High-average-power femtosecond laser at 258 nm.

We present an ultrafast fiber laser system delivering 4.6 W average power at 258 nm based on two-stage fourth-harmonic generation in beta barium borate (BBO). The beam quality is close to being diffraction limited with an M value of 1.

100 W average power femtosecond laser at 343 nm.

We present a femtosecond laser system delivering up to 100 W of average power at 343 nm. The laser system employs a Yb-based femtosecond fiber laser and subsequent second- and third-harmonic generation in beta barium borate (BBO) crystals. Thermal gradients within these BBO crystals are mitigated by sapphire heat spreaders directly bonded to the front and back surface of the crystals.

Scalability of components for kW-level average power few-cycle lasers.

In this paper, the average power scalability of components that can be used for intense few-cycle lasers based on nonlinear compression of modern femtosecond solid-state lasers is investigated. The key components of such a setup, namely, the gas-filled waveguides, laser windows, chirped mirrors for pulse compression and low dispersion mirrors for beam collimation, focusing, and beam steering are tested under high-average-power operation using a kilowatt cw laser. We demonstrate the long-term stable transmission of kW-level average power through a hollow capillary and a Kagome-type photonic crystal fiber.

High-average-power 2 μm few-cycle optical parametric chirped pulse amplifier at 100 kHz repetition rate.

Sources of long wavelengths few-cycle high repetition rate pulses are becoming increasingly important for a plethora of applications, e.g., in high-field physics.

22 GW peak-power fiber chirped-pulse-amplification system.

In this Letter, we report on a femtosecond fiber chirped-pulse-amplification system based on the coherent combination of the output of four ytterbium-doped large-pitch fibers. Each single channel delivers a peak power of about 6.2 GW after compression.

53 W average power few-cycle fiber laser system generating soft x rays up to the water window.

We report on a few-cycle laser system delivering sub-8-fs pulses with 353 μJ pulse energy and 25 GW of peak power at up to 150 kHz repetition rate. The corresponding average output power is as high as 53 W, which represents the highest average power obtained from any few-cycle laser architecture so far. The combination of both high average and high peak power provides unique opportunities for applications.

Enhancing the macroscopic yield of narrow-band high-order harmonic generation by Fano resonances.

Resonances in the photoabsorption spectrum of the generating medium can modify the spectrum of high-order harmonics. In particular, window-type Fano resonances can reduce photoabsorption within a narrow spectral region and, consequently, lead to an enhanced emission of high-order harmonics in absorption-limited generation conditions. For high harmonic generation in argon it is shown that the 3s3p(6)np(1)P(1) window resonances (n = 4, 5, 6) give rise to enhanced photon yield.

Coherent beam combination of Yb:YAG single-crystal rod amplifiers.

Coherent combination of ultrashort laser pulses emitted from spatially separated amplifiers is a promising power-scaling technique for ultrafast laser systems. It has been successfully applied to fiber amplifiers, since guidance of the signal provides the advantage of an excellent beam quality and straightforward superposition of beams as compared to bulk-type amplifier implementations. Herein we demonstrate, for the first time to our knowledge, a two-channel combining scheme employing Yb:YAG single-crystal rod amplifiers as an energy booster in a fiber chirped-pulse amplification system.

Generation of high-photon flux-coherent soft x-ray radiation with few-cycle pulses.

We present a tabletop source of coherent soft x-ray radiation with high-photon flux. Two-cycle pulses delivered by a fiber-laser-pumped optical parametric chirped-pulse amplifier operating at 180 kHz repetition rate are upconverted via high harmonic generation in neon to photon energies beyond 200 eV. A maximum photon flux of 1.

Thermal effects in high average power optical parametric amplifiers.

Optical parametric amplifiers (OPAs) have the reputation of being average power scalable due to the instantaneous nature of the parametric process (zero quantum defect). This Letter reveals serious challenges originating from thermal load in the nonlinear crystal caused by absorption. We investigate these thermal effects in high average power OPAs based on beta barium borate.

Control of nonlinear spectral phase induced by ultra-broadband optical parametric amplification.

Optical parametric amplifiers (OPAs) impose an optical parametric phase (OPP) onto the amplified signal. It manifests itself as a spectral phase in the case of broadband signals and, therefore, hampers pulse compression. Here we present, for the first time, a complete experimental characterization of this OPP for different ultra-broadband noncollinear OPA configurations.

Octave-spanning OPCPA system delivering CEP-stable few-cycle pulses and 22 W of average power at 1 MHz repetition rate.

We report on an OPCPA system delivering CEP-stable pulses with a pulse duration of only 1.7 optical cycles at 880 nm wavelength. This pulse duration is achieved by the generation, optical parametric amplification and compression of a full optical octave of bandwidth.

1 MHz repetition rate hollow fiber pulse compression to sub-100-fs duration at 100 W average power.

We report on nonlinear pulse compression at very high average power. A high-power fiber chirped pulse amplification system based on a novel large pitch photonic crystal fiber delivers 700 fs pulses with 200 μJ pulse energy at a 1 MHz repetition rate, resulting in 200 W of average power. Subsequent spectral broadening in a xenon-filled hollow-core fiber and pulse compression with chirped mirrors is employed for pulse shortening and peak power enhancement.

Coherently-combined two channel femtosecond fiber CPA system producing 3 mJ pulse energy.

We present a fiber CPA system consisting of two coherently combined fiber amplifiers, which have been arranged in an actively stabilized Mach-Zehnder interferometer. Pulse durations as short as 470 fs and pulse energies of 3 mJ, corresponding to 5.4 GW of peak power, have been achieved at an average power of 30 W.

Generation of high quality, 1.3 cycle pulses by active phase control of an octave spanning supercontinuum.

Nonlinear pulse compression based on the generation of ultra-broadband supercontinuum (SC) in an all-normal dispersion photonic crystal fiber (ANDi PCF) is demonstrated. The highly coherent and smooth octave-spanning SC spectra are generated using 6 fs, 3 nJ pulses from a Ti:Sapphire oscillator for pumping a 13 mm piece of ANDi PCF. Applying active phase control has enabled the generation of 4.

High-repetition-rate sub-5-fs pulses with 12 GW peak power from fiber-amplifier-pumped optical parametric chirped-pulse amplification.

An optical parametric chirped-pulse amplification system delivering pulses with more than 12 GW peak power is presented. Compression to sub-5 fs, 87 μJ and 5.4 fs, 100 μJ is realized at the 30 kHz repetition rate.