Novel fabrication method for zirconia restorations: bonding strength of machinable ceramic to zirconia with resin cements.

A novel method was developed to fabricate all-ceramic restorations which comprised CAD/CAM-fabricated machinable ceramic bonded to CAD/CAM-fabricated zirconia framework using resin cement. The feasibility of this fabrication method was assessed in this study by investigating the bonding strength of a machinable ceramic to zirconia. A machinable ceramic was bonded to a zirconia plate using three kinds of resin cements: ResiCem (RE), Panavia (PA), and Multilink (ML).

Combination treatment of tribochemical treatment and phosphoric acid ester monomer of zirconia ceramics enhances the bonding durability of resin-based luting cements.

The aim of the present study was to evaluate the bonding durability of resin-based luting cement to partially stabilized tetragonal zirconia (Y-TZP) achieved by combination treatment of tribochemical (TBC) treatment and two different phosphate acid ester monomers. Two phosphate acid ester monomers (EP: Epricord opaque primer, AZ: AZ primer) were applied to each surface modification followed by application of resin-based luting cement (Rely-X ARC). Bonding specimens were placed in deionized water at 37 degrees C and stored for 24 h.

A review of dental CAD/CAM: current status and future perspectives from 20 years of experience.

In this article, we review the recent history of the development of dental CAD/CAM systems for the fabrication of crowns and fixed partial dentures (FPDs), based on our 20 years of experience in this field. The current status of commercial dental CAD/CAM systems developed around the world is evaluated, with particular focus on the field of ceramic crowns and FPDs. Finally, we discuss the future perspectives applicable to dental CAD/CAM.