between cemented and cementless OUKRs.

Less pain reported 5 years after cementless compared to cemented unicompartmental knee replacement: an analysis of pain, neuropathy, and co-morbidity scores.

Purpose: To compare patient-reported pain scores and assess the influence of neuropathy and co-morbidity, on knee pain following cemented and cementless medial unicompartmental knee replacement (UKR) 5 years after surgery.

Method: In this longitudinal study, 262 cemented and 262 cementless Oxford UKR performed for the same indications and with the same techniques were recruited. Patients were reviewed at five years, evaluating patient-reported pain and association with clinical outcomes.

Mechanisms of mobile bearing dislocation in lateral unicompartmental knee replacement.

Mobile bearing dislocation occurs in 1- 6% of Oxford Domed Lateral replacements. Dislocations are predominantly medial, but can occur anteriorly or posteriorly. They tend to occur when the knee is flexed.

Fixed lateral unicompartmental knee replacement is a reliable treatment for lateral compartment osteoarthritis after mobile-bearing medial unicompartmental replacement.

Purpose: Lateral osteoarthritis following medial unicompartmental knee replacement (UKR) is usually treated with total knee replacement, however, lateral UKR is a less invasive option that preserves a well-functioning medial UKR. This study aimed to determine the 5-year outcome of the cemented Fixed Lateral Oxford UKR (FLO) when used for the treatment of severe lateral disease after medial Oxford unicompartmental knee replacement.

Methods: Forty-four knees with lateral bone-on-bone osteoarthritis (n = 43) and avascular necrosis (n = 1) treated with the FLO following medial Oxford UKR were followed up prospectively.

Incidence and severity of radiological lateral osteoarthritis 15 years following medial unicompartmental knee arthroplasty.

To assess the incidence of radiological lateral osteoarthritis (OA) at 15 years after medial unicompartmental knee arthroplasty (UKA) and assess the relationship of lateral OA with symptoms and patient characteristics. Cemented Phase 3 medial Oxford UKA implanted by two surgeons since 1998 for the recommended indications were prospectively followed. A 15-year cumulative revision rate for lateral OA of 5% for this series was previously reported.

Application of a robotics path planning algorithm to assess the risk of mobile bearing dislocation in lateral unicompartmental knee replacement.

Due to ligament laxity, bearing dislocation occurs in 1-6% of Oxford Domed Lateral (ODL) replacements with most dislocations occurring medially. Dislocations were studied using a previously built mechanical rig, however testing using the rig was inefficient. The aim of this study was to develop a better tool that was more reliable and efficient.

Comparison of five-year clinical outcomes of 524 cemented and cementless medial unicompartmental knee replacements.

Aim: To compare the outcomes of cemented and cementless Unicompartmental Knee Replacements (UKR) at 5 years after surgery.

Methods: 262 cemented and 262 cementless medial mobile-bearing UKR, implanted by four high-volume surgeons using identical indications and surgical techniques, were reviewed by independent physiotherapists at 5 years. Survival, Oxford Knee Score (OKS), American Knee Society Score (AKSS), and EQ-5D-5L were assessed.

The Oxford Domed Lateral Unicompartmental Knee Replacement implant: Increasing wall height reduces the risk of bearing dislocation.

Due to lateral ligament laxity, bearing dislocation occurs in 1%-6% of Oxford Domed Lateral replacements. Most dislocations are medial but they do rarely occur anteriorly or posteriorly. The aim was to decrease the risk of dislocation.

The effect of body mass index on the outcomes of cementless medial mobile-bearing unicompartmental knee replacements.

Purpose: Given an increasingly overweight population, unicompartmental knee replacements (UKRs) are being performed in patients with higher body mass indices (BMIs). There are concerns that cemented fixation will not last. Cementless fixation may offer a solution, but the long term results in different BMI groups has not been assessed.

The effect of age on the outcomes of cementless mobile bearing unicompartmental knee replacements.

Purpose: Unicompartmental Knee Replacements (UKR) are being performed in patients with increasing demands and life expectancies with surgical concerns that cemented fixation will not last. Cementless fixation may offer a solution, but the results in different age groups have not been assessed. The effect of age at surgery on the outcomes of cementless UKRs was investigated.

Systematic review and meta-analysis of bearing dislocation in lateral meniscal bearing unicompartmental knee replacement: Domed versus flat tibial surface.

Background: Bearing dislocation is a problem following mobile bearing Oxford lateral Unicompartmental Knee Replacement (UKR). Therefore, the design of the tibial component was changed from a flat tibial surface to a domed tibial surface with a biconcave bearing to increase bearing entrapment. This systematic review compared the dislocation and revision rates of the two designs.

The effect of obesity on revision rate in unicompartmental knee arthroplasty: a systematic review and meta-analysis.

