30 TW and 33 fs pulses delivered by a Ti:Sa amplifier system seeded with a frequency-doubled fiber laser.

We report a full experimental comparison study on the injection of a Ti:Sa multi-terawatt amplifier chain with a standard 15 fs Ti:Sa oscillator and 35 fs frequency-doubled fiber oscillator. The study highlights that the Ti:Sa oscillator, with high performance in terms of pulse duration and spectral width, can be replaced by the frequency-doubled fiber oscillator to seed Ti:Sa amplifier chains almost without any compromise on the output pulse duration and picosecond contrast. Finally, we demonstrate for the first time to our knowledge a 30 TW and 33 fs Ti:Sa amplifier injected by a fiber oscillator.

Table-top high-energy 7 μm OPCPA and 260 mJ Ho:YLF pump laser.

We present a state-of-the-art compact high-energy mid-infrared (mid-IR) laser system for TW-level eight-cycle pulses at 7 μm. This system consists of an Er:Tm:Ho:fiber MOPA which serves as the seeder for a ZGP-based optical parametric chirped pulse amplification (OPCPA) chain, in addition to a Ho:YLF amplifier which is Tm:fiber pumped. Featuring all-optical synchronization, the system delivers 260 mJ pump energy at 2052 nm and 16 ps duration at 100 Hz with a stability of 0.

Coherent beam combining of seven fiber chirped-pulse amplifiers using an interferometric phase measurement.

Coherent beam combining in tiled-aperture configuration is demonstrated on seven femtosecond fiber amplifiers using an interferometric phase measurement technique. The residual phase error between two fibers is as low as λ/55 RMS and a combination efficiency of 48% has been achieved. The combined pulses are compressed to 216 fs, delivering 71 W average power at a repetition rate of 55 MHz.

Highly scalable femtosecond coherent beam combining demonstrated with 19 fibers.

Coherent beam combining in the femtosecond regime of a record number of 19 fibers is demonstrated. The interferometric phase measurement technique, particularly well suited to phase-lock a very large number of fibers, is successfully demonstrated in the femtosecond regime. A servo loop is implemented to control piezoelectric fiber stretchers for both phase and delay variation compensation.

Suppression of parasitic lasing in high energy, high repetition rate Ti:sapphire laser amplifiers.

Transverse parasitic lasing is well known for limiting the signal gain and the pulse energy that can be extracted from Ti:sapphire petawatt amplifiers. We have developed a technique for suppressing these parasitic lasing modes based on perfect refractive index-matching liquid doped with a broad-bandwidth absorber to suppress the transverse lasing while ensuring proper heat removal from the Ti:sapphire crystal. The 800 nm laser output with a bandwidth of 41 nm (FWHM) and peak energy of 22.

Picosecond pulses of variable duration from a high-power passively mode-locked Nd:YVO(4) laser free of spatial hole burning.

We report on a high-power passively mode-locked TEM(00)Nd:YVO(4) oscillator, 888 nm diode-pumped, with pulse durations adjustable between 46 ps and 12 ps. The duration tunability was obtained by varying the output coupler (OC) transmission while avoiding resorting to spatial hole burning (SHB) for pulse shortening. At a repetition rate of 91 MHz and for an output power ranging from 15 Wto45 W, we produced SHB-free 12-ps-to32-ps-long pulses.