Hybrid nickel manganese oxide nanosheet-3D metallic dendrite percolation network electrodes for high-rate electrochemical energy storage.

This work reports the fabrication, by electrodeposition and post-thermal annealing, of hybrid electrodes for high rate electrochemical energy storage composed of nickel manganese oxide (Ni0.86Mn0.14O) nanosheets over 3D open porous dendritic NiCu foams.

Bond strength of an etch-and-rinse adhesive to KrF excimer laser-treated dentin.

Objective: The aim of this work was to evaluate the effect of KrF excimer laser treatment on the bond strength between dentin and an etch-and-rinse adhesive system.

Materials And Methods: Polished dentin surfaces were subjected to the following treatments: (1) 35% phosphoric acid etching for 15 s; (2) laser surface treatment using KrF excimer laser radiation (1 J/cm(2)); and (3) laser treatment under the same conditions followed by acid etching. After treating the dentin, an etch-and-rinse adhesive (Adper Scotchbond 1 XT, 3M ESPE) was applied and composite (Esthet-X, Dentsply Caulk, Konstanz, Germany) build-ups were incrementally constructed.

Characterisation of dentin surfaces processed with KrF excimer laser radiation.

In the present work, the surface microtexture and chemical changes induced in human dentin by laser processing with KrF excimer laser radiation using fluences ranging from 0.5 to 20 J/cm2 were studied by SEM, XPS and FTIR. Two distinct behaviours were observed in the evolution of surface topography.

Laser surface modification of hydroxyapatite and glass-reinforced hydroxyapatite.

Surface treatment of materials with excimer laser radiation often results in the formation of a rough columnar or cone-shaped surface topography, which leads to a considerable increase in the surface area. As a result, the search for a non-porous bioactive material with adequate mechanical properties and a high surface to volume ratio, similar to porous materials, which could be used for drug delivery in the treatment of periodontitis, justified assessing excimer laser surface treatment to promote controlled roughning of hydroxyapatite (HA) and glass-reinforced hydroxyapatite (GR-HA). A KrF excimer laser with 248 nm radiation wavelength and 30 ns pulse duration was used for surface modification.