The number of patients with knee osteoarthritis, the proportion that is obese and the number undergoing unicompartmental knee arthroplasty (UKA) are all increasing. The primary aim of this systematic review was to determine the effects of obesity on outcomes in UKA. A systematic review was performed using PRISMA guidelines and the primary outcome was revision rate per 100 observed component years, with a BMI of ≥ 30 used to define obesity.

Low polyethylene creep and wear following mobile-bearing unicompartmental knee replacement.

Purpose: The Oxford unicompartmental knee replacement (UKR) has a fully congruent mobile bearing to minimise wear. However, with younger higher demand patients, wear remains a concern. The aim of this study was to quantify the wear rate of Phase 3 Oxford UKR bearings over the course of 5 years and to identify the factors that influence it.

Oxford domed lateral unicompartmental knee arthroplasty.

Aims: To report mid- to long-term results of Oxford mobile bearing domed lateral unicompartmental knee arthroplasty (UKA), and determine the effect of potential contraindications on outcome.

Methods: A total of 325 consecutive domed lateral UKAs undertaken for the recommended indications were included, and their functional and survival outcomes were assessed. The effects of age, weight, activity, and the presence of full-thickness erosions of cartilage in the patellofemoral joint on outcome were evaluated.

Acceptable outcomes with unicompartmental knee replacement and PCL deficiency are achievable: a case series of nine patients.

Purpose: Posterior cruciate ligament (PCL) deficiency is considered to be a contraindication for unicompartmental knee replacement (UKR); however, there is no evidence to support or contradict this. There are occasional circumstances where UKR in PCL deficient patients have been performed where the patient otherwise satisfies the indications for UKR. The aim of this paper is to describe the outcome of UKR in PCL deficient patients.

Cementless unicompartmental knee replacement achieves better ten-year clinical outcomes than cemented: a systematic review.

Purpose: The aim of this study was to report and compare the long-term revision rate, revision indications and patient reported outcome measures of cemented and cementless unicompartmental knee replacements (UKR).

Methods: Databases Medline, Embase and Cochrane Central of Controlled Trials were searched to identify all UKR studies reporting the ≥ 10 year clinical outcomes. Revision rates per 100 component years [% per annum (% pa)] were calculated by fixation type and then, subgroup analyses for fixed and mobile bearing UKRs were performed.

Candidacy for medial unicompartmental knee replacement declines with age.

Background: The effect of age on the percentage of primary knee replacements appropriate for unicompartmental replacement (UKR), defined as candidacy, is unknown. The aim was to determine the candidacy and outcome of UKR in different age groups.

Hypothesis: Age is associated with candidacy for medial UKR.

Most unicompartmental knee replacement revisions could be avoided: a radiographic evaluation of revised Oxford knees in the National Joint Registry.

Purpose: The purpose of this study was to understand why the revision rate of unicompartmental knee replacement (UKR) in the National Joint Registry (NJR) is so high. Using radiographs, the appropriateness of patient selection for primary surgery, surgical technique, and indications for revision were determined. In addition, the alignment of the radiographs was assessed.

A radiographic analysis of alignment in 966 lower extremities with knee pain and its association with osteoarthritis in Indian population.

Purpose: This study aimed to investigate the alignment based on deformity in knees affected by osteoarthritis (OA) at different stages and evaluate its association with OA.

Material And Methods: The following radiological parameters were measured from weight bearing long leg radiographs of 966 legs in the Indian subjects via a morphometric software (Matlab R2009a) (1)Hip-Knee-Ankle angle (HKAA), (2) Femoral bowing, (3) Tibial Bowing, (4) Condylar Plateau angle (CPA). The knees were classified according to the Kellegren and Lawrence grading and these parameters were evaluated with OA for its association using appropriate statistical tests.

The clinical outcomes of cementless unicompartmental knee replacement in patients with reduced bone mineral density.

Background: Osteoporosis and osteopenia are conditions characterised by reduced bone mineral density (BMD). There is concern that bone with reduced BMD may not provide sufficient fixation for cementless components which primarily rely on the quality of surrounding bone. The aim of our study was to report the midterm clinical outcomes of patients with reduced BMD undergoing cementless unicompartmental knee replacements (UKR).

An open-source tool for the validation of finite element models using three-dimensional full-field measurements.

Three-dimensional (3D) full-field measurements provide a comprehensive and accurate validation of finite element (FE) models. For the validation, the result of the model and measurements are compared based on two respective point-sets and this requires the point-sets to be registered in one coordinate system. Point-set registration is a non-convex optimization problem that has widely been solved by the ordinary iterative closest point algorithm.

Long-term wear of different bearing types used for the Oxford Unicompartmental Knee Replacement.

Objectives: The aim of this study was to determine the polyethylene wear rate of Phase 3 Oxford Unicompartmental Knee Replacement bearings and to investigate the effects of resin type and manufacturing process.

Methods: A total of 63 patients with at least ten years' follow-up with three bearing types (1900 resin machined, 1050 resin machined, and 1050 resin moulded) were recruited. Patients underwent full weight-bearing model-based radiostereometric analysis to determine the bearing thickness.