A Combined Persistence and Physical Approach for Ultra-Short-Term Photovoltaic Power Forecasting Using Distributed Sensors.

This paper presents a novel method for forecasting the impact of cloud cover on photovoltaic (PV) fields in the nowcasting term, utilizing PV panels as sensors in a combination of physical and persistence models and integrating energy storage system control. The proposed approach entails simulating a power network consisting of a 22 kV renewable energy source and energy storage, enabling the evaluation of network behavior in comparison to the national grid. To optimize computational efficiency, the authors develop an equivalent model of the PV + energy storage module, accurately simulating system behavior while accounting for weather conditions, particularly cloud cover.

Thermal Cues Composed of Sequences of Pulses for Transferring Data via a Haptic Thermal Interface.

This research study is the preliminary phase of an effort to develop a generic data transfer method via human haptic thermal sensation (i.e., a coded language such as Morse or Braille).

Static, Dynamic, and Signal-To-Noise Analysis of a Solid-State Magnetoelectric (Me) Sensor with a Spice-Based Circuit Simulator.

Modeling the non-electrical processes by equivalent electrical circuits is a widely known and successfully used technique in research and development. Although finite element methods software development has supplanted electrical analogy techniques due to greater accuracy and intuitiveness in recent decades, the modeling of physical processes based on analogies has several advantages in some cases. Representation of physical processes in the form of lumped circuits and graphs allows researchers to estimate the system with an alternative view, use standardized methods for solving electrical circuits for non-electrical systems, and, most importantly, allows us to use electrical circuit simulators with their unique capabilities.

Analysis, Modeling, and Simulation of Thin-Film Cells-Based Photovoltaic Generator Combined with Multilayer Thermoelectric Generator.

A new model for a multi-stage thermoelectric generator (TEG) is developed. An electrical and thermal model is built and simulated for different configurations of photovoltaic (PV) stand-alone hybrid systems, combining different stages of a TEG. The approach is evaluated with and without cooling by coupling a cold plate to a multi-stage hybrid PVTEG system.

The Effects of Cogging Torque Reduction in Axial Flux Machines.

An axial flux permanent magnet single-rotor generator has good potential in various applications that require high efficiency, prolonged service life, as well as low mass and dimensions. However, the effect of cogging torque diminishes generator efficiency and flexibility of functionality. The effect of cogging torque arises because of a small air gap between the stator teeth and the rotor.

Spatial Equivalent Circuit Model for Simulation of On-Chip Thermoelectric Harvesters.

Interest in autonomous low-power energy sources has risen with the development and widespread use of devices with very low energy consumption. Interest in thermoelectric harvesters has increased against this background. Thermoelectric harvesters, especially harvesters on-chip, have peculiar properties related to the thermal route, thermal transients, and spatial temperature distribution within the chip.

Hybrid Internal Combustion Engine based Auxiliary Power Unit.

The brief presents some principles of the ON/OFF operational strategy applied to energy management of a hybrid internal combustion engine (ICE) based auxiliary power unit (APU). It is shown that significant reduction of fuel consumption (78% for the example system presented) and maintenance expenses (80% operation time decrease was attained by the system) may be achieved by such a strategy, shifting the system operation point towards corresponding optimal region. The side effect of aggravated amount of starting events is cured by employing an actively balanced supercapacitor (SC)-based emergency starter (SCS).