One-Stone-for-Two-Birds Method to Improve the SnO Layers for High Power-per-Weight Flexible Perovskite Solar Cell Mini-modules.

Maintaining the power conversion efficiency (PCE) of flexible perovskite solar cells (fPSCs) while decreasing their weight is essential to utilize their lightweight and flexibility as much as possible for commercialization. Strengthening the interfaces between functional layers, such as flexible substrates, charge transport layers, and perovskite active layers, is critical to addressing the issue. Herein, we propose a feasible and one-stone-for-two-birds method to improve the electron transport layer (ETL), SnO, and the interface between the ETL and perovskite layer simultaneously.

How to Stabilize the Current of Efficient Inverted Flexible Perovskite Solar Cells at the Maximum Power Point.

Inverted flexible perovskite cells (fPSCs) have attracted much attention for their high efficiency and power per weight. Still, the steady-state output is one of the critical factors for their commercialization. In this paper, it is found that the steady-state current of inverted fPSCs based on nickel oxide nanoparticles (n-NiO) continuously decreases under light illumination.

Phase-Engineering of Layered Nickel Hydroxide for Synthesizing High-Quality NiO Nanocrystals for Efficient Inverted Flexible Perovskite Solar Cells.

Nickel oxide (NiO) nanocrystals have been widely used in inverted (p-i-n) flexible perovskite solar cells (fPSCs) due to their remarkable advantages of low cost and outstanding stability. However, anion and cation impurities such as NO widely exist in the NiO nanocrystals obtained from calcinated nickel hydroxide (Ni(OH)). The impurities impair the photovoltaic performance of fPSCs.

A "time-frozen" technique in microchannel used for the thermodynamic studies of DNA origami.

The emergence of DNA origami greatly accelerated the development of DNA nanotechnology. A thorough understanding of origami thermodynamics is very important for both fundamental studies and practical applications. These thermodynamic transitions usually take place in several seconds or even less, and are very difficult to monitor by conventional methods.

Millifluidic chip with a modular design used as a sample pretreatment cartridge for flour and flour food products.

The integration of sample pretreatment remains one of the hurdles towards a rapid, automated micro total analytical system (µ-TAS) for real samples. In this paper, a modular design, which was used for sample preparation, has been developed as the polydimethylsiloxane (PDMS) millifluidic chips with channels at a millimeter level. Multiple functional units, including extraction, filtration, mixing and solid phase extraction (SPE), for sample pretreatment were integrated in one chip.