Controlling the Surface Functionalization of Ultrasmall Gold Nanoparticles by Sequence-Defined Macromolecules.

Ultrasmall gold nanoparticles (diameter about 2 nm) were surface-functionalized with cysteine-carrying precision macromolecules. These consisted of sequence-defined oligo(amidoamine)s (OAAs) with either two or six cysteine molecules for binding to the gold surface and either with or without a PEG chain (3400 Da). They were characterized by H NMR spectroscopy, H NMR diffusion-ordered spectroscopy (DOSY), small-angle X-ray scattering (SAXS), and high-resolution transmission electron microscopy.

Correction: Sophia, B.; et al. Presenting Precision Glycomacromolecules on Gold Nanoparticles for Increased Lectin Binding. 2017, , 716.

In the original version of this Article, an error occurred in the "Results and Discussion" section, under the subheading "Preparation and Characterization of Glyco-AuNPs"[...

Sequence-Defined Introduction of Hydrophobic Motifs and Effects in Lectin Binding of Precision Glycomacromolecules.

This study investigates the influence of an increasingly hydrophobic backbone of multivalent glycomimetics based on sequence-defined oligo(amidoamines) on their resulting affinity toward bacterial lectins. Glycomacromolecules are obtained by stepwise assembly of tailor-made building blocks on solid support, using both hydrophobic aliphatic and aromatic building blocks to enable a gradual change in hydrophobicity of the backbone. Their binding behavior toward model lectin Concanavalin A (ConA) is evaluated using isothermal titration calorimetry (ITC) and surface plasmon resonance (SPR) showing higher affinities for glycomacromolecules with higher content of hydrophobic and aromatic moieties in the backbone.

Multivalent Binding of Precision Glycooligomers on Soft Glycocalyx Mimicking Hydrogels.

We present a synthetic approach toward soft, glycooligomer-functionalized microgel particles mimicking carbohydrate presenting cell surfaces and analyze their specific binding to a model lectin (Concanavalin A, ConA). Focusing on multivalent presentation, a series of sequence-controlled glycooligomers with varying spacing and number of mannose units was synthesized and analyzed for the resulting glycooligomer-ConA affinity. Both direct binding and inhibition studies show a higher affinity with increasing the number of sugar moieties, but they level off for higher valent systems, indicating steric hindrance.

Presenting Precision Glycomacromolecules on Gold Nanoparticles for Increased Lectin Binding.

Glyco-functionalized gold nanoparticles have great potential as biosensors and as inhibitors due to their increased binding to carbohydrate-recognizing receptors such as the lectins. Here we apply previously developed solid phase polymer synthesis to obtain a series of precision glycomacromolecules that allows for straightforward variation of their chemical structure as well as functionalization of gold nanoparticles by ligand exchange. A novel building block is introduced allowing for the change of spacer building blocks within the macromolecular scaffold going from an ethylene glycol unit to an aliphatic spacer.

Linear Precision Glycomacromolecules with Varying Interligand Spacing and Linker Functionalities Binding to Concanavalin A and the Bacterial Lectin FimH.

A series of precision glycomacromolecules is prepared following previously established solid phase synthesis allowing for controlled variations of interligand spacing and the overall number of carbohydrate ligands. In addition, now also different linkers are installed between the carbohydrate ligand and the macromolecular scaffold. The lectin binding behavior of these glycomacromolecules is then evaluated in isothermal titration calorimetry (ITC) and kinITC experiments using the lectin Concanavalin A (Con A) in its dimeric and tetrameric form.

Sequence-Controlled Glycopolymers via Step-Growth Polymerization of Precision Glycomacromolecules for Lectin Receptor Clustering.

A versatile approach for the synthesis of sequence-controlled multiblock copolymers, using a combination of solid phase synthesis and step-growth polymerization by photoinduced thiol-ene coupling (TEC) is presented. Following this strategy, a series of sequence-controlled glycopolymers is derived from the polymerization of a hydrophilic spacer macromonomer and different glycomacromonomers bearing between one to five α-d-Mannose (Man) ligands. Through the solid phase assembly of the macromonomers, the number and positioning of spacer and sugar moieties is controlled and translates into the sequence-control of the final polymer.

Development and optimization of a competitive binding assay for the galactophilic low affinity lectin LecA from Pseudomonas aeruginosa.

Infections with the Gram-negative bacterium Pseudomonas aeruginosa result in a high mortality among immunocompromised patients and those with cystic fibrosis. The pathogen can switch from planktonic life to biofilms, and thereby shields itself against antibiotic treatment and host immune defense to establish chronic infections. The bacterial protein LecA, a C-type lectin, is a virulence factor and an integral component for biofilm formation.