Study on the proportion of paste filling materials based on fluorogypsum.

A new type of paste filling material was created using fluorogypsum, a byproduct of hydrofluoric acid, as the raw material to address the issue of the filling material's high cost. The effects of five factors, including gangue, fly ash, fluorogypsum, lime content, and mass concentration on the physical and mechanical properties of filling material were also examined. In addition to analyzing slump and extension changes, the filler's mineral composition and microstructure were examined using SEM and XRD examinations.

Mechanical properties and acoustic emission characteristics of deep hard coal after segmented high-temperature treatment.

Based on engineering background that local heating of coal seam is uneven due to underground coal gasification, coal-bed gas exploitation via heat injection, spontaneous combustion of coal seam, etc., segmented heating coal sample was used to simulate coal seam under uneven heating condition, and experimental study on mechanical behaviors of coal sample after segmented heat treatment at high temperatures was conducted. Test results show that temperature at 100 °C ~ 400 °C did not reach ignition temperature of deep hard coal for the experiment and was not enough to change main ingredients of coal sample, which less affected compression strength, elastic modulus, acoustic emission behavior of coal sample.

Static and dynamic failure mechanisms of circular granite under the condition of water-heat cycles.

Based on the engineering environment where rocks surrounding wellbores in energy storage areas are influenced by high temperature, cool and hot water, thermal stress etc. in the exploitation of hydrothermally geothermal energy, the experimental study on mechanical properties of ring granite under the static and dynamic loads in the water-heat condition was performed. The experimental results showed that when the ring granite was influenced by the inner diameters, heating temperatures, curing temperatures and heat recovery cycle times, the impact load-strain curves were nonlinear.

Study on the dynamic characteristics of rock surrounding a wellbore in energy storage areas during deep geothermal energy mining.

Based on the engineering background in which the rock surrounding a wellbore is affected by a thermal shock, impact disturbances from drilling vibration, cyclic heat extraction and high temperature during hydrothermal geothermal energy mining, the environmental conditions in the shaft wall rock are simulated by means of high temperature, cooling, immersing granite in water with different curing temperatures and applying impact loads. Additionally, an experimental study on the mechanical characteristics of circular granite specimens under radial impact loads and in the heat treatment and water curing conditions is carried out. The results show that the inner diameters of the rings, heating temperatures, curing water temperatures and cycle heating times are less affected than other parameters by the impact load-strain curves of circular granite, which can generally be divided into three sections, i.