Synthesis and Characterization of N and Fe-Doped TiO Nanoparticles for 2,4-Dimethylaniline Mineralization.

The present study aimed to evaluate the feasibility of developing low-cost N- and Fe-doped TiO photocatalysts for investigating the mineralization of 2,4-dimethylaniline (2,4-DMA). With a single anatase phase, the photocatalysts showed high thermal stability with mass losses of less than 2%. The predominant oxidative state is Ti, but there is presence of Ti associated with oxygen vacancies.

Photoelectrocatalytic Degradation of Methylene Blue Using ZnO Nanorods Fabricated on Silicon Substrates.

ZnO nanorods were grown on silicon (Si) substrates by two techniques: (i) Chemical Bath Deposition (CBD) and (ii) a CBD seed layer combined with Carbothermal Reduction Vapor Phase Transport (CTR-VPT). The structured ZnO nanorods were characterized by scanning electron microscopy (SEM), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and contact angle measurments. The photoelectrochemical property of ZnO nanorods were analyzed by linear voltammetry under UV-ABC light excitation.

HO-assisted photoelectrocatalytic degradation of Mitoxantrone using CuO nanostructured films: Identification of by-products and toxicity.

CuO nanostructured thin films supported on silicon with 6.5 cm area (geometric area greater than the studies reported in the literature) were synthesized by a chemical bath deposition technique. The electrodes were characterized by MEV, XRD, XPS, contact angle, cyclic voltammetry and electrochemical impedance spectroscopy analyses.

Optimization of nimesulide oxidation via a UV-ABC/HO treatment process: Degradation products, ecotoxicological effects, and their dependence on the water matrix.

Nimesulide (Nim) degradation in ultrapure water (UW) and municipal sewage (MS) via UV-ABC/HO was investigated. The variables included in the experimental design were time, initial Nim, and initial HO concentrations. Resulting decreases in Nim concentration (monitored by high performance liquid chromatography (HPLC) using a photodiode array detector operating at a maximum UV absorbance of 300 nm), mineralization (from total organic carbon (TOC) measurements), and ecotoxicity (assays employing the bioindicators Daphnia similis, Artemia salina, and Allium cepa) were also studied.

Degradation of 4-aminoantipyrine by electro-oxidation with a boron-doped diamond anode: Optimization by central composite design, oxidation products and toxicity.

Electro-oxidation with electrogenerated HO (EO-HO) was applied to treat acidic aqueous solutions of 4-aminoantipyrine (4-AA), a persistent drug metabolite of dipyrone, in sulfate medium. Trials were made using a boron-doped diamond anode in the presence of HO electrogenerated on site. A 2 central composite design (CCD) was employed to evaluate the effect of four independent variables, namely current density (j), pH, 4-AA concentration and electrolysis time, on the percentages of degradation and mineralization, as well as on mineralization current efficiency (MCE).

Antituberculosis drug isoniazid degraded by electro-Fenton and photoelectro-Fenton processes using a boron-doped diamond anode and a carbon-PTFE air-diffusion cathode.

Solutions with 0.65 mM of the antituberculosis drug isoniazid (INH) in 0.050 M NaSO at pH 3.

Influence of chelation on the Fenton-based electrochemical degradation of herbicide tebuthiuron.

This study describes the performance of electro-Fenton (EF) and photoelectro-Fenton (PEF) processes to degrade the herbicide tebuthiuron (TBH) in 0.050 M NaSO at pH = 3.0.

Identification of intermediates, acute toxicity removal, and kinetics investigation to the Ametryn treatment by direct photolysis (UV), UV/HO, Fenton, and photo-Fenton processes.

This paper reports the degradation of 10 mg L Ametryn solution with different advanced oxidation processes and by ultraviolet (UV) irradiation alone with the main objective of reducing acute toxicity and increase biodegradability. The investigated factors included Fe and HO concentrations. The effectiveness of the UV and UV/HO processes were investigated using a low-pressure mercury UV lamp (254 nm).

Tolfenamic acid degradation by direct photolysis and the UV-ABC/HO process: factorial design, kinetics, identification of intermediates, and toxicity evaluation.

This study employed direct UV-ABC photolysis and the UV-ABC/HO process to investigate the degradation of tolfenamic acid (TA), a common anti-inflammatory drug used in both human and veterinary medicine. A 2 factorial design with added center point was used to evaluate the effect of three independent variables-namely, HO concentration ([HO]), TA concentration ([TA]), and experiment time (time)-on TA degradation and HO photolysis during UV-ABC/HO treatment using a high-pressure mercury vapor lamp (photon flux of 2.6307 × 10 J s) as the UV irradiation source.

Degradation of the insecticide propoxur by electrochemical advanced oxidation processes using a boron-doped diamond/air-diffusion cell.

A solution with 0.38 mM of the pesticide propoxur (PX) at pH 3.0 has been comparatively treated by electrochemical oxidation with electrogenerated HO (EO-HO), electro-Fenton (EF), and photoelectro-Fenton (PEF).

Application of Fenton, photo-Fenton, solar photo-Fenton, and UV/H2O2 to degradation of the antineoplastic agent mitoxantrone and toxicological evaluation.

In the present study, selected advanced oxidation processes (AOPs)-namely, photo-Fenton (with Fe(2+), Fe(3+), and potassium ferrioxalate-FeOx-as iron sources), solar photo-Fenton, Fenton, and UV/H2O2-were investigated for degradation of the antineoplastic drug mitoxantrone (MTX), frequently used to treat metastatic breast cancer, skin cancer, and acute leukemia. The results showed that photo-Fenton processes employing Fe(III) and FeOx and the UV/H2O2 process were most efficient for mineralizing MTX, with 77, 82, and 90% of total organic carbon removal, respectively. MTX probably forms a complex with Fe(III), as demonstrated by voltammetric and spectrophotometric measurements.