New insights on the effects of blend composition on the biodegradation and permeability of Inulin-Eudragit RS film coatings for colon drug delivery.

Inulin has been applied in Inulin-Eudragit RS (Inu-ERS) coatings as the component responsible for degradation by human microbiota. However, studies on how bacterial enzymes can degrade polysaccharides like inulin imbedded in water insoluble polymers like Eudragit RS are still elusive. The present work aims at elucidating the complex process of enzyme triggered biodegradation of inulin with various molecular weights in isolated films with Eudragit RS.

Gaining Insight into the Role of the Solvent during Spray Drying of Amorphous Solid Dispersions by Studying Evaporation Kinetics.

Spray drying is one of the most commonly used manufacturing techniques for amorphous solid dispersions (ASDs). During spray drying, very fast solvent evaporation is enabled by the generation of small droplets and exposure of these droplets to a heated drying gas. This fast solvent evaporation leads to an increased viscosity that enables kinetic trapping of an active pharmaceutical ingredient (API) in a polymer matrix, which is favorable for the formulation of supersaturated, kinetically stabilized ASDs.

The underestimated contribution of the solvent to the phase behavior of highly drug loaded amorphous solid dispersions.

In spite of the fact that spray drying is widely applied for the formulation of amorphous solid dispersions (ASDs), the influence of the solvent on the physical properties of the ASDs is still not completely understood. Therefore, the impact of organic solvents on the kinetic stabilization of drug components in a polymer matrix prepared by either film casting or spray drying was investigated. One polymer, PVPVA 64, together with one of four poorly water soluble drugs, naproxen, indomethacin, fenofibrate or diazepam, were film casted and spray dried using either methanol, ethanol, isopropanol, acetonitrile, acetone, dichloromethane or ethyl acetate.

Unraveling Particle Formation: From Single Droplet Drying to Spray Drying and Electrospraying.

Spray drying and electrospraying are well-established drying processes that already have proven their value in the pharmaceutical field. However, there is currently still a lack of knowledge on the fundamentals of the particle formation process, thereby hampering fast and cost-effective particle engineering. To get a better understanding of how functional particles are formed with respect to process and formulation parameters, it is indispensable to offer a comprehensive overview of critical aspects of the droplet drying and particle formation process.

Solid-state analysis of amorphous solid dispersions: Why DSC and XRPD may not be regarded as stand-alone techniques.

Amorphous solid dispersions (ASDs) are single-phase amorphous systems, where drug molecules are molecularly dispersed (dissolved) in a polymer matrix. The molecular dispersion of the drug molecules is responsible for their improved dissolution properties. Unambiguously establishing the phase behavior of the ASDs is of utmost importance.

Chemically identical but physically different: A comparison of spray drying, hot melt extrusion and cryo-milling for the formulation of high drug loaded amorphous solid dispersions of naproxen.

In spite of the large research efforts in the past two decades, it is still difficult, if possible at all, to predict what manufacturing technology will lead to the best amorphous solid dispersions (ASDs) in terms of drug to polymer ratio ("drug loading") and physical stability. In general, ASDs can be prepared by solvent based methods, heat based methods and mechanochemical activation. In the current study, one manufacturing technique per category was selected: spray drying, hot melt extrusion and cryo-milling, respectively